Influência da porosidade em algumas propriedades mecânicas da liga de Al-6,5%Si-0,6%Mg fundida e tratada termicamente

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

20/05/2019

RESUMO

RESUMO As ligas de Al-Si-Mg são atualmente as mais utilizadas para obtenção de peças fundidas comerciais, isto porque as propriedades mecânicas desses materiais podem ser melhoradas através de tratamentos térmicos. No entanto, cabe salientar que nas peças fundidas de ligas de alumínio, a porosidade é o defeito que ocorre mais frequentemente. Esse defeito geralmente resulta em propriedades mecânicas pobres. Nesse sentido, o presente estudo tem como objetivo analisar a influência do percentual de porosidade nas propriedades mecânicas de limite de resistência à tração, deformação específica e dureza em uma liga de Al-Si-Mg fundida e tratada termicamente. Para tanto, foi obtida por processo de fundição e solidificação a liga Al-6,5%Si0,6%Mg (% em massa). A partir da liga básica foram obtidos lingotes com e sem processo de desgaseificação com pastilhas de hexacloroetano. Os lingotes produzidos foram submetidos a tratamentos térmicos de solubilização e posterior envelhecimento artificial. Amostras transversais foram extraídas ao longo do comprimento dos lingotes para análise do percentual de porosidade e determinação das propriedades mecânicas. Com os resultados determinados nas análises de porosidade e ensaios mecânicos de tração e dureza, foi determinada a influência do percentual de porosidade na variação das propriedades mecânicas.ABSTRACT Al-Si-Mg alloys are currently the most popular alloys for obtaining commercial castings, because the mechanical properties of these materials can be improved by heat treatments. However, it should be noted that in cast aluminum alloy parts, porosity is the most frequently occurred defect. This defect usually results in poor mechanical properties. In this sense, the present study aims to analyze the influence of the porosity fraction on the mechanical properties of ultimate tensile strength, specific deformation and hardness in as cast and thermally treated Al-Si-Mg alloy. For that, it was obtained by natural casting and solidification process, an alloy having the following chemical composition: Al-6.5% Si-0.6% Mg. From the basic alloy were obtained ingots with and without degasification process with hexachloroethane pellets. The ingots produced were subjected to thermal treatments of solubilization and subsequent artificial aging. Transverse samples were drawn along the length of the ingots for analysis of porosity fraction and determination of mechanical properties. With the results found in the analysis of porosity and the mechanical tests of tensile and hardness, it was measured the influence of the percentage of porosity on the variation of the mechanical properties.

Documentos Relacionados