Load Transfer Efficiency
Mostrando 1-12 de 14 artigos, teses e dissertações.
-
1. Comparison Between Three- and Four-coil Wireless Power Transfer Systems with Resonant Coils
Abstract In this paper, it is demonstrated that the efficiency and ability to transfer power to the load in three-coil wireless power transfer (WPT) systems are always higher than in equivalent four-coil ones. On the other hand, it is shown that there are features attainable in four-coil WPT system that are not in three-coil ones. For instance, in a four-coi
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2021-03
-
2. Uncracked joints in plain concrete pavements: causes, effects and possibilities of improvements
AbstractDuring the construction of Jointed Plain Concrete Pavements (JPCPs) in Chile, it was observed that joints remained uncracked. The objectives of this paper are to evaluate the effects of uncracked joints (UnCrJ) in JPCPs and to propose possible solutions or improvements to avoid or minimize this phenomenon. Considering low thermal amplitude as cause o
J. Transp. Lit.. Publicado em: 2016-03
-
3. Maximum Power Transfer versus Efficiency in Mid-Range Wireless Power Transfer Systems
AbstractThe condition for maximum power transfer of 2-coils wireless power transfer (WPT) system is derived from circuit analysis and discussed together with the respective WPT system efficiency (η). In the sequence, it is shown that a 4-coils WPT system (which can be divided in source, two communication and load circuits) without power losses at the two co
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2015-06
-
4. Cost-effective joints configurations of concrete pavements for a sustainable infrastructure
Abstract Nowadays, there are Concrete Pavements (CPs) with Joints Configurations (JCs) that reduce initial costs about 20%. But are these JCs produced by Early-Entry Saw-Cutting (EESC), Unsealed Joints (UJs) and Shorter Joint Spacing (ShJS) able to maintain the traditional performance of CPs? The aim of this paper is to analyze the effects of the joints beha
J. Transp. Lit.. Publicado em: 2015-04
-
5. Oxygen air enrichment through composite membrane: application to an aerated biofilm reactor
A highly permeable composite hollow-fibre membrane developed for air separation was used in a membrane aerated biofilm reactor (MABR). The composite membrane consisted of a porous support layer covered with a thin dense film, which was responsible for oxygen enrichment of the permeate stream. Besides oxygen enrichment capability, dense membranes overcome maj
Braz. J. Chem. Eng.. Publicado em: 2013-12
-
6. Produção e eficácia de anticorpos gerados contra glicolipídios de Paracoccidioides brasiliensis / Production and efficacy of antibodies generated against glycolipids of P. brasiliensis
Paracoccidioidomycosis (PCM) is a systemic fungal infection most prevalent in Latin America, whose etiologic agent, Paracoccidioides brasiliensis, is a yeast with a complex cell wall structure consisting of proteins, glycoproteins, polysaccharides, lipids, and melanin polypeptides that gather physical, chemical and biological conditions to serve as antigens.
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 10/10/2012
-
7. Study on the factors affecting load transfer in jointed plain concrete pavements. / Estudo dos fatores que afetam a transferência de carga em juntas de pavimentos de concreto simples.
Este trabalho de pesquisa foi realizado na busca de melhor entendimento do comportamento estrutural de pavimentos de concreto no que tange a transferência de carga em juntas, de quais os fatores que influenciam essa transferência de esforços nas juntas e a determinação, em caráter preliminar, de como as condições climáticas vigentes na área tropica
Publicado em: 2009
-
8. ALGORITMOS HEURÍSTICOS DE OTIMIZAÇÃO DA PROTEÇÃO E MANOBRA EM REDES DE DISTRIBUIÇÃO DE ENERGIA / RELIABILITY HEURISTIC ALGORITHMS FOR PROTECTION AND MANEUVERING DEVICES DISTRIBUTION NETWORKS
The new regulations of the electricity sector have requested from the power utilities great performance efficiency on their distribution systems, requiring more rigorous quality and continuity energy levels. In Brazil, the privatization of the power utility companies has been allowing the adoption of new planning and operation policies, that necessarily cons
Publicado em: 2008
-
9. CONCEPÇÃO, CONSTRUÇÃO E AVALIAÇÃO DE FOTORREATORES CATALISADOS NA DEGRADAÇÃO DE CARGA POLUENTE E AMOXICILINA EM EFLUENTE HOSPITALAR
The focus of this study was the application of advanced oxidation photoprocesses, heterogeneous photocatalysis and photo-Fenton, in the degradation of pollutant load and amoxicillin in wastewater from the University Hospital of Santa Maria (HUSM), evaluating the photoreactors performance in the degradation efficiency. In the hospital wastewater there is a wi
Publicado em: 2008
-
10. Tratamento de lixiviado através de filtro anaeróbio associado a membrana de microfiltração
Nowadays, the use of membrane bioreactors (MBRs) has been researched in many places of the world to treat different kinds of wastewater. The use of MBRs has advantages over other processes when the main focus is on the reuse of wastewater, small areas for wastewater treatment plant or restricted laws conditions. Commonly, the MBRs have been designed with sus
Publicado em: 2006
-
11. Non linear signal analysis applied to friction force identification in tribological tests / Identificação da força de atrito através de análise de sinais não lineares em ensaios tribológicos
When the surfaces of two elastic bodies present relative motions under certain amount of contact pressure the mechanical system can be instable. Experiments conducted on elastic bodies under friction forces shown that the dynamical system is self-excited by the non-linear behavior of frictional forces. The main objectives of this thesis are the study of the
Publicado em: 2005
-
12. UM MODELO PARA CÁLCULO DE FLUXO DE POTÊNCIA EM REDES RADIAIS / A MODEL POWER FLOWS BASED ON THE POWER SUMMATION METHOD
This work presents a methodology for radial power flows based on the power Summation Method, able to exploit the network particular characteristics in order to achieve accuracy and efficiency. This work also presents a novel model for radial network control based on sensitivity coefficients that evaluate load transfer or curtailment effects on network perfor
Publicado em: 1992