Stability And Instability
Mostrando 13-24 de 453 artigos, teses e dissertações.
-
13. Standardization and quality assessment for clinical grade mesenchymal stem cells from human adipose tissue
Abstract Background Mesenchymal stem cells have immense potential in stem cell-based therapies, however there is a pre-requisite to develop a curative cell dose. Adipose tissue-derived mesenchymal stem cells are promising mainly due to their potential abundance, immunomodulatory effect and remarkable differentiation potential. Nevertheless, senescence may d
Hematol., Transfus. Cell Ther.. Publicado em: 15/04/2019
-
14. Stability Characteristics of a Model Trim Adjustment System for Open Loop Active Control of Thermoacoustic Instability
ABSTRACT Thermoacoustic instability in liquid rocket engines can have potentially catastrophic consequences. Active control based on feedback promises improved stability margin over a wider range of operating conditions than passive control. In the present work, the thermoacoustic characteristics of a trim adjustment active control system based on variable v
J. Aerosp. Technol. Manag.. Publicado em: 14/01/2019
-
15. GFEM STABILIZATION TECHNIQUES APPLIED TO DYNAMIC ANALYSIS OF NON-UNIFORM SECTION BARS
Abstract The Finite Element Method (FEM), although widely used as an approximate solution method, has some limitations when applied in dynamic analysis. As the loads excite the high frequency and modes, the method may lose precision and accuracy. To improve the representation of these high-frequency modes, we can use the Generalized Finite Element Method (GF
Lat. Am. j. solids struct.. Publicado em: 29/10/2018
-
16. Development and validation of a stability-indicating LC-UV and LC-MS/MS methods for quantitative analysis of anisomycin and identification of degradation products
ABSTRACT Multifunctional drug anisomycin was subjected to forced degradation in accordance with International Conference on Harmonisation (ICH) guidelines for the first time. The drug was exposed to the recommended stress conditions of hydrolysis (acidic, alkaline and neutral), oxidation, thermal stress and photolysis, in order to investigate its stability.
Braz. J. Pharm. Sci.. Publicado em: 26/07/2018
-
17. On the stability of internally pressurized thick-walled spherical and cylindrical shells made of functionally graded incompressible hyperelastic material
Abstract In this paper, stability analysis of thick-walled spherical and cylindrical shells made of functionally graded incompressible hyperelastic material subjected to internal pressure is presented. Instability point happens in the inflation of above mentioned shells and in this paper effect of material inhomogeneity and shell thickness has been investig
Lat. Am. j. solids struct.. Publicado em: 04/06/2018
-
18. Direct Numerical Simulation Code Validation for Compressible Shear Flows Using Linear Stability Theory
ABSTRACT: In order to simulate compressible shear flow stability and aeroacoustic problems, a numerical code must be able to capture how a baseflow behaves when submitted to small disturbances. If the disturbances are amplified, the flow is unstable. The linear stability theory (LST) provides a framework to obtain information about the growth rate in relatio
J. Aerosp. Technol. Manag.. Publicado em: 07/05/2018
-
19. Optimal hydrated lime concentration in asphalt binder to improve photo degradation resistance
Abstract The effect of short-term oxidation, evaluated by using a Rolling Thin Film Oven Test, and the effect of weathering aging on the oxidation process of hydrated lime modified asphalts were studied. Hydrated lime (HL) has been known as an additive for asphalt mixtures and is now considered as a binder additive that increases asphalt mixture durability.
REM, Int. Eng. J.. Publicado em: 2018-04
-
20. Tibial tunnel enlargement and joint instability after anterior cruciate ligament reconstruction. A prospective comparison between autograft and allograft
Abstract Purpose: To investigate tibial tunnel widening and knee instability after ACL reconstruction with hamstring autograft or irradiated soft tissue allograft. Methods: Eight-two patients were divided into two groups: autograft group and allograft group. Radiographic and clinical evaluations were performed. Results: Seventy patients were followed u
Acta Cir. Bras.. Publicado em: 2017-12
-
21. Application of Full Factorial Design to Evaluate the Effect of Different Variables on the Stability of Biodiesel:Diesel Blends under Storage Conditions
Biodiesel is obtained from a renewable source and has been used as an alternative to fossil fuels. It has unsaturated fatty acid methyl esters that can degrade due to oxidation of the double bonds. The instability of biodiesel during storage may cause problems regarding the maintenance and operation of motors. This work evaluated the effect of several variab
J. Braz. Chem. Soc.. Publicado em: 2017-10
-
22. Effect of clay incorporation in the dimensional stability of FKM nanocomposite
ABSTRACT In this work was studied the effect of nanoparticle incorporation in the dimensional stability of elastomer matrix. To avoid excessive swelling and consequently dimensional instability in the films, crosslinking has been shown to be an efficient and simple method for achieve the reducing membrane swelling and improving mechanical stability. The elas
Matéria (Rio J.). Publicado em: 20/07/2017
-
23. Pectin lyase overproduction by Penicillium griseoroseum mutants resistant to catabolite repression
Abstract Expression of pectinolytic genes is regulated by catabolic repression limiting the production of pectin lyase (PL) if the natural inducer, pectin, is missing from the growth medium. Here, we report the isolation of Penicillium griseoroseum mutants resistant to 2-deoxy-d-glucose (DG) that show resistance to catabolite repression and overproduce PL. T
Braz. J. Microbiol.. Publicado em: 2017-07
-
24. Slag Evaluation to Reduce Energy Consumption and EAF Electrical Instability
In steel mills that operate with electric arc furnaces (EAF), it is interesting to ensure greater stability to the electric arc to aim at less distortion in the electrical system, with consequent reduction in electric power consumption. The slag foaming increases electric arc stability by reducing the total harmonic distortion (THD) between EAF phases. In th
Mat. Res.. Publicado em: 01/09/2016