Turbulence Models
Mostrando 1-12 de 68 artigos, teses e dissertações.
-
1. SIMULATION AND EXPERIMENTAL INVESTIGATION OF POWER CONSUMPTION, GAS DISPERSION AND MASS TRANSFER COEFFICIENT IN A MULTI-PHASE STIRRED BIOREACTOR
Abstract Bio-oxidation leaching of refractory gold concentrate was carried out in a typical gas-liquid-solid three-phase stirred bioreactor. The bacteria, which adhered to solid particle surfaces and spread over the liquid phase, require sufficient oxygen and nutrient of carbon and nitrogen, and then the mass transfer rate should be considered. However, the
Braz. J. Chem. Eng.. Publicado em: 13/01/2020
-
2. Aerodynamic effects on a high slenderness concrete chimney
Resumo Este trabalho apresenta os resultados da determinação teórico-experimental do comportamento aerodinâmico de uma chaminé esbelta de concreto armado, com 150m de altura e esbeltez 30. Foram construídos dois modelos reduzidos: um rígido para medição das pressões e outro aeroelástico, reproduzindo as principais características dinâmicas da es
Rev. IBRACON Estrut. Mater.. Publicado em: 13/12/2019
-
3. ON THE PERFORMANCE OF DIFFERENT RANS BASED MODELS TO DESCRIBE THE TURBULENT FLOW IN AN AGITATED VESSEL USING NON-STRUCTURED GRIDS AND PIV VALIDATION
ABSTRACT The performances of the Standard κ-ε, RNG, Realizable, κ-ω and RSM turbulence models to describe the behavior of the flow in agitated tank reactors were evaluated. Because most of these tanks have complex geometries, structured meshing schemes are not a practical alternative in engineering. Two particular unstructured meshing schemes composed of
Braz. J. Chem. Eng.. Publicado em: 15/07/2019
-
4. Comparison of In-Flight Measured and Computed Aeroelastic Damping: Modal Identification Procedures and Modeling Approaches
ABSTRACT The Operational Modal Analysis technique is a methodology very often applied for the identification of dynamic systems when the input signal is unknown. The applied methodology is based on a technique to estimate the Frequency Response Functions and extract the modal parameters using only the structural dynamic response data, without assuming the kn
J. Aerosp. Technol. Manag.. Publicado em: 2016-06
-
5. Numerical Study of the b-Ξ Flame Wrinkling Combustion Model in Oracles Test Rig
ABSTRACT: Numerical modeling of premixed combustion is important for a wide range of machines and systems focusing on compliance with the increasing pollutants reduction requirements. However good industrial numerical combustion models need a practical requiring, in this way, a balance between speed and accuracy. The flamelet models are suitable for this pur
J. Aerosp. Technol. Manag.. Publicado em: 2015-12
-
6. Calculation of Aircraft Target's Single-Pulse Detection Probability
ABSTRACT: The original radar cross section data or some rough models are often used to estimate a given aircraft target detection probability. The calculation results may not be very accurate as targets are different from one another and the real radar detection process is complex. A new method for radar cross section model generation is proposed and it take
J. Aerosp. Technol. Manag.. Publicado em: 2015-09
-
7. Simulação tridimensional de uma coluna de bolhas cilíndrica : análise em sistema bifásico por técnica de velocimetria por imagem de partícula (PIV), shadow imaging e simulação / Three-dimensional simulation of a cylindrical bubble column : analysis in biphase system by technique of particle image velocimetry (PIV), shadow imaging and simulation
This research aims to evaluate the numerical results from Computational Fluid Dynamics (CFD) simulations and experimental results obtained using Particle Image Velocimetry (PIV) and Shadow Imaging in a bubble column of 1m height, diameter of 14,5cm with a gas distributor with 5 holes of 1 mm diameter each one. The system studied was water-air. The study was
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 16/07/2012
-
8. A swirler stabilized combustion chamber for a micro-gas turbine fuelled with natural gas
Micro-gas turbines are a good alternative for on-site power generation, since their operation is very reliable. The possibility of operating with various fuels increases versatility and, as a result, the usage of these devices. Focusing on a performance improvement of a tri-fuel low-cost micro-gas turbine, this work presents investigations of the inner flow
J. Braz. Soc. Mech. Sci. & Eng.. Publicado em: 2012-12
-
9. Droplet dispersion angle measurements on a Pease-Antony Venturi scrubber
A Pease-Anthony Venturi scrubber is a gas cleaning device that uses liquid, injected in the equipment as jets, to remove contaminants from the gas. The liquid jet is atomized into droplets, which are dispersed throughout the equipment due to the turbulence. The performance of the scrubber is affected by the spatial distribution of the droplets. Although CFD
Brazilian Journal of Chemical Engineering. Publicado em: 2012-03
-
10. Characterization of Surface Level Wind in the Centro de Lançamento de Alcântara for Use in Rocket Structure Loading and Dispersion Studies
Abstract: We present wind data collected for ten days during the dry season in 2008 during the Murici II Campaign, which was carried out in the area of the Centro de Lançamento de Alcântara (CLA). The main goals are to better understand processes governing the wind regime in the CLA and the development of tools for analyzing the impact of wind on rocket st
J. Aerosp. Technol. Manag.. Publicado em: 2012-03
-
11. Generation of stationary Gaussian processes and extreme value distributions for high-cycle fatigue models - application to tidal stream Turbines
The operating environment of tidal stream turbines is random due to the variability of the sea flow (turbulence, wake, tide, streams, among others). This yields complex time-varying random loadings, making it necessary to deal with high cycle multiaxial fatigue when designing such structures. It is thus required to apprehend extreme value distributions of st
J. Braz. Soc. Mech. Sci. & Eng.. Publicado em: 2012
-
12. Investigação do escoamento bifásico gás-líquido em uma coluna de bolhas retangular por meio da técnica CFD / Investigation of two-phase gas-liquid flow in a rectangular bubble column using CFD technique
This study aims to evaluate the main forces which act in gas-liquid flow in a rectangular bubble column of dimensions 150cm x 26;4cm x 3;1cm (height (H) x width (W) x depth (D)), with centralized aeration, using CFD technique. The proposed case is based in a experimental study of an air-water system operating in homogeneous bubbly flow, with initial liquid h
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 12/12/2011