Softening
Mostrando 1-12 de 207 artigos, teses e dissertações.
-
1. Zeólita NaA sintetizada sobre fibra de vidro como estratégia para otimização do abrandamento de águas duras
NaA ZEOLITE SYNTHESIZED OVER FIBERGLASS AS A STRATEGY FOR OPTIMIZING HARD WATER SOFTENING. Zeolite NaA has been successfully synthesized over glass fiber surface previously activated by alkaline treatment. By varying the time of the treatment and the amount of silica and alumina precursors used in the reaction mixture, a sample with higher zeolite concentrat
Química Nova. Publicado em: 2022
-
2. Mechanical properties and fractography of cement-based composites reinforced by natural piassava and jute fibers
Abstract Today’s demand for environmentally friendly and energy-efficient solutions to the construction industry has driven researchers to match natural resources with traditional technics to develop new building technologies. However, there are literature limitations about the correlation of fiber-matrix interface with the failure of natural fibers in mor
Cerâmica. Publicado em: 2022
-
3. Interfacial bond-slip relationship between Carbon Fiber Reinforced Polymer Plate and Concrete after High Temperature of Asphalt Paving Construction
Abstract The bond-slip relationship of Carbon Fiber Reinforced Polymer (CFRP) plate-concrete after the influence of high temperature action of Stone Mastic Asphalt (SMA) paving was investigated in this article. Two groups of double shear specimens with different bonding length were designed and tested. Based on the test results, the failure modes of specimen
Lat. Am. j. solids struct.. Publicado em: 25/11/2019
-
4. Evaluation of Dynamic Mechanical Properties of Fique Fabric/Epoxy Composites
The fique is a plant typical of the Colombian Andes, from which relatively common items are fabricated. One of these is woven fabric extensively applied in sackcloths. The mechanical strength of fique fabric have motivated recent investigations on possible reinforcement of polymer matrix composites. For this purpose its thermo-mechanical behavior was unveile
Mat. Res.. Publicado em: 14/10/2019
-
5. Behaviors of Embrittlement and Softening in Heat Affected Zone of High Strength X90 Pipeline Steels
Abstract The embrittlement and softening behaviors in heat affected zone of X90 pipeline steel were studied, and the influence of weld thermal cycle on microstructure and mechanical properties were discussed by combining the effect of peak temperature on the phase transition point (Ar3). Results show that there are embrittlement and softening zones existed i
Soldag. insp.. Publicado em: 15/08/2019
-
6. Multi-scale representation of plastic deformation in fiber-reinforced materials: application to reinforced concrete
Abstract Here we present a multi-scale model to carry out the computation of brittle composite materials reinforced with fibers, and we show its application to standard reinforced concrete. The computation is carried out within an operator-split framework on the macro-scale, which allows for different failure mechanisms to develop in separate phases, as both
Lat. Am. j. solids struct.. Publicado em: 12/08/2019
-
7. Polioencephalomalacia (PEM) in calves associated with excess sulfur intake
RESUMO: A polioencefalomalacia (PEM) é a caracterização morfológica para o amolecimento da substância cinzenta encefálica, e uma de suas principais etiologias é a ingestão excessiva de enxofre. Este trabalho descreve um surto desta enfermidade em bezerros de um a três meses de idade em uma propriedade de Santa Catarina. O lote era composto por 27 be
Pesq. Vet. Bras.. Publicado em: 18/07/2019
-
8. Effect of cold-working process on cyclic deformation of electrolytic copper
Abstract Cyclic softening and hardening processes are expressed by the change in the stress amplitude necessary to cause a given strain amplitude. Understanding the cyclic stress-strain behavior of materials is an important step in the complex study of their fatigue behavior. The potential differences between the defect structures of cold-formed materials ma
REM, Int. Eng. J.. Publicado em: 19/06/2019
-
9. Softening Behavior During Annealing of Overaged and Cold-rolled Aluminum Alloy 7075
This work proposes studying the softening kinetics of aluminum alloy 7075-T6. Firstly, AA 7075 strips were overaged (300°C and 5 hours). Then, the overaged strips were cold-rolled at room temperature (45% in thickness reduction) and, after that, annealed at different temperatures (200°C and 250°C) and time intervals (30 minutes - 4 hours). By using polari
Mat. Res.. Publicado em: 30/05/2019
-
10. On the mechanical behavior of an Al 7075 alloy deformed by asymmetrical and conventional rolling
ABSTRACT Samples of the Al 7075 naturally and artificially aged were processed by conventional and asymmetrical rolling with 5% of thickness reduction. The rolling processes were evaluated under room temperature and under warm condition (130°C). Mechanical properties were evaluated by uniaxial tensile and Vickers microhardness tests. Microstructure evolutio
Matéria (Rio J.). Publicado em: 20/05/2019
-
11. Análise espacial da AIDS e os determinantes sociais de saúde
RESUMO: Introdução: Os determinantes sociais de saúde (DSS) podem influenciar na distribuição das taxas da síndrome da imunodeficiência adquirida (AIDS) de uma região. Este trabalho teve o objetivo de analisar os DSS que se relacionam com a AIDS. Método: Estudo ecológico com técnicas de análise espacial. Analisaram-se 7.896 notificações dos
Rev. bras. epidemiol.. Publicado em: 25/04/2019
-
12. Influence of CaO Addition, FeO/SiO2 , and MgO/SiO2 on the Melting Characteristic Temperatures of FeO-SiO2-MgO-CaO System
In order to decrease the oxidation temperature of fayalite in molten nickel slags, the influence of CaO addition, FeO/SiO2, and MgO/SiO2 on melting characteristic temperatures of FeO-SiO2-MgO-CaO system were investigated. The melting characteristic temperatures, including softening temperature (Ts), hemispherical temperature (Th), and flow temperature (Tf),w
Mat. Res.. Publicado em: 08/04/2019