Influência do Regime Transiente Sobre a Microdureza e Microestrutura nos Aços ASTM-A36 e SAE-1045 Soldados pelo Processo MAG

AUTOR(ES)
FONTE

Soldag. insp.

DATA DE PUBLICAÇÃO

08/08/2019

RESUMO

Resumo O regime quase-estacionário pode não ser alcançado em soldagens a arco elétrico de peças de pequenas dimensões e/ou de materiais de maior condutividade térmica. Entretanto, o regime transiente sempre ocorrerá no início e no final da soldagem. Neste regime, a variação do fluxo de energia via calor pode promover variações microestruturais e, consequentemente, variações de propriedades físicas. Portanto, o objetivo deste estudo é analisar as variações de dureza e de microestrutura ao longo do cordão de solda nos regimes transiente e quase-estacionário, com o processo GMAW e consumível ER70S-6, nos aços ASTM-A36 e SAE-1045. Foram realizados cordões sobre chapa e coletados ciclos térmicos na face oposta à face soldada, a partir de termopares soldados em diferentes posições ao longo de uma linha paralela à linha central do cordão. Também foram realizados ensaio de microdureza e metalografia. Obtiveram-se maiores taxas de resfriamento no início do cordão, durante o regime transiente, resultando em maiores frações volumétricas de ferrita acicular e menores frações de ferrita de contorno de grão e de Widmanstätten. Consequentemente, obteve-se um aumento de dureza em torno de 20% no início do cordão, tendo-se como referência aos valores de dureza do regime quase estacionário.Abstract The quasi-stationary state may not be achieved in electrical arc welding of small parts and/or materials of higher thermal conductivity. However, the transient state will always occur at the beginning and end of the welding. In this case, the variation of the energy flow through heat can promote microstructural variations and, consequently, variations of physical properties. Therefore, the objective of this study is to analyze the hardness and microstructure variations along the weld bead in the transient and quasi-stationary states, with the GMAW process and consumable ER70S-6, in the ASTM-A36 and SAE-1045 steels. The welds were carried on plate and collected thermal cycles on the face opposite the welded face, from thermocouples welded in different positions along a line parallel to the center line of the welds. Also, microhardness test and metallography were carried out. Higher cooling rates were obtained at the beginning of the cord during the transient regime, resulting in larger volumetric fractions of acicular ferrite and smaller fractions ferrite of the grain contour and Widmanstätten. Consequently, a hardness increase was obtained at around 20% at the beginning of the weld, with reference to the hardness values of the quasi-stationary state.

Documentos Relacionados