Removal Torque
Mostrando 1-12 de 18 artigos, teses e dissertações.
-
1. Microneurorrhaphy of the mentonian nerve during the removal of a giant odontoma
RESUMO O objetivo deste artigo é descrever uma técnica cirúrgica de opção no tratamento de grandes tumores na mandíbula cujo risco de ruptura acidental do nervo mental apresenta aumento pelo relato de uma paciente com extenso odontoma complexo em corpo mandibular. A opção foi pelo o acesso intraoral, corte intencional do nervo mentoniano, seguida da
RGO, Rev. Gaúch. Odontol.. Publicado em: 06/05/2019
-
2. Mechanical influence of thread pitch on orthodontic mini-implant stability
The aim of this study was to evaluate the effect of pitch distance on the primary stability (PS) of orthodontic mini-implants (MIs) in artificial bone. Twenty experimental MIs were allocated to two groups, according to their geometric design: G1(30oX 0.6 mm) and G2(45o X 0.8 mm), and inserted into artificial bone of different densities: D1 (0.32 g/cm3) and D
Braz. oral res.. Publicado em: 16/02/2015
-
3. Estudo da influência da força de corte em usinagem a verde nas propriedades mecânicas de cerâmicas sinterizadas / Influence of the cutting force of green machining on the mechanical properties of sintered ceramics
The present study deals with the measurement forces of green machining ceramics and their correlation with the mechanical properties after sintering. The green machining is employed in crude compacts either to check raw formats without compromising the extreme dimensional accuracy or to obtain a preform prior to finish machining after sintering, extensively
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 13/01/2012
-
4. A rationale method for evaluating unscrewing torque values of prosthetic screws in dental implants
OBJECTIVES: Previous studies that evaluated the torque needed for removing dental implant screws have not considered the manner of transfer of the occlusal loads in clinical settings. Instead, the torque used for removal was applied directly to the screw, and most of them omitted the possibility that the hexagon could limit the action of the occlusal load in
Journal of Applied Oral Science. Publicado em: 2011-02
-
5. Removal torque of zirconia abutment screws under dry and wet conditions
A fim de verificar se a lubrificação do parafuso do pilar pode gerar valores maiores de pré-carga do que nos parafusos não lubrificados, um pilar de titânio foi parafusado no análogo do implante e escaneado pelo Sistema Procera para gerar 20 pilares de zircônia. Depois, os implantes MKIII Brånemark foram presos num dispositivo de torque. Os pilares f
Brazilian Dental Journal. Publicado em: 2010
-
6. Avaliação in vitro da variação do torque de remoção de parafusos para fixação de pilares protéticos submetidos a ciclos de parafusamento e desparafusamento / Torque removal evaluation of prosthetic screws after cycles of tightening and loosening: an in vitro study
O afrouxamento dos parafusos protéticos é descrito na literatura como uma das complicações mais frequentes das próteses sobre implantes. Durante sua confecção, os profissionais sentem necessidade de remover várias vezes as próteses e/ou componentes protéticos, soltando e re-apertando os parafusos repetidamente. O principal objetivo deste trabalho f
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 01/12/2009
-
7. Evaluation of titanium implants with surface modification by laser beam: biomechanical study in rabbit tibias
The purpose of the present study was to evaluate, using a biomechanical test, the force needed to remove implants with surface modification by laser (Nd:YAG) in comparison with implants with machined surfaces. Twenty-four rabbits received one implant with each surface treatment in the tibia, machined surface (MS) and laser-modified surface (LMS). After 4, 8
Brazilian Oral Research. Publicado em: 2009-06
-
8. Measurement of the morse taper abutment removal torque in dental implants using a carbon deposition above the attrition surface / Mensuração do torque de desaperto do componente protético em conexão do tipo cone-morse em implantes dentários utilizando deposição de carbono sobre a superfície de atrito
Os implantes cone morse apresentam um travamento e vedamento por meio de atrito entre as paredes do implante e do pilar protético. Nos sistemas convencionais do tipo Hexágono externo e interno, para reduzir o afrouxamento dos parafusos protéticos, são utilizados materiais de cobertura de superfície, como carbono e ouro. Não foram encontradas referênci
Publicado em: 2009
-
9. Preload and torque removal evaluation of three different abutment screws for single standing implant restorations
Several authors still consider the mechanical problems of fracture and component loosening as the main causes of failure of implant-supported restorations. The purpose of this in vitro study was to compare the preload of three types of screw for transmucosal abutment attachment used in single implant-supported prosthesis through strain gauge and removal torq
Journal of Applied Oral Science. Publicado em: 2008-02
-
10. Desenvolvimento de uma bancada de teste para torque de parafusos para implantes
Componentes de próteses e órteses humanas devem ser confortáveis, capazes de realizar as funções esperadas e, mais do que tudo, confiáveis. O foco deste trabalho é no desenvolvimento e aplicação de uma metodologia de análise de parafusos cirúrgicos. Para tanto foi desenvolvido um aparato mecânico, que consiste em um atuador de torque e um sistema
Publicado em: 2008
-
11. Estudo biomecânico da conexão implante/pilar protético em implantes do sistema cone morse / Biomechanical study of the implant/abutment connection in implants with internal tapered connectios
Internal tapered connections were developed to improve biomechanical properties and to reduce mechanical problems found in external and internal hex implants. This work presents the results of two studies that investigated the biomechanical properties of the implant/abutment connection in implants with internal tapered connections. The purpose of the first s
Publicado em: 2007
-
12. AvaliaÃÃo da biocompatibilidade do cimento portland, em polpas humanas, apÃs capeamento pulpar direto: estudo morfolÃgico e imunoistoquÃmico. / Evaluation of the biocompatibility of the Portland cement, in human pulp, after direct dental pulp capping: a morphological and imunohistological study
The present study evaluated dental implants with no primary stability and with uncovered threads, inserted in rabbit’s tibias, in the presence of BMP through the value of removal torque and radiographic’s analysis. It was used 6 adult male New Zealand White rabbits, divided in test (4 animals) and control group (2 animals). Two implants (Neodent�
Publicado em: 2006