Grain Size
Mostrando 25-36 de 466 artigos, teses e dissertações.
-
25. Statistical analysis of mechanical properties of mortars with fly ash and waste tire rubber
Resumo Este artigo tem como objetivo efetuar a análise estatística dos efeitos da inclusão da borracha de pneus inservíveis e cinza volante oriunda de usinas termelétricas como componentes da argamassa para revestimento de edificações. Foram produzidas argamassas de referência e argamassas contendo borracha com dimensão máxima dos grãos de 0,71 mm
Rev. IBRACON Estrut. Mater.. Publicado em: 23/09/2019
-
26. Rolling and recrystallization behavior of pure zirconium and zircaloy-4
ABSTRACT Rolling and recrystallization of pure zirconium and zircaloy-4 have been studied comparatively in this paper. For the as-received condition, zirconium presented a recrystallized microstructure and the alloy a typical basketweave microstructure. Comparative rolling tests were performed, and reduction limit curves as a function of the rolling temperat
Matéria (Rio J.). Publicado em: 16/09/2019
-
27. Caracterização microestrutural das ligas AA7004 e AA7075 tixoforjadas em prensa excêntrica
RESUMO Este trabalho tem como objetivo analisar o processo de tixoforjamento em prensa excêntrica das ligas aeronáuticas AA7004 e AA7075 e compreender o comportamento do material semissólido durante o preenchimento da matriz através de análises microestruturais. As ligas foram submetidas a tratamentos térmicos de globularização pelo tempo de 210 s e
Matéria (Rio J.). Publicado em: 16/09/2019
-
28. Avaliação da susceptibilidade à corrosão de um aço inoxidável AISI 316L submetido à simulação térmica com o uso da Gleeble
RESUMO Este trabalho teve como finalidade avaliar a influência do tamanho médio dos grãos na susceptibilidade à corrosão do aço inoxidável austenítico AISI 316L, cujo material é bastante utilizado em juntas soldadas, em temperatura ambiente e em baixíssimas temperaturas (condições criogênicas) por apresentar excelente resistência à corrosão e
Matéria (Rio J.). Publicado em: 16/09/2019
-
29. In vitro Bioactivity, Bio-Corrosion Resistance and Antibacterial Property of Laser Cladded HA Coatings with Different Content of ZnO on Ti-6Al-4V Substrate
HA/ZnO coatings with varying content of ZnO were fabricated on Ti-6Al-4V substrate to enhance its bioactivity and antibacterial ability. The main phases are identified as CaTiO3, Ca3(PO4)2, ZnTiO3 and CaO. The coatings with higher ZnO content presented smaller grain size, resulting in a higher surface free energy and better wettability. Consequently, the min
Mat. Res.. Publicado em: 05/09/2019
-
30. Roasting soybeans in a microwave for manufacturing chocolate dragées
RESUMO: Este estudo objetivou avaliar o efeito do tempo de torra no micro-ondas para diferentes tamanhos de grãos de soja tipo alimento de tegumento preto, de forma a atingir a melhor crocância, sabor e dureza, e em seguida caracterizar o seu confeito, estruturado na forma de núcleo e camadas de cobertura de chocolate (drageados), em relação ao valor n
Cienc. Rural. Publicado em: 05/09/2019
-
31. Behaviors of Embrittlement and Softening in Heat Affected Zone of High Strength X90 Pipeline Steels
Abstract The embrittlement and softening behaviors in heat affected zone of X90 pipeline steel were studied, and the influence of weld thermal cycle on microstructure and mechanical properties were discussed by combining the effect of peak temperature on the phase transition point (Ar3). Results show that there are embrittlement and softening zones existed i
Soldag. insp.. Publicado em: 15/08/2019
-
32. X-ray Microtomography to Quantify Morphological Sandstones Properties
Abstract The sandstones of the Furnas Formation in the State of Paraná, south of Brazil, are located in regions with great importance due to the natural heritage found in the rocky forms and associated flora and fauna. This paper presents a detailed analysis of the internal structure of diverse sandstones of the Furnas Formation. X-ray microtomography allow
Braz. arch. biol. technol.. Publicado em: 12/08/2019
-
33. Do natural disturbances have significant effects on sandy beach macrofauna of Southeastern Brazil?
ABSTRACT The role of morphodynamic features such as grain size, swash climate and wave action on the macrofauna of beaches are well-known. However, few studies have investigated natural disturbances as potential drivers of temporal community variations. In southeastern Brazil, we sampled the intertidal macrofauna of two sandy beaches to test whether seasonal
Zoologia (Curitiba). Publicado em: 08/08/2019
-
34. Pervious concrete made with electric furnace slag (FEA): mechanical and hydraulic properties
Resumo O objetivo deste trabalho é viabilizar o uso de escória de forno elétrico (FEA) em substituição ao agregado graúdo convencional na fabricação de concreto permeável (CoPe), atingindo os parâmetros mínimos exigidos pela norma NBR16416/2015. Esta substituição minimizaria a utilização de agregados naturais, além de aproveitar um resíduo q
Rev. IBRACON Estrut. Mater.. Publicado em: 18/07/2019
-
35. Microstructure evolution during the extrusion of a 6351 aluminum alloy tube
Abstract The aluminum alloy AA 6351 is a precipitation hardened alloy of the Al-Mg-Si system, additionally containing Mn and Fe. In this study, the microstructural characterization during processing of a thick wall extruded AA 6351 tube was carried out. Several complementary techniques for microstructural characterization were used, such as polarized light o
REM, Int. Eng. J.. Publicado em: 19/06/2019
-
36. Shear Strength of a typical soil from Manaus, Brazil, stabilized with ceramic residue additive
ABSTRACT The purpose of this study is to determine the geotechnical behavior of a clayey surface soil typical to the Manaus region (Amazonas, Brazil), when mixed with ceramic powder from brick residue produced by potteries located in the county of Iranduba, Amazonas, Brazil, and with residual sand (the reference mixture), commonly used in pavements in the re
Matéria (Rio J.). Publicado em: 10/06/2019