Thermal Waves
Mostrando 1-12 de 24 artigos, teses e dissertações.
-
1. Análisis de la forma de onda de señales de Emisión Acústica producida en ensayos de interfaces ceramo-metálicas
ABSTRACT The study of ceramic-metal interface is of special importance in odontology area by the current demand about dental prostheses, so it is very important to be more and more similar to natural teeth and with a long service life. With the aim of assessing in detail the behavior of ceramic-metal interface used in dental restorations systems, in this wor
Matéria (Rio J.). Publicado em: 19/07/2018
-
2. Mechanical Loss Angle Measurement for Stressed thin Film Using Cantilever Ring-Down Method
Mechanical loss of the coating materials, and hence thermal noise from the mirror coatings, is a limiting factor for the sensitivity of the laser interferometer gravitational waves detector at its most sensitive frequency range. Mechanical loss of the thin films are often measured using the cantilever ring-down method. But when the thin film is under stress,
Mat. Res.. Publicado em: 28/05/2018
-
3. An Overview of Research into Low Internal Friction Optical Coatings by the Gravitational Wave Detection Community
The direct detection of gravitational waves by ground-based interferometric gravitational wave detectors in recent years has opened a new window of the universe, allowing the astrophysical observations of previously unexplored phenomena, such as the collisions of black holes and neutron stars. However, small thermodynamic fluctuations of the density of the t
Mat. Res.. Publicado em: 24/05/2018
-
4. A Comuputerized DRBEM model for generalized magneto-thermo-visco-elastic stress waves in functionally graded anisotropic thin film/substrate structures
A numerical computer model, based on the dual reciprocity boundary element method (DRBEM) for studying the generalized magneto-thermo-visco-elastic stress waves in a rotating functionally graded anisotropic thin film/substrate structure under pulsed laser irradiation is established. An implicit-implicit staggered algorithm was proposed and implemented for us
Lat. Am. j. solids struct.. Publicado em: 2014-05
-
5. Thermoelastic slowness surfaces in anisotropic media with thermal relaxation
Analysis for general closed form solution of the thermoelastic waves in anisotropic heat conducting materials is obtained by using the solution technique for the biquadratic equation in the framework of the generalized theory of thermoelasticity. Obtained results are general in nature and can be applied to the materials of higher symmetry classes such as tra
Lat. Am. j. solids struct.. Publicado em: 2014
-
6. Preparation of refractory calcium aluminate cement using the sonochemical process
Calcium aluminate cements (CAC) were prepared using the sonochemical process, followed by heat treatment. A study was made of the action of ultrasonic waves and the influence of thermal treatment conditions on two initial molar compositions of 1:1 and 1:2 of calcia:alumina. The aqueous suspension containing the raw materials (A-50 alumina and CaO) was subjec
Mat. Res.. Publicado em: 22/03/2013
-
7. Numerical evaluation of an air-to-air missile radar cross section signature at X-band
Abstract: The remote detection of a vehicle requires that some kinds of its emissions are tracked and detected. Usually, electromagnetic emissions are used in the form of radar (electromagnetic waves in the range of radiofrequency and microwaves). Different types of antennas are used as sensors, tailored to the signal frequency band and its polarization, as
J. Aerosp. Technol. Manag.. Publicado em: 2011-12
-
8. Estudo do Limiar Nociceptivo durante Privação de Sono utilizando o Potencial Evocado por Laser / Nociceptive Threshold Investigation during Sleep Deprivation by means of the Laser Evoked Potential.
In the present study, we investigated the effects of total and REM sleep deprivation on the thermal nociceptive threshold using the laser-evoked potential (LEP). Twenty-eight male adult volunteers were randomly assigned to groups of Control (CTRL), Total (T-SD) and REM (REM-SD) sleep deprivation. Pain parameters, such as thermal noxious and warmth thresholds
Publicado em: 2010
-
9. Investigation of the theory of coupling compositis in thermal waves fields / Investigação da teoria de acoplamentos de compósitos em campos de ondas térmicas
In this work we elaborate an analytical solution of the temperature field of an opaque material containing two overlapping and parallel subsurface cylinders, illuminated by a modulated light beam. The method is based on the expansion of plane and cylindrical thermal waves, in series of Bessel and Hankel functions. Firstly, the work shows the model of propaga
Publicado em: 2009
-
10. Estimate of energy balance in the basin Jaguaribe-CE using remote sensing techniques / Estimativa do balanço de energia na bacia do Baixo Jaguaribe utilizando técnicas de sensoriamento remoto.
Using techniques of remote detection, this work aimed to obtain the energy balance in the Basin of Low Jaguaribe, Perimeter irrigated Tabuleiro de Russas and dam Santo Antônio de Russas. Two images of sensor TM of the satellite Landsat 5 obtained together DGI (Department of Generation of Images) of INPE, composed by six bands, (1,2,3,4,5,7) of the spectrum
Publicado em: 2009
-
11. Metodos baseados na fotoacustica para caracterização de materiais magnetocaloricos / Methods based on the photoacoustic for characterization of magnetocaloric materials
In this work the photoacoustic technique was used to develop experimental setups to investigate magnetocaloric materials, which have been of great interest due to their applications in refrigeration systems. The value (4,5 ± 0,2).10-6 m2/s was determined, at room temperature, as the thermal di usivity of the Gd, based on the two-beam photoacoustic method, b
Publicado em: 2008
-
12. Characterization and estimation of occurrence of heat waves with impact on broiler mortality / Caracterização e previsão de ondas de calor com impacto na mortalidade de frangos de corte
As broiler production increases in Brazil it appears the need of optimizing production system mainly due to the market competitiveness, and technological resources application are required for reducing losses. Productive loss decurrently from heat wave (HW) incidence is quite common in broiler rearing under tropical conditions, and the solution for this is a
Publicado em: 2008