Lead Titanate
Mostrando 13-20 de 20 artigos, teses e dissertações.
-
13. Study of pyroelectric activity of PZT/PVDF-HFP composite
Flexible, free-standing piezo and pyroelectric composite with 0 to 3 connectivity was made up from Lead Zirconate Titanate (PZT) powder and poly(vinylidene fluoride-hexafluoropropylene) (PVDF-HFP) copolymer. The pyroelectric and the piezoelectric longitudinal (d33) coefficients were measured. A 50/50 vol.% PZT/PVDF-HFP composite resulted in piezo and pyroele
Materials Research. Publicado em: 2003-12
-
14. Dielectric characterization of materials at microwave frequency range
In this study a coaxial line was used to connect a microwave-frequency Network Analyzer and a base moving sample holder for dielectric characterization of ferroelectric materials in the microwave range. The main innovation of the technique is the introduction of a special sample holder that eliminates the air gap effect by pressing sample using a fine pressu
Materials Research. Publicado em: 2003-01
-
15. Fotoluminescência de SrTiO3 dopado com Al, Y, Cr, V e Nb.
It was studied the effect of the dopants, Al, Y, Cr, Nb and V, on the photoluminescent properties of films and powders of amorphous strontium titanate. With this purpose the techniques of SEM, XRD, UV/Visible spectroscopy and room temperature photoluminescence were applied to film and powder samples of strontium titanate, prepared by the Pechini method. A li
Publicado em: 2003
-
16. Uso da técnica do pulso eletroacústico para o estudo de polietilenos e titanato zirconato de chumbo (PZT). / Use of the pulsed electroacoustic technique for the study polyethilens and lead zirconate titanate (PZT).
The purpose this work was using to PEA method for investigation of the ferroelectrics response in PZT and space charge formation in polymeric materials (PE, XLPE) used as electrical insulation for high voltage devices. The PEA method is based on propagation acoustic signal generated by the application of a short electric field pulse, typically 5 ns in durati
Publicado em: 2003
-
17. Hot-pressed transparent PLZT ceramics from low cost chemical processing
Lanthanum-modified lead zirconate titanate (PLZT) ceramics were obtained with high transmittance in the visible range by a combination of an inexpensive chemical processing and hot pressing. Optical, microstructural, pyroelectric, ferroelectric and dielectric properties characterized in this study attested the applicability of the employed method in the prod
Materials Research. Publicado em: 2001-10
-
18. Electroactive properties of flexible piezoelectric composites
A flexible piezoelectric composite with 0-3 connectivity, made from Lead Zirconate Titanate (PZT) powder and vegetable-based polyurethane (PU), was doped with small amount of semiconductor powder. As a result a composite with 0-0-3 connectivity was obtained. The nature of absorption and steady state electrical conduction and the dielectric behaviour have bee
Materials Research. Publicado em: 2001-07
-
19. Effects of the atmosphere and substrate on the crystallization of PLZT thin films
Lead lanthanum zirconate titanate [PLZT (9/65/35)] thin films were prepared by dip-coating on Si (100) or Si/Ti/Pt (100) substrates using a polymeric precursor solution and annealed at 650 °C for 3 h. Perovskite phase formation of the PLZT thin films and microstructure were analysed using XRD and SEM. Effects of Si (100), Si/Ti/Pt (100) substrates and atmos
Materials Research. Publicado em: 2000-07
-
20. Multiple matching scheme for broadband 0.72Pb(Mg1∕3Nb2∕3)O3−0.28PbTiO3 single crystal phased-array transducer
Lead magnesium niobate–lead titanate single crystal 0.72Pb(Mg1∕3Nb2∕3)O3−0.28PbTiO3 (abbreviated as PMN-PT) was used to fabricate high performance ultrasonic phased-array transducer as it exhibited excellent piezoelectric properties. In this paper, we focus on the design and fabrication of a low-loss and wide-band transducer for medical imaging appli
American Institute of Physics.