Matrix Viscosity
Mostrando 1-12 de 94 artigos, teses e dissertações.
-
1. Physical and mechanical properties of low, ultralow and no cement refractory castables containing MgO nanoparticles developed in situ by means of polymeric resins
Resumo A introdução de nanopartículas de MgO desenvolvidas in situ na matriz de concretos refratários de baixo teor de cimento, ultrabaixo e sem cimento foi feita por meio de uma resina polimérica aquosa de baixa viscosidade, produzida pelo método Pechini. A adição da resina líquida aos concretos desempenhou dois papéis: primeiro serviu como fornec
Cerâmica. Publicado em: 14/11/2019
-
2. Avaliação morfológica de fibras eletrofiadas de policaprolactona em função do tipo de solvente
RESUMO Recentemente, estratégias da engenharia tecidual para o tratamento de feridas e queimaduras prevê o uso de biomateriais nanoestruturados capazes de facilitar a regeneração da pele e a cura das feridas. Um dos processos utilizados para a obtenção deste tipo de biomaterial é a eletrofiação. Por meio deste processo é possível formar filmes com
Matéria (Rio J.). Publicado em: 16/09/2019
-
3. Milk from different species on physicochemical and microstructural yoghurt properties
RESUMO: O objetivo da presente pesquisa foi avaliar as diferenças nas propriedades químicas e na estrutura física do iogurte produzido com leite de diferentes espécies (ovinos, bovinos e caprinos). Para cada experimento, leite de ovelha cru (S), vaca (C) e cabra (G), foram usados para fabricar 4L de iogurtes (Y) de cada espécie (SY, CY e GY, respectiva
Cienc. Rural. Publicado em: 13/06/2019
-
4. Rheological characteristics PBAT/organoclay compounds
Abstract The rheological behavior of poly (butylene adipate-co-terephthalate) (PBAT) and its composites prepared with three different organoclays was investigated. Composites containing up to 7.5%, w/w organoclay, were prepared by two routes: (a) direct melt blending in an internal laboratory mixer with high intensity rotors and (b) concentrates (prepared in
REM, Int. Eng. J.. Publicado em: 2019-06
-
5. Preparation and in vitro & in vivo evaluation of cephalexin matrix tablets
The purpose of the study is to develop cephalexin controlled-release matrix tablets by using lower proportions of release retardant polymer and to establish their in vitro & in vivo correlation. Tablets were compressed by incorporating polymers in a matrix form along with drug which prolong the drug release. Twelve formulations were prepared by mixing ethyl
Braz. J. Pharm. Sci.. Publicado em: 29/11/2018
-
6. Effect of Preparation Method on the Electrical and Mechanical Properties of PVC/Carbon Nanotubes Nanocomposites
The biggest challenge for the development of carbon nanotubes polymeric nanocomposites is in the suitable dispersion and distribution of the nanometric particles along the polymer matrix. Several preparation methods have been used to obtain nanocomposites, highlighting the mixture with polymer solution followed by solvent evaporation and the hot compacting.
Mat. Res.. Publicado em: 02/08/2018
-
7. Replacement of Commercial Silica by Rice Husk Ash in Epoxy Composites: A Comparative Analysis
Since epoxy resins are used as composite matrix with excellent results, and silica is one of the fillers most often employed, this study compared the performance of rice husk ash (RHA) as filler in epoxy composites, in replacement for high-purity silica. Composites were molded containing 20%, 40%, and 60% (wt) silica or RHA. Viscosity analysis, infrared spec
Mat. Res.. Publicado em: 05/04/2018
-
8. ZnS Nanocrystals as an Additive for Gamma-Irradiated Poly (Vinyl Chloride)
Zinc sulfide (ZnS) was synthesized by sonochemical method and nanoparticles with crystallite size around 2 nm were obtained. PVC containing ZnS nanoparticles at concentrations of 0.10; 0.30; 0.50; 0.7 and 1.00 wt% were gamma irradiated (60Co) at room temperature in air. No appreciable decrease in PVC Viscosity-Average Molar Mass (Mv) was observed for samples
Mat. Res.. Publicado em: 01/02/2018
-
9. Study of Coffee Grounds Oil Action in PVC Matrix Exposed to Gamma Radiation: Comparison of Systems in Film and Specimen Forms
The poly (vinyl chloride), PVC, undergoes changes in its physicochemical properties when it is exposed to gamma radiation. Thus, the radiolytic stabilization of PVC is one way for obtain a material with radiation resistance. In this work, we studied the coffee grounds oil as PVC radiolytic protection in two systems forms: PVC film and PVC specimen. The syste
Mat. Res.. Publicado em: 18/12/2017
-
10. Fractographic and rheological characterizations of CF/PP-PE-copolymer composites tested in tensile
Abstract This work shows the fractographic study of fractured surfaces resulted from tensile tests of thermoplastic composites based on poly(propylene-co-ethylene) (PP-PE) and modified PP-PE copolymers reinforced with continuous carbon fibers (CF). The PP-PE matrix was modified with two agents called AM1 (based on maleic anhydride) and AM2 (containing an ela
Polímeros. Publicado em: 29/06/2017
-
11. Mixing process influence on thermal and rheological properties of NBR/SiO2 from rice husk ash
Abstract Silica was extracted from rice husk ash (RHA) by a sequence of reactions to produce nanosilica. Two laboratory routes, co-coagulation and spray drying, were used to incorporate the nanosilica into the rubber matrix. Samples were characterized regarding filler incorporation efficiency, thermal stability, rheological behavior and morphology. Thermogra
Polímeros. Publicado em: 29/06/2017
-
12. Physicochemical Properties and Field Evaluation of Monolithic Wax Formulations for the Controlled Release of a Forest Pest Pheromone
This work shows the way to develop a monolithic device for the release of an active agent. Different waxes to prepare monolithic dispensers were used. Studies to characterize the release rate of the pheromone dispensers, and to determine many physicochemical properties of the active components and waxes utilized as matrices, were conducted. The advantages of
J. Braz. Chem. Soc.. Publicado em: 2017-02