Power Amplifier
Mostrando 1-12 de 42 artigos, teses e dissertações.
-
1. High Efficiency Continuous Inverse Class-F Power Amplifier with Modified Current Waveform
Abstract Continuous inverse class-F (CICF) is a recent mode of harmonically-tuned RF power amplifiers used to extend the operating bandwidth of the conventional narrowband class-F−1 power amplifier by producing variable set of drain current waveforms and load admittances that give the same operating efficiency. In this work, a new approach of analysis is d
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2020-09
-
2. A simple strategy to design broadband low power consumption distributed Raman amplifier
Abstract In this work, a simple strategy to design wideband low power consumption Raman amplifiers is demonstrated for a three-pump configuration using a low water peak optical fiber. The approach is based on the introduction of a novel numerical measure, which quantifies and isolates pump-pump interaction contribution to gain profile and analyzes its correl
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-09
-
3. New methodology for modeling, design and implementation of RF power amplifiers
Abstract This work presents a new methodology for modeling, design and implementation of power amplifiers in different technologies. As result of comparison, a flowchart with a new methodology is proposed which can be useful for the designer to design and implement power amplifiers with low, medium and high power devices in different technologies. This paper
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-09
-
4. Power amplifier circuits for functional electrical stimulation systems
Abstract Introduction: Functional electrical stimulation (FES) is a technique that has been successfully employed in rehabilitation treatment to mitigate problems after spinal cord injury (SCI). One of the most relevant modules in a typical FES system is the power or output amplifier stage, which is responsible for the application of voltage or current puls
Res. Biomed. Eng.. Publicado em: 2017-06
-
5. Analysis and PIC simulation of a Gyrotron travelling wave tube amplifier
The analysis of a Ka-band gyrotron Travelling Wave Tube (gyro-TWT) amplifier using a uniform cylindrical waveguide as its interaction circuit has been presented for the TE01 mode of operation a self-consistent nonlinear analysis in the large signal regime. The analysis predicts that the saturated peak output power of ~ 134 kW with a power conversion efficien
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
6. PIC simulation study of a 35 GHz, 200 kW Gyroklystron
A three-dimensional PIC simulation of a 35 GHz, 200 kW two cavity gyroklystron amplifier has been performed to study the electron beam and RF wave interaction behavior using a commercial PIC code 'MAGIC'. The electromagnetic field analysis of the RF structure in the absence of the electron beam and beam-wave interaction study in the presence of the electron
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
7. Comparing OSNR based policies for an adaptive-alternative IA-RWA algorithm applied to all-optical networks
We propose two policies to select the route for an adaptive-alternative routing algorithm for all-optical networks. We use the NrPSR to find the Nr routes with lower cost for a given source-destination pair according to a cost function expanded in a power series (PSR) in which the coefficients are determined by a Particle Swarm Optimizer (PSO). The selected
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
8. A passive-matched 22 GHz 2.6-dB-NF CMOS front-end with a 70-800 ps delay block
This paper presents a power-efficient RF differential receiver front-end supporting transmitted-reference (TR) communication in a 90 nm CMOS technology. Particularly, it addresses the issues of designing the frontend amplifier with low-noise and passive matching circuits on a silicon process and integrating a low-power delay unit in the front-end with wideba
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-06
-
9. Design of distributed optical-fiber raman amplifiers using multi-objective particle swarm optimization
A novel method is presented to design the configuration of pumping lasers of Raman amplifiers using a multi-objective particle swarm optimizer. The goal is to obtain the pump laser wavelengths and powers that maximize the amplifier on-off gain, while maintaining the flatness of the gain over the used bandwidth. We used an algorithm called Multiple Objective
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2011-12
-
10. Design of self-checking fully differential circuits and boards
A design methodology for on-line testing analog linear fully differential (FD) circuits is presented in this work. The test strategy is based on concurrently monitoring via an analog checker the common mode (CM) at the inputs of all amplifiers. The totally self-checking (TSC) goal is achieved for linear FD implementations provided that the checker CM thresho
Publicado em: 2011
-
11. Gain profile optimization for Raman+EDFA hybrid amplifiers with recycled pumps for WDM systems
An approximated technique to quickly optimize the gain profile of multi-pump broadband hybrid amplifiers under residual pump recycling in WDM systems is proposed. It is based on the amplifier spectral equalization by adjusting the flexible gain profile of a multi-pump Raman amplification stage to compensate the Erbium-doped stage gain variation within the C-
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2010-12
-
12. Projeto de um conversor analógico-digital para um receptor Bluetooth em tecnologia CMOS. / Analog to digital converter design for a Bluetooth receiver in CMOS technology.
In this work, an Analog to Digital Converter (ADC) fulfilling the Bluetooth standard specifications is designed. This block stays at the reception side of an integrated wireless transceiver in CMOS technology. Initially, an analysis of the ADC as a system is carried out, at the same time that the specifications at that level are developed. The architecture a
Publicado em: 2010