Pulse Generation
Mostrando 1-12 de 124 artigos, teses e dissertações.
-
1. Passively Q-Switched Pulses Generation from Erbium-Doped Fiber Laser Using Lutetium Oxide as Saturable Absorber
Abstract In this paper, a configuration of a passive Q-switched Erbium-doped fiber laser (EDFL) using a Lutetium Oxide (Lu2O3) thin film as a saturable absorber (SA) is experimentally implemented to generate high pulse energy with a high signal to noise ratio. A stable Q-switched pulse train is initiated at the input pump power of 30.442mW, and a maximum pul
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2021-03
-
2. Medicinal Electrochemistry of Halogenated and Nitrated Pterocarpanquinones
Electrochemical methods are considered useful tools for simulations of biological redox reactions. The activities of quinones depend on their bioreduction. Biologically active pterocarpanquinones LQB-149 (nitroderivative), 150 and 151 (bromo and chloroderivatives, respectively) were electrochemically investigated by cyclic voltammetry, differential pulse vol
J. Braz. Chem. Soc.. Publicado em: 24/10/2019
-
3. Determination of Chlorophenol in Environmental Samples Using a Voltammetric Biosensor Based on Hybrid Nanocomposite
In this work, a simple electrochemical biosensor for 4-chlorophenol was developed based on laccase immobilized on a hybrid nanocomposite (ZnO nanoparticles/chitosan), and incorporated in a carbon paste electrode. There are few biosensors in the literature for this specific pollutant because it tends to form polymeric films on the electrode, causing surface p
J. Braz. Chem. Soc.. Publicado em: 2017-07
-
4. Artificial motor control for electrically stimulated upper limbs of plegic or paretic people
Introduction: Functional Electrical Stimulation (FES) is a technique used in the restoration and generation of movements performed by subjects with neuromuscular disorders such as spinal cord injury (SCI). The purpose of this article is to outline the state of the art and perspectives of the use of FES in artificial motor control of the upper limbs in pareti
Res. Biomed. Eng.. Publicado em: 14/06/2016
-
5. Calculation of Aircraft Target's Single-Pulse Detection Probability
ABSTRACT: The original radar cross section data or some rough models are often used to estimate a given aircraft target detection probability. The calculation results may not be very accurate as targets are different from one another and the real radar detection process is complex. A new method for radar cross section model generation is proposed and it take
J. Aerosp. Technol. Manag.. Publicado em: 2015-09
-
6. DETERMINAÇÃO RÁPIDA E SIMULTÂNEA DE SULFAMETOXAZOL E TRIMETOPRIMA UTILIZANDO ANÁLISE POR INJEÇÃO EM BATELADA COM DETECÇÃO AMPEROMÉTRICA E ELETRODO DE DIAMANTE DOPADO COM BORO
A fast, simple procedure for simultaneous determination of sulfamethoxazole (SMX) and trimethoprim (TMP) was performed using batch injection analysis with multiple pulse amperometric detection (BIA-MPA). The sample aliquot (150 µL) was directly injected onto the boron-doped diamond (BDD) electrode (wall-jet configuration) immersed in a BIA system. The an
Quím. Nova. Publicado em: 2015-06
-
7. A CMOS UWB transmitter with Vivaldi Array for Ultra-fast Beam steering microwave radar
This work presents a new Ultra Wide Band (UWB) beamforming fifth-order derivative Gaussian pulse transmitter with dual small Vivaldi antennas for remote acquisition of vital signals in impulse radar applications. The system consists of a programmable delay circuit (PDC or τ), a UWB pulse generator (PG) circuit and an array of two Vivaldi planar antennas. Th
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
8. Sistemas CDMA ópticos coerentes baseados em codificação de fase espectral / Coherent optical CDMA systems based on spectral phase coding
In this work we perform a comprehensive analysis of a spectral phase-encoded time spreading optical code division multiple access (SPECTS-OCDMA) system. Despite being a numerical study, efforts were concentrated on the investigation of more realistic scenarios using as much information as possible from implemented test-beds in laboratories. In this context,
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 11/12/2012
-
9. Simulação da propagação de ondas ultrassônicas longitudinais em materiais estruturais aeroespaciais / Simulating the propagation of longitudinal ultrasonic waves in aerospace structural materials
The use of composite materials in the aerospace industry is increasing due to its low ratio between density and mechanical strength. To perform non-destructive testing using ultrasound, it is necessary to know the sound velocity in these materials. It is not always possible to manufacture physical prototypes during the development of a project because of tim
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 10/08/2012
-
10. Geração de segundo harmônico sintonizável por modulação de fase de pulsos de laser ultracurtos / Tunable second harmonic generation by phase-modulated ultrashort laser pulses
Neste trabalho é feito um estudo da formatação de pulsos ultracurtos de laser de Ti:Safira para a geração de segundo harmônico em cristal de KDP. Para a formatação dos pulsos, é utilizado um aparato que inclui um modulador espacial de luz de cristal líquido (LC SLM), que altera unicamente a fase espectral dos pulsos. Este aparelho tem a vantagem de
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/02/2012
-
11. Técnica de varredura-Z com pulsos de femtossegundo e geração de terceiro harmônico / Z-scan tecnique with femtosecond pulse and third-harmonic generation
Neste trabalho fizemos um estudo da geração de terceiro harmônico (GTH) usando pulsos de femtossegundos (fs). A GTH é uma importante técnica que permite estudar propriedades ópticas não lineares de terceira ordem de materiais. Estudamos a GTH aplicando as técnicas de franjas de Maker e a de varredura-Z em diferentes materiais levando em conta as cont
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 09/02/2012
-
12. Inversão sísmica para impedância acústica na caracterização de reservatórios : impacto da extração da wavelet e do aumento da banda de frequências / Seismic inversion to acoustic impedance in reservoir caracterization : the impact of wavelet extraction and increase the frequency band
The substrates that constitute a reservoir are identified using seismic data. The process consists of determining reservoir petrophysical properties. However, sub-seismic layers structures are masked due to the limitation of conventional seismic data. The failure provided by these data produces an erroneous model of reservoir. The lack of vertical resolution
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 25/11/2011