Carbon Fibers
Mostrando 25-36 de 108 artigos, teses e dissertações.
-
25. Mechanical and Water Intake Properties of Banana-Carbon Hybrid Fiber Reinforced Polymer Composites
The concern for the environmental pollution and the prevention of resources has attracted researchers to develop new eco-friendly green materials based on sustainability principles. In this experimental study, there are six different composite samples were fabricated by using banana and carbon fibers with epoxy resin matrix. The mechanical properties such as
Mat. Res.. Publicado em: 26/01/2017
-
26. Applicability of FT-IR Techniques and Goniometry on Characterization of Carbon Fiber Surfaces
ABSTRACT Carbon fibers have been widely used as structural reinforcement in aeronautical composites, because of their exceptional mechanical properties. However, carbon fibers present few polar groups on their surfaces inducing a weak interaction with some thermosetting and thermoplastic matrices. Surface treatments, such as thermal and electrochemical oxida
J. Aerosp. Technol. Manag.. Publicado em: 2016-03
-
27. Thermal Stabilization study of polyacrylonitrile fiber obtained by extrusion
A low cost and environmental friendly extrusion process of the Polyacrylonitrile (PAN) polymer was viabilized by using the 1,2,3-propanetriol (glycerol) as a plasticizer. The characterization of the fibers obtained by this process was the object of study in the present work. The PAN fibers were heat treated in the range of 200 °C to 300 °C, which is the te
Polímeros. Publicado em: 2015-12
-
28. Influence of the polymeric coating thickness on the electrochemical performance of Carbon Fiber/PAni composites
Abstract Carbon fiber/polyaniline composites (CF/PAni) were synthesized at three different deposition time of 30, 60 and 90 min by oxidative polymerization. The composite materials were morphologically and physically characterized by scanning electron microscopy and by Raman spectroscopy, respectively. Their electrochemical responses were analyzed by cyclic
Polímeros. Publicado em: 2015-10
-
29. Evolution of texture and microstructure during thermo-mechanical processingin ultrathin low carbon steels
ABSTRACT In this research paper an analysis concerning the evolution of crystallographic texture during hot rolling processing of low carbon steel is presented. The study was performed on a steel sheet with an initial thickness of 1.9 mm used in the process of cold rolling. In order to assess the differences between tensile and compressive deformation, a 90�
Matéria (Rio J.). Publicado em: 2015-09
-
30. Production of Inulinase by Free and Immobilized Cells of Penicillium funiculosum p.36
The aim of this work was to optimize the growth conditions and continuous production of the enzyme using free and immobilized cells of inulinase by Penicillium funiculosum. The highest yield of enzyme (163.5U/mL) was obtained when the culture was incubated at 27oC and 200 rpm for 96h in a fermentation medium containing both inulin and peptone as sole carbon
Braz. arch. biol. technol.. Publicado em: 2015-08
-
31. Effect of the Fiber Orientation Relatively to the Plasma Flow Direction in the Ablation Process of a Carbon-Phenolic Composite
ABSTRACT: Composite materials are vastly employed in rocket nozzle extensions and as thermal protection shields in aerospace industry. In both cases, ablative and thermal properties play an important role for material choice and equipment sizing. These properties are strongly dependent on the way the pieces are manufactured. For the case of nozzle extensions
J. Aerosp. Technol. Manag.. Publicado em: 2015-03
-
32. Effects of CFRP retrofit on impact response of shear-deficient scaled reinforced concrete beams
An experimental procedure is carried out to investigate response features of semi-deep reinforced concrete (RC) beams with dominant static shear failure subjected to low-velocity impact dynamic load both in intact and retrofitted cases. Built specimens have scaled geometry and material properties preserving physical similarity with full-scale members and are
Lat. Am. j. solids struct.. Publicado em: 2015-01
-
33. Dynamics of the chemical composition and productivity of composts for the cultivation of Agaricus bisporus strains
Two compost formulations based on oat straw (Avena sativa) and brachiaria (Brachiaria sp.) were tested for the cultivation of three Agaricus bisporus strains (ABI-07/06, ABI-05/03, and PB-1). The experimental design was a 2 x 3 factorial scheme (composts x strains) with 6 treatments and 8 repetitions (boxes containing 12 kg of compost). The chemical characte
Braz. J. Microbiol.. Publicado em: 2013-12
-
34. Glass fiber hybrid composites molded by RTM using a dispersion of carbon nanotubes/clay in epoxy
Nanocomposites based on epoxy and a mixture of clays and multi-walled carbon nanotubes (MWCNT) were produced by casting, and also molded by RTM using glass fibers as reinforcement, yielding a hybrid multi-scale micro/nanocomposite material. Two types of montmorillonite clays were used, natural (MMT-Na) and organophilic (MMT-30B). Higher viscosity was obtaine
Mat. Res.. Publicado em: 02/07/2013
-
35. Nano-engineered composites: interlayer carbon nanotubes effect
The concept of carbon nanotube interlayer was successfully introduced to carbon fiber/epoxy composites. This new hybrid laminated composites was characterized by Raman spectroscopy, X-ray diffraction, scanning electron microscopy and tensile tests. An increase on peak stress close to 85% was witnessed when CNTs interlayer with 206.30 mg was placed to carbon
Mat. Res.. Publicado em: 05/03/2013
-
36. Reação de deslocamento de gás d Água sobre catalisadores de cobre e níquel suportados em alumina e nanofibra de carbono / Water gas shift reaction over copper and nickel catalysts supported on alumina and carbon nanofibers
A reação de deslocamento de gás d água, também conhecida como water gas shift reaction (WGSR), é muito utilizada na produção de hidrogênio, por meio da conversão do monóxido de carbono em CO2 e da água em H2. No presente trabalho, catalisadores de cobre e níquel suportados em alumina ou nanofibras de carbono (NFC) foram utilizados para estudo da
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 13/08/2012