Flash Point
Mostrando 1-12 de 32 artigos, teses e dissertações.
-
1. Joint calibration of a hydrological model and rating curve parameters for simulation of flash flood in urban areas
RESUMO Nos modelos chuva-vazão, a etapa de calibração geralmente exige tempo e grande quantidade de informação das vazões. No entanto, do ponto de vista prático, a informação usualmente disponível é o nível d’água medido, este, por sua vez, utilizado na construção das curvas-chave. Este artigo propõe uma calibração conjunta dos parâmetro
RBRH. Publicado em: 13/05/2019
-
2. Correlation Between the Composition and Flash Point of Diesel-Biodiesel Blends
Methyl ester biodiesels from vegetable oils, including soy, corn, canola and sunflower, and from swine lard, were prepared. They were mixed with mineral diesel to produce blends from 5% v/v to 50% v/v of biodiesel, i.e., B5, B10, B20 and B50. The flash points of these mixtures, the pure diesel (B0) and the pure biodiesel (B100) were determined. In all cases,
J. Braz. Chem. Soc.. Publicado em: 2015-02
-
3. Effects of micronized sodium chloride on the sensory profile and consumer acceptance of turkey ham with reduced sodium content
The impact of sodium chloride reduction and its substitution for micronized salt on consumer acceptance of turkey ham was investigated. Five formulations - F1 (control - 2.0% NaCl), F2 (1.7% NaCl), F3 (1.4% NaCl), F4 (1.7% micronized NaCl), and F5 (1.4% micronized NaCl) - were evaluated with respect to sodium chloride content and by consumers using a nine-po
Food Sci. Technol. Publicado em: 11/03/2014
-
4. Multi-model MPC with output feedback
In this work, a new formulation is presented for the model predictive control (MPC) of a process system that is represented by a finite set of models, each one corresponding to a different operating point. The general case is considered of systems with stable and integrating outputs in closed-loop with output feedback. For this purpose, the controller is bas
Braz. J. Chem. Eng.. Publicado em: 2014-03
-
5. Desenvolvimento de novas propostas para análise de bioesel e estudo da relação entre ponto de fulgor e o teor de álcool reiduol / Development of new proposals for biodiesel analysis and study of the relationship between flash point and concentration of residual alcohol
Um método de baixo custo é proposto neste trabalho para a análise quantitativa do álcool residual em biodiesel através da determinação do ponto de fulgor. Foram analisados ésteres metílicos obtidos de óleos de soja, milho, girassol e de sebo bovino. Os ésteres etílicos foram obtidos de óleo de soja. Em todos os casos ficou evidente que há uma c
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 10/08/2012
-
6. Estudo da influência da adição de etanol e/ou metanol ao biodiesel associado a ferramentas quimiométricas
The objective of this work is to study the influence of the addition of alcohol methanol or ethanol - to biodiesel. Therefore, Principal Components Analysis (PCA) was combined with infrared spectra with the aim of separating soybean and tallow biodiesel samples with different alcohol contents of ethanol or methanol. PCA yielded a good reduction of data regar
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 20/04/2012
-
7. Gráficos e Animações: uma estratégia lúdica para o ensino-aprendizagem de funções
O conjunto de atividades que integram este trabalho foi construído com o propósito de promover um ensino-aprendizagem lúdico e dinâmico, a fim de estimular a memória gráfica e a inteligência visual. A seqüência didática envolve o ensino de funções e foi aplicada na 1ª série do Ensino Médio. Com o equilíbrio entre a intuição e a visualizaç�
Publicado em: 2011
-
8. Use of Jatropha oil methyl ester and its blends as an alternative fuel in diesel engine
Biomass derived vegetable oils are quite promising alternative fuels for agricultural diesel engines. Use of vegetable oils in diesel engines leads to slightly inferior performance and higher smoke emissions due to their high viscosity. The performance of vegetable oils can be improved by modifying them through the transesterification process. In the present
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2009-09
-
9. Application of experimental design in different stages of the oil refining / Aplicação de planejamento de experimentos em diferentes etapas do refino de petroleo
In this work, experimental design technique was applied to different optimization studies, which were carried out in the Paulínia Refinery (Replan). The work covers applications of the technique in laboratorial scale, in computational tool, and the use of the technique in different industrial plants. The laboratory studies consisted in the evaluation of the
Publicado em: 2009
-
10. Estudo de tratamento de interface proveniente de polidutos
The São Paulo Brasília Pipeline (OSBRA), owed by PETROBRAS, starts at the Planalto Refinery (REPLAN) and supplies gasoline, Diesel oil and liquefied petroleum gas (LPG) to the mid-west region of Brazil. The pipeline is 786 kilometers long with diameter of 20 inches in its first segment and 178 kilometers with 12 inches of diameter in the second. The fuels
Publicado em: 2009
-
11. Avaliação da estabilidade de bio-óleo obtido a partir de óleo de soja durante armazenamento
Fossil fuels are relatively inert maintaining their essential characteristics during tankage even for long periods. On the other hand, biodiesel degrades during storage. The changes that occur during the tankage can be harmful to the fuel injection systems. Therefore, it is of great importance to know the oxidation stability of the bio-oil as obtained by the
Publicado em: 2009
-
12. Estudo das caracteristicas de inflamabilidade de polimeros utilizados na construção civil e industria de transportes / Study of flammability characteristics of polymers used in buildings and automobile industry
The polymer materials are being used in several applications. The great number of existent monomers, as well as the possibility of copolymers synthesis, polymeric alloys formulation and the composites and nanocomposites show that it is possible to obtain materials with different specific properties and for being used in different application areas. However,
Publicado em: 2008