Electrical Energy
Mostrando 25-36 de 596 artigos, teses e dissertações.
-
25. Equipamento Automatizado de Soldagem Capacitiva para Termopares
Resumo Os termopares são dispositivos elétricos de simples concepção utilizados na medição de temperatura, e possuem um grande uso na indústria. O termopar necessita de uma junção eficiente para os dois fios metálicos que o compõem, que comumente é feita pela soldagem. O processo de soldagem utilizado para construir um termopar pode ser feito de
Soldag. insp.. Publicado em: 15/08/2019
-
26. DECREASE IN OFF-PEAK ELECTRICAL ENERGY DEMAND BY AGROINDUSTRIES DUE TO PHOTOVOLTAIC SOLAR GENERATION
ABSTRACT The largest energy losses and voltage variations from electricity suppliers occur at times of peak demand. Daytime peaks are mainly influenced by large industrial and commercial consumers. The installation of photovoltaic systems without energy storage to supply part of the demand can contribute to stabilize the voltage and reduce losses. These and
Eng. Agríc.. Publicado em: 12/08/2019
-
27. HYBRID SOLAR HEAT PUMP SYSTEM FOR WATER HEATING
ABSTRACT A comparative test of water heating between the hybrid system - solar collector with heat pump - and a system with conventional supplementary heating - with high electric power - was performed. For this, a small capacity heat pump was installed, which was later installed together with a solar heating system, composed of a 250 L thermal reservoir and
Eng. Agríc.. Publicado em: 12/08/2019
-
28. Influência do Regime Transiente Sobre a Microdureza e Microestrutura nos Aços ASTM-A36 e SAE-1045 Soldados pelo Processo MAG
Resumo O regime quase-estacionário pode não ser alcançado em soldagens a arco elétrico de peças de pequenas dimensões e/ou de materiais de maior condutividade térmica. Entretanto, o regime transiente sempre ocorrerá no início e no final da soldagem. Neste regime, a variação do fluxo de energia via calor pode promover variações microestruturais e
Soldag. insp.. Publicado em: 08/08/2019
-
29. Influence of Yttria-Stabilized Zirconia on Microstructure and Electrical Properties of Doped Lanthanum Gallate
Lanthanum gallate with partial substitutions for strontium and magnesium shows higher ionic conductivity than traditional ionic conductors such as yttria-stabilized zirconia (8YSZ), and has been considered for application as solid electrolyte and electrode in Solid Oxide Fuel Cells operating at intermediate temperatures (500-700ºC). Parallel to the developm
Mat. Res.. Publicado em: 01/08/2019
-
30. Thermal, dielectric and catalytic behavior of palladium doped PVC films
Abstract The present paper discusses the aspects of synthesizing palladium (Pd) doped (Pd+2 and Pd0) poly(vinyl chloride) (PVC) using simple solution cast technique. The Pd loading to PVC was altered from 2.5% to 10.0% and the material properties were studied using UV-Visible spectroscopy (UV-Vis), X-ray diffraction (XRD), Energy-dispersive X-ray spectroscop
Polímeros. Publicado em: 04/07/2019
-
31. Microstructure evolution during the extrusion of a 6351 aluminum alloy tube
Abstract The aluminum alloy AA 6351 is a precipitation hardened alloy of the Al-Mg-Si system, additionally containing Mn and Fe. In this study, the microstructural characterization during processing of a thick wall extruded AA 6351 tube was carried out. Several complementary techniques for microstructural characterization were used, such as polarized light o
REM, Int. Eng. J.. Publicado em: 19/06/2019
-
32. Y3+ substituted Sr-hexaferrites: sol-gel synthesis, structural, magnetic and electrical characterization
Resumo Hexaferritas de estrôncio com adição de Y3+ com composição química SrYxFe12-xO19 (x= 0,0, 0,5, 1,0, 1,5) foram sintetizadas com sucesso pelo método sol-gel com autocombustão. Os estudos estruturais e morfológicos das amostras preparadas foram investigados usando a técnica de difração de raios X, espectroscopia de energia dispersiva, micros
Cerâmica. Publicado em: 06/06/2019
-
33. Estimativa do potencial de recuperação energética de resíduos sólidos urbanos usando modelos matemáticos de biodigestão anaeróbia e incineração
RESUMO Atualmente, um dos grandes problemas enfrentados pelos gestores de resíduos sólidos urbanos (RSU) é a disposição final dos resíduos gerados por sua população. As disposições de resíduos devem ser feitas em espaços e sob condições adequados de modo a minimizar os impactos socioeconômicos e ambientais. Nesse contexto, este artigo teve por
Eng. Sanit. Ambient.. Publicado em: 30/05/2019
-
34. COMPARATIVE STUDY OF TiO2 AND ZnO APPLICATION IN HYBRID SOLAR CELLS USING COPOLYMER P3OT/P3MT
Hybrid inorganic-organic solar cells are an attractive alternative energy source because of their low-cost production and ability to make use of a large amount of solar radiation available. This work aims to evaluate different solar cells composed of TiO2 and ZnO with P3OT/P3MT copolymer. Layers of semiconductor oxides were deposited on transparent fluorine-
Quím. Nova. Publicado em: 02/05/2019
-
35. The Modification of (Nd0.5Ta0.5)4+ Complex-Ions on Structure and Electrical Properties of Bi0.5Na0.5TiO3-BaTiO3 Ceramics
The (Bi0.5Na0.5)0.94Ba0.06Ti1-x (Nd0.5Ta0.5) xO3 (0.01≤x≤0.05) lead-free ceramics (BNBT-xNT) used (Nd0.5Ta0.5)4+ complex-ions to modify its structure and electrical properties. The BNBT-xNT ceramics exhibit the coexistence of tetragonal and rhombohedral phase. The (Nd0.5Ta0.5)4+ complex-ions prohibit grain growth, and its average grain size decreases fro
Mat. Res.. Publicado em: 14/03/2019
-
36. Conceitos básicos de radiômetros de substituição elétrica para medidas da Irradiância Solar Total
Resumo A irradiância solar total (TSI) é definida como a energia emitida pelo Sol por unidade de área e recebida pela Terra. Durante muitos anos essa energia foi considerada constante, no entanto, hoje se sabe que há variações em diferentes escalas de tempo. A medição do valor absoluto da TSI precisar ser realizada em ambiente extraterrestre devido �
Rev. Bras. Ensino Fís.. Publicado em: 07/01/2019