Thermal Analysis Tests
Mostrando 13-24 de 194 artigos, teses e dissertações.
-
13. Kinetics of the Carbonation Reaction of Lithium Orthosilicate Using a Typical CO2 Concentration of Combustion Gases
The aim of this work was to investigate the carbonation kinetics of lithium orthosilicate (Li4SiO4) by thermogravimetry and via thermodynamic simulations, using CO2 concentrations of 15 vol.% (typical of combustion gases) and 100 vol.%. Tests were performed in a thermogravimetric analyzer, in two sequential steps: (1) pre-treatment at 750 ºC with N2 and (2)
Mat. Res.. Publicado em: 05/09/2019
-
14. Mechanical properties of mortar produced with the replacement of natural sand by scheelite residue
Resumo O resíduo gerado pelas atividades industriais representa um custo, já que os geradores são responsáveis pela sua gestão, transporte, tratamento e disposição. O estado do Rio Grande do Norte, Brasil, é o maior produtor de resíduos de scheelita. O objetivo desta pesquisa foi caracterizar este resíduo de mineração, identificar sua similaridad
Cerâmica. Publicado em: 15/08/2019
-
15. Influência da porosidade em algumas propriedades mecânicas da liga de Al-6,5%Si-0,6%Mg fundida e tratada termicamente
RESUMO As ligas de Al-Si-Mg são atualmente as mais utilizadas para obtenção de peças fundidas comerciais, isto porque as propriedades mecânicas desses materiais podem ser melhoradas através de tratamentos térmicos. No entanto, cabe salientar que nas peças fundidas de ligas de alumínio, a porosidade é o defeito que ocorre mais frequentemente. Esse d
Matéria (Rio J.). Publicado em: 20/05/2019
-
16. The Influence of Seasonal Temperature Variation on Blood Pressure Behavior
Abstract Background: Hypertension in Brazil affects 32.5% of the population, accounting for 50% of deaths due to cardiovascular disease. The correct measurement and interpretation of blood pressure are essential for attaining an adequate disease diagnosis and management. Objective: To verify the correlation between the seasonal temperature variation during
Int. J. Cardiovasc. Sci.. Publicado em: 06/05/2019
-
17. Painéis de partículas elaborados do mesocarpo do dendê como alternativa ao MDF utilizado na construção civil
RESUMO A escassez dos recursos florestais integrada à necessidade de aquisição de produtos mais ecológicos demanda o uso de outros tipos de biomassa, além da madeira no setor construtivo. Diante disso, o mesocarpo do dendê - resíduo oriundo da agroindústria e com grande potencial de utilização para desenvolvimento de novos materiais - surge como al
Eng. Sanit. Ambient.. Publicado em: 01/04/2019
-
18. Experimental study of brass properties through perforation tests using a thermal chamber for elevated temperatures
Abstract Experimental analysis on standard brass alloy has been carried out using a high pressure gas gun. Perforation tests have been performed for a variety of impact velocities from 40 to 120 m/s in order to study the material behaviour and to define failure modes. The main aim of the study has been to provide results using an innovative thermal chamber t
Lat. Am. j. solids struct.. Publicado em: 22/10/2018
-
19. Estudio de propiedades mecánicas locales de uniones soldadas por fricción agitación (FSW) en AA6061-T6 mediante Small Punch Test (SPT)
ABSTRACT Friction Stir Welding (FSW) is a solid state process that has reach a strong technological impact in welding of aluminum alloys. Among its advantages, it may include the ability of joining materials that are difficult to weld by fusion. In welding of heat treatable aluminum alloys, some degradation in metallurgical properties is observed, so welds s
Matéria (Rio J.). Publicado em: 19/07/2018
-
20. Análisis de la forma de onda de señales de Emisión Acústica producida en ensayos de interfaces ceramo-metálicas
ABSTRACT The study of ceramic-metal interface is of special importance in odontology area by the current demand about dental prostheses, so it is very important to be more and more similar to natural teeth and with a long service life. With the aim of assessing in detail the behavior of ceramic-metal interface used in dental restorations systems, in this wor
Matéria (Rio J.). Publicado em: 19/07/2018
-
21. Replacement of Commercial Silica by Rice Husk Ash in Epoxy Composites: A Comparative Analysis
Since epoxy resins are used as composite matrix with excellent results, and silica is one of the fillers most often employed, this study compared the performance of rice husk ash (RHA) as filler in epoxy composites, in replacement for high-purity silica. Composites were molded containing 20%, 40%, and 60% (wt) silica or RHA. Viscosity analysis, infrared spec
Mat. Res.. Publicado em: 05/04/2018
-
22. Effects of Multiple Extrusions on Structure-property Performance of Natural Fiber High-density Polyethylene Biocomposites
Detailed analysis of the effects of multiple extrusions on physical, mechanical, micro-structural as well as dynamic mechanical thermal properties of natural fiber high-density polyethylene (HDPE) composites is reported. Composite materials containing HDPE, wood flour, and Maleic Anhydride polyethylene (MAPE) were manufactured and subjected to a recycling pr
Mat. Res.. Publicado em: 01/02/2018
-
23. Effect of the Cooling Rate on the Properties of Veneer Porcelain for Zirconia Dental Prosthesis
To solve chipping of veneer porcelain in zirconia dental prosthesis it has been studied different cooling rates in firing schedules to control residual stresses generated by differences in thermal properties between the ceramics. However, cooling rates may affect the porcelain, irrespectively of interaction with zirconia. This study analyzed the effect of co
Mat. Res.. Publicado em: 07/08/2017
-
24. Effect of photodynamic therapy and non-thermal plasma on root canal filling: analysis of adhesion and sealer penetration
Abstract Objective The aim of this study was to evaluate the effect of photodynamic therapy (PDT) and non-thermal plasma (NTP) on adhesion and sealer penetration in root canals. Material and Methods Sixty single-rooted premolars were used. The teeth were prepared using a crown-down technique. NaOCl and EDTA were used for irrigation and smear layer remova
J. Appl. Oral Sci.. Publicado em: 2017-08