Electrochemical Impedance Spectroscopy Eis
Mostrando 1-12 de 108 artigos, teses e dissertações.
-
1. AN APPROACH BASED ON ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY TO STUDY THE GLYCEROL/BIODIESEL GRAVITY SEPARATION
In this study, electrochemical impedance spectroscopy (EIS) is evaluated as a novel application in the biodiesel purification process. EIS is proposed as a tool to study the behavior of charge carriers produced from side reactions or dissociations of some impurities during the gravitational separation of glycerol dispersed in crude biodiesel after the transe
Quím. Nova. Publicado em: 2020-12
-
2. Gold Nanoparticle/Tetrapyridylporphyrin Hybrid Material: Spectroscopic and Electrocatalytic Properties and Sensor Application
An electrocatalytic active hybrid material prepared by successive stepwise coordinative deposition of 20 nm diameter gold nanoparticles (AuNP) with 5,10,15,20-tetra(4-pyridyl)-21H,23H-porphine (TPyP) on fluorine-doped tin oxide (FTO) substrates previously modified with 3-mercaptopropylsilane is described. Their interaction and assembly were studied by UV-Vis
J. Braz. Chem. Soc.. Publicado em: 2020-11
-
3. Ações contra a Covid-19 na População com Síndrome de Down
An electrocatalytic active hybrid material prepared by successive stepwise coordinative deposition of 20 nm diameter gold nanoparticles (AuNP) with 5,10,15,20-tetra(4-pyridyl)-21H,23H-porphine (TPyP) on fluorine-doped tin oxide (FTO) substrates previously modified with 3-mercaptopropylsilane is described. Their interaction and assembly were studied by UV-Vis
Arq. Bras. Cardiol.. Publicado em: 2020-11
-
4. Corrosion Protection of Steel by Volatile Corrosion Inhibitors: Vapor Analysis by Gas-Diffusion Microextraction and Mass Loss and Electrochemical Impedance in NaCl Deliquescence Tests
A new methodology using gas-diffusion microextraction (GDME) was developed for the analysis of volatile corrosion inhibitors (VCIs). The evaluation of the inhibition efficiency and corrosion rate (ν) was performed by NaCl deliquescence tests and correlated with measurements of polarization resistance (Rp) obtained from electrochemical impedance spectroscopy
J. Braz. Chem. Soc.. Publicado em: 2020-10
-
5. Changes within the care of hematopoietic cell transplantation patients after the shift of a Mexican institution to a COVID-19-only center
A new methodology using gas-diffusion microextraction (GDME) was developed for the analysis of volatile corrosion inhibitors (VCIs). The evaluation of the inhibition efficiency and corrosion rate (ν) was performed by NaCl deliquescence tests and correlated with measurements of polarization resistance (Rp) obtained from electrochemical impedance spectroscopy
Hematol., Transfus. Cell Ther.. Publicado em: 2020-10
-
6. PMMA-SiO2 Organic-Inorganic Hybrid Coating Application to Ti-6Al-4V Alloy Prepared through the Sol-Gel Method
Siloxane-poly(methyl methacrylate) (PMMA) hybrid was synthesized based on the sol-gel method and applied to Ti-6Al-4V through dip-coating. The structural feature of the hybrid was subjected to Fourier-transform infrared spectroscopy (FTIR) and thermogravimetric analysis (TG); its morphological properties were analyzed through scanning electron microscope (SE
J. Braz. Chem. Soc.. Publicado em: 2020-02
-
7. Determination of Catechol and Hydroquinone by Using Perilla frutescens Activated Carbon Modified Glassy Carbon Electrode
High specific surface area activated carbon prepared by Perilla frutescens (PFHSAAC) was modified on the surface of the glassy carbon electrode (GCE) by drop-coating method to construct a PFHSAAC/GCE. The electrochemical properties of the modified electrode were investigated in detail by some electrochemical methods such as cyclic voltammetry (CV), different
J. Braz. Chem. Soc.. Publicado em: 2020-01
-
8. Effect of High-pressure Torsion on Corrosion Behavior of a Solution-treated Al-Mg-Sc Alloy in a Saline Solution
The effect of the increase in crystalline defects in the structure generated by high-pressure torsion (HPT) on the corrosion behavior of metallic materials is not well understood. This report evaluates the influence of HPT on the corrosion behavior of a solution treated Al-3wt% Mg-0.2wt% Sc alloy in a 3.5 wt./v.% NaCl solution. The electrochemical behavior o
Mat. Res.. Publicado em: 04/11/2019
-
9. Nanoparticles of Fe2O3 and Co3O4 as Efficient Electrocatalysts for Oxygen Reduction Reaction in Acid Medium
This paper presents a comparative study about the oxygen reduction reaction (ORR) catalyzed by nanoparticles of Fe2O3 and Co3O4 applied on the surface of glassy carbon electrodes (GCE). The nanoparticles were synthesized using the modified polymeric precursor method (Pechini). These two nanomaterials were characterized by Fourier transform infrared spectrosc
J. Braz. Chem. Soc.. Publicado em: 24/10/2019
-
10. Investigating the Effect of Curing in the Chloride Diffusion Coefficient of Conventional Concrete
Concrete is the most used material in the construction industry worldwide. Built concrete infrastructure is exposed to specific environments conditions during the asset’s life, which impose chemical and physical actions that may lead to premature deterioration. Poor concrete durability and corrosion of reinforcement bars are the primary cause of structural
Mat. Res.. Publicado em: 16/09/2019
-
11. Produção e caracterização de revestimentos de ligas metálicas Cu-Sn em banho eletrolítico contendo glicina: ensaios preliminares
RESUMO Os problemas relacionados à corrosão são frequentes, podendo ocorrer nas mais variadas áreas, tais como, nas indústrias química, petroquímica, naval, de construção civil e automobilística, dentre outros setores produtivos. Portanto, métodos para prevenir a corrosão devem ser empregados para evitar a perda de materiais e o uso de revestimen
Matéria (Rio J.). Publicado em: 16/09/2019
-
12. Avaliação da resistência à corrosão do filme de silanoviniltrimetoxisilano modificado com íons Ce (III) e Ce (IV) como pré-tratamento do aço carbono
RESUMO Silanos são compostos organo funcionais utilizados como agentes de acoplamentos entre interfaces orgânicoinorgânicas, com boas propriedades de adesão. Por esta razão, o uso de silanos como pré-tratamento para aços, vem ganhando espaço já que também são geradores de resíduos de menor toxidade ao meio ambiente e à saúde humana. Para melhor
Matéria (Rio J.). Publicado em: 16/09/2019