Photoacoustic
Mostrando 1-12 de 94 artigos, teses e dissertações.
-
1. CHARACTERIZATION-PERFORMANCE OF ZnO AND ZnO/ZnFe2O4 CATALYST USING ARTIFICIAL AND SOLAR LIGHT FOR MERCURY (II) REDUCTION
Abstract This study describes the application of ZnO commercial oxide and ZnO/ZnFe2O4 mixed oxides to reduce the mercury ion (Hg2+) in the aqueous phase. The catalysts synthesized were characterized by thermogravimetric analysis, adsorption and desorption of N2, scanning electron microscopy, X-ray diffraction, Fourier transform infrared spectroscopy, photoac
Braz. J. Chem. Eng.. Publicado em: 30/09/2019
-
2. Structural, Thermal, Optical, and Photoacoustic Study of Mechanically Alloyed Nanocrystalline SnTe
A nanostructured SnTe phase was produced by mechanical alloying after 2 h of milling. Part of the as-milled powder was annealed and its X-ray diffraction (XRD) pattern was recorded. The XRD patterns of the as-milled and annealed samples were refined using the Rietveld method. After annealing, partial decomposition of the SnTe phase was observed and corrobora
Mat. Res.. Publicado em: 07/06/2018
-
3. Photoacoustic-based thermal image formation and optimization using an evolutionary genetic algorithm
Abstract Introduction For improved efficiency and security in heat application during hyperthermia, it is important to monitor tissue temperature during treatments. Photoacoustic (PA) pressure wave amplitude has a temperature dependence given by the Gruenesein parameter. Consequently, changes in PA signal amplitude carry information about temperature varia
Res. Biomed. Eng.. Publicado em: 28/05/2018
-
4. Can intra-radicular cleaning protocols increase the retention of fiberglass posts? A systematic review
Abstract The presence of residues within the root canal after post-space preparation can influence the bond strength between resin cement and root dentin when using fiberglass posts (FGPs). Currently, there is no consensus in the literature regarding what is the best solution for the removal of debris after post-space preparation. This systematic review invo
Braz. oral res.. Publicado em: 15/03/2018
-
5. Structural and Photoacoustic Study of Cr11Ge19 Prepared by Mechanical Alloying
A nanostructured Cr11Ge19 phase was produced by mechanical alloying for 15 h. Decomposition occurred for larger milling times, yielding Cr, Ge, Cr2O3 and GeO2. According to the Cr-Ge phase diagram, the Cr11Ge19 phase is stable up to ≈ 928 oC, but, when submitted to milling, a structural instability causes its decomposition. We studied this structural insta
Mat. Res.. Publicado em: 22/06/2017
-
6. Removal of calcium hydroxide from Weine Type II systems using photon-induced photoacoustic streaming, passive ultrasonic, and needle irrigation: a microcomputed tomography study
ABSTRACT Objective This study compared the effectiveness of Er:YAG laser-activated irrigation (PIPS), passive ultrasonic irrigation (PUI) with EndoUltra and standard needle irrigation (SNI) in the removal of calcium hydroxide [Ca(OH)2] from the mesial roots of Weine Type II mandibular molars. Material and Methods Thirty mandibular molars were screened by
J. Appl. Oral Sci.. Publicado em: 2016-12
-
7. Applicability of FT-IR Techniques and Goniometry on Characterization of Carbon Fiber Surfaces
ABSTRACT Carbon fibers have been widely used as structural reinforcement in aeronautical composites, because of their exceptional mechanical properties. However, carbon fibers present few polar groups on their surfaces inducing a weak interaction with some thermosetting and thermoplastic matrices. Surface treatments, such as thermal and electrochemical oxida
J. Aerosp. Technol. Manag.. Publicado em: 2016-03
-
8. Photoacoustic Thermal Characterization of Banana Fibers
Natural fibers are attracting the interest of engineering sectors owing to specific advantages such as lightweight and lower cost as well as an inherent condition of being renewable, biodegradable, recyclable and environmentally correct with respect to CO2 emission. In addition, several natural fibers present mechanical and thermal properties appropriate for
Mat. Res.. Publicado em: 2015-12
-
9. Nectandra falcifolia: potential phytopharmaceutical for skin damage protection designed by statistical approach and characterized by photoacoustic spectroscopy
AbstractPhytopharmaceutical products are being used in the treatment and prevention of health problems. Nowadays, the development and evaluation of novel pharmaceutical products is expensive and time consuming. A statistical approach is a good tool for optimal development processes. Nectandra falcifolia (Nees) J.A. Castigl. ex Mart. Crov. & Piccinini, Laurac
Rev. bras. farmacogn.. Publicado em: 2015-06
-
10. Photoacoustic spectroscopy as an approach to assess chemical modifications in edible oils
Espectroscopia fotoacústica foi utilizada tanto para obter algumas propriedades ópticas de óleos de soja, canola e oliva quanto para avaliar as alterações ocorridas devido ao tratamento térmico dos óleos. A intensidade do sinal fotoacústico normalizado e a sua fase foram medidas, independentemente, como uma função do comprimento de onda da fonte de
J. Braz. Chem. Soc.. Publicado em: 2013-03
-
11. ANÁLISE DA CAMADA NITROCEMENTADA NO AÇO AISI 316 POR MEIO DA TÉCNICA DE FOTOACÚSTICA DE CÉLULA ABERTA
A técnica fotoacústica é um método utilizado no estudo de propriedades físicas e térmicas de materiais sólidos, líquidos ou gasosos, com base no efeito fototérmico. O fenômeno fototérmico resulta da combinação de mecanismos físicos como a expansão térmica, difusão térmica e a flexão termoelástica. A difusividade térmica é um parâmetro
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 22/03/2012
-
12. PROTETORES SOLARES À BASE DE FILTROS INORGÂNICOS: DESENVOLVIMENTO E CARACTERIZAÇÃO
The inorganic sunscreens represented mainly by titanium dioxide (TiO2) and Zinc Oxide (ZnO), were classified as inert particles, therefore, they are pointed out as the best way to protect the skin against the harmful effects of ultraviolet radiation (UV). However, recent studies suggest that these particles have several stability problems that may lead to a
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 01/01/2012