Physical Chemical Evaluation
Mostrando 1-12 de 334 artigos, teses e dissertações.
-
1. Evaluation of the use of blast furnace slag as an additive in mortars
Abstract Clinker is the raw material used in the manufacture of cement. However, this material is very harmful to the environment, since it is estimated that for every ton of clinker produced, about 1.0 ton of CO2 is released into the atmosphere. For this reason, alternatives were sought for the use of other materials that are less harmful to the environment
REM - International Engineering Journal. Publicado em: 2022
-
2. Coverage plants in the management of skeletal coffee
ABSTRACT Currently, one of the most used practices in national coffee production is skeletal pruning, to preserve productive capacity, correct plant architecture, minimize the occurrence of diseases, among others. Also, it reduces the plants diameter, exposing the soil to climatic conditions, erosion, loss of moisture and nutrients, negatively affecting the
Revista Ceres. Publicado em: 2022
-
3. Assessment of sensory and physical-chemical quality, and potential for certification of cachaças from the state of Paraíba, Brazil
Abstract The State of Paraíba is an important producer of artisanal cachaça that has outstanding quality in national tasting panels and for this reason this research studied organizational aspects for certification and compliance with Good Manufacturing Practices - GMP - of 53% of formal producers. Samples of cachaças from these producers were evaluated f
Food Sci. Technol. Publicado em: 2021-09
-
4. Quality evaluation of metallurgical coke produced with sawdust and different mixtures of coal
Abstract The present research is dedicated to analyzing the addition of sawdust biomass, which is a carbonaceous raw material that may be used in coal blends for the production of metallurgical coke, preserving the required quality, with lower cost. The quality of metallurgical coke may be determined by the efficiency of its chemical, physical and thermal fu
REM, Int. Eng. J.. Publicado em: 2021-06
-
5. Physico-chemical and Nutraceutical Characterization of Selected Indigenous Guava (Psidium guajava L.) Cultivars
Abstract In order to ascertain physicochemical and nutraceutical attributes, indigenous guava (Psidium guajava L.) cultivars were comprehensively characterized. Eight cultivars namely Gola, Chota Gola, Surahi, Choti Surahi, Sufaida, Sdabahar, Lal Badshah and Karela were selected due to their climatic adaptability and commercial suitability. All the cultivars
Food Sci. Technol. Publicado em: 2021-03
-
6. Comprehensive assessment and evaluation of selected wheat varieties for their relationship to chapatti quality attributes
Abstract Wheat is consumed as staple food by majority of population in Pakistan. This study was aimed to assess the effects of recently introduced five cultivars of wheat (Ojala 2016, Borlaug 2016, Johar 2016, Gold 2016 and Fatehjang 2016) for chapatti quality. Results for different physical, chemical, rheological and sensory parameters revealed significant
Food Sci. Technol. Publicado em: 2020-12
-
7. Investigation of some properties of gluten-free tarhanas produced by red, green and yellow lentil whole flour
Abstract Gluten-free lentil tarhanas were obtained by replacing red, green and yellow lentil whole flour instead of wheat flour used in traditional tarhana formulation. Some physical, chemical, bioactive, microbiological, reological, morphological and sensory properties of these tarhanas were investigated comparatively. Amount of crude protein (%), crude ash
Food Sci. Technol. Publicado em: 2020-12
-
8. Physicochemical and bioactive compounds evaluation of Physalis pubescens Linnaeus
ABSTRACT Physalis pubescens L. is a UFP (unconventional food plant) that produces high quality fruits; however, in Rio Grande do Sul it is still considered a rare species. There is only few information regarding the characterization of these fruits in Brazil, and the main reports of this species are mainly focused on the pharmacology and agronomic conditions
Rev. Ceres. Publicado em: 2020-12
-
9. Development of diet cereal bar sweetened with stevia leaves pre-treated with ethanol
Abstract The objective of this work was to perform the ethanolic pretreatment of stevia leaves from the plant Stevia UEM-13 line and to characterize its physical-chemical properties aiming its use as a sweetener in the development of a diet cereal bar. The same formulation of the cereal bar with stevia leaves without pretreatment was elaborated for comparati
Food Sci. Technol. Publicado em: 2020-12
-
10. Development of isotonic beverage with functional attributes based on extract of Myrciaria jabuticaba (Vell) Berg
Abstract Isotonic repositories are specially designed to promote rehydration during or after physical exercise. These beverages are processed for commercialization from synthetic flavorings and dyes with sensorial characteristics similar to those of fruits, in order to attenuate their natural acidity. The aim of the present study was to develop two formulati
Food Sci. Technol. Publicado em: 2020-09
-
11. AVALIAÇÃO DE NANOTUBOS DE CARBONO FUNCIONALIZADOS VISANDO O DESENVOLVIMENTO DE MÉTODOS DE PRÉ-CONCENTRAÇÃO DE ÍONS METÁLICOS E DETERMINAÇÃO POR TÉCNICAS ESPECTROMÉTRICAS E ELETROANALÍTICAS
This review focuses on the use of functionalized carbon nanotubes (CNTs) on the development of preconcentration methods with substantial contributions on selectivity and sensitivity for metal ions determination. CNTs have been usually employed in the development of preconcentration/speciation coupled to spectroanalytical techniques for ions determination at
Quím. Nova. Publicado em: 2020-09
-
12. Polyurethane/poly (Ionic Liquids) Cellulosic Composites and their Evaluation for Separation of CO2 from Natural Gas
The development of both versatile and inexpensive sorbents for CO2/CH4 separation has become one of the greatest challenges to the environment and natural gas processing. This study reports the preparation and characterization of polyurethane (PU)/ cellulose based poly(ionic liquid)(CPIL) composites for CO2/CH4 separation. PU matrix was reinforced with CPIL
Mat. Res.. Publicado em: 20/01/2020