Caracterização microestrutural das ligas AA7004 e AA7075 tixoforjadas em prensa excêntrica

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

16/09/2019

RESUMO

RESUMO Este trabalho tem como objetivo analisar o processo de tixoforjamento em prensa excêntrica das ligas aeronáuticas AA7004 e AA7075 e compreender o comportamento do material semissólido durante o preenchimento da matriz através de análises microestruturais. As ligas foram submetidas a tratamentos térmicos de globularização pelo tempo de 210 s e fração líquida de 55% e na sequência tixoforjadas. As temperaturas de trabalho foram determinadas via ensaios de DSC (differential scanning calorimetry). O tratamento térmico de globularização tem como objetivo efetuar a globularização parcial ou total das ligas, permitindo analisar a evolução microestrutural. A força máxima aplicada no ensaio de tixoforjamento foi de aproximadamente 500 kg, sendo que a capacidade da prensa excêntrica segundo seu fabricante é de 25 toneladas, demonstrando que a carga utilizada para a realização dos ensaios foi irrisória em comparação com a capacidade do equipamento. O produto final apresentou total preenchimento da matriz e qualidade dimensional. A região localizada no centro da peça, onde ocorreu a maior deformação apresentou grãos deformados e menores em relação às outras regiões, a saber, a liga AA7004 apresentou tamanho de grãos de 142 µm e a liga AA7075 apresentou tamanho de grãos de 105 µm.ABSTRACT The aim of this work was to analyze the thixoforging process in an eccentric press of the AA7004 and AA7075 aeronautical alloys and to understand the behavior of the semisolid material during the filling of the die through microstructural analysis. The alloys were subjected to globularization heat treatments for 210 seconds and liquid fraction of 55% and in the sequence thixoforged. Working temperatures were determined via DSC tests (differential scanning calorimetry). The globularization heat treatments aim to effect the partial or total globularization of the alloys, allowing the analysis of microstructural evolution. The maximum force applied in the thixoforging process was approximately 500 kg, and the capacity of the eccentric press according to its manufacturer is 25 tons, demonstrating that the force used to perform the tests was negligible compared of the capacity of the equipment. The thixoforged final product presented total filling of the die and dimensional quality. The part in the center of the final product, where the biggest deformation occurred, presented deformed and smaller grains in relation to the other parts, namely the AA7004 alloy presented a grain size of 142 µm and the AA7075 alloy presented a grain size of 105 µm.

Documentos Relacionados