Pervious concrete made with electric furnace slag (FEA): mechanical and hydraulic properties

AUTOR(ES)
FONTE

Rev. IBRACON Estrut. Mater.

DATA DE PUBLICAÇÃO

18/07/2019

RESUMO

Resumo O objetivo deste trabalho é viabilizar o uso de escória de forno elétrico (FEA) em substituição ao agregado graúdo convencional na fabricação de concreto permeável (CoPe), atingindo os parâmetros mínimos exigidos pela norma NBR16416/2015. Esta substituição minimizaria a utilização de agregados naturais, além de aproveitar um resíduo que não tem destinação específica. Para alcançar o objetivo foram escolhidos três FEA’s com diferentes distribuições granulométricas: 6-10 mm (A), 10-20 mm (B) e finalmente uma mistura das duas anteriores (C) na proporção 30-70 respectivamente. Para avaliar seu comportamento mecânico foram realizados ensaios de resistência à compressão e tração na flexão, enquanto na avaliação do comportamento hidráulico, índice de vazios e permeabilidade à carga constante foram realizados. Na compressão foram obtidas resistências variando de 19-31MPa e 3-4MPa na tração na flexão. Em termos hidráulicos, o índice de vazios variou de 15%-20% e o coeficiente de permeabilidade de 10-12mm/s. Também se verifica a influência direta dos grãos de tamanho inferior a 4.8 mm (agregado miúdo) na resistência à compressão e na permeabilidade dos CoPes. Ao final, a partir dos resultados obtidos foi possível estabelecer uma correlação entre a resistência à compressão, a permeabilidade e a porcentagem de grãos inferiores a 4.8mm (%areia), sendo esta positiva em relação às variáveis estudadas, ou seja, as propriedades mecânicas e hidráulica. Por tanto foi concluído que é viável a substituição total dos agregados convencionais por FEA na fabricação de CoPe cumprindo com os parâmetros mínimos da NBR 16416/2015.Abstract The objective of this work is to make feasible the use of FEA slag instead of the conventional bulk aggregate in the pervious concrete (PC) production, reaching the minimum parameters required by NBR16416/2015 and ACI 522R-10. This substitution would minimize the use of natural aggregates, besides taking advantage of a residue that has no specific destination. In order to reach the objective, three FEAs with different grain sizes were chosen: 6-10 mm (A), 10-20 mm (B) and finally a mixture of the two previous ones (C) in the proportion 30-70 respectively. In order to evaluate its mechanical behavior, tests of compressive strength and flexural tensile tests were carried out, while the evaluation of the hydraulic behavior, porosity and constant head permeability test were performed. The compressive strength varies from 19-31MPa and 3-4MPa for flexural tensile strength was obtained. In hydraulic terms, the porosity varied from 15-20% and the permeability coefficient was 10-12mm/s. There is also a direct influence of grains of size less than 4.8 mm (small aggregate) on the compressive strength and permeability of PCs. At the end of the results, it was possible to establish a correlation between the compressive strength, the permeability and the percentage of grains inferior to 4.8mm (sand%), being this positive in relation to the studied variables, that is, the mechanical and hydraulics. Therefore, it has been concluded that the total substitution of conventional aggregates by FEA in CoPe manufacturing will comply with the minimum parameters of NBR 16416/2015.

Documentos Relacionados