Corrosion Defects
Mostrando 1-12 de 36 artigos, teses e dissertações.
-
1. Effect of High-pressure Torsion on Corrosion Behavior of a Solution-treated Al-Mg-Sc Alloy in a Saline Solution
The effect of the increase in crystalline defects in the structure generated by high-pressure torsion (HPT) on the corrosion behavior of metallic materials is not well understood. This report evaluates the influence of HPT on the corrosion behavior of a solution treated Al-3wt% Mg-0.2wt% Sc alloy in a 3.5 wt./v.% NaCl solution. The electrochemical behavior o
Mat. Res.. Publicado em: 04/11/2019
-
2. Quality analysis of galvanized pipes applied to natural gas installations in civil construction
ABSTRACT Some natural gas distributors for residential and commercial buildings in Brazil use galvanized steel tubes and fittings manufactured by the hot-dip zinc process that are supported by the specifications contained in the Brazilian Standards. Zinc coating is one of the most widely used methods to provide protection against corrosion. It is therefore e
Matéria (Rio J.). Publicado em: 10/06/2019
-
3. Carbon based DLC films: Influence of the processing parameters on the structure and properties
ABSTRACT Hydrogenated carbon-based films, such as DLC (“Diamond Like Carbon”), have interesting properties such as excellent tribological behavior, low friction coefficient, high superficial hardness and good wear resistance; they are chemically inert and highly corrosion resistant. They are deposited by means of PACVD (plasma-assisted chemical vapor dep
Matéria (Rio J.). Publicado em: 19/07/2018
-
4. Titanium Coating with Hydroxyapatite and Chitosan Doped with Silver Nitrate
Biomaterials are effective alternatives for tissue substitution, including the bone tissue, since they do not pose risks of transmission of diseases or immune rejection. Nowadays, there is an interest in new materials capable of being associated with other substances which favor bone formation, especially natural biopolymers, in particular chitosan, which ma
Mat. Res.. Publicado em: 01/02/2018
-
5. Cu-Sn Coatings Produced Using Environmentally Non-Aggressive Electrolyte Containing Sodium Tartrate
This work proposes the production of Cu-Sn alloy coatings with anticorrosive properties, using an environmentally non-aggressive bath. The coatings were electrodeposited on carbon steel substrate AISI 1020 using an electrolyte containing CuCl2 and SnCl2, and sodium tartrate as the complexant agent. The produced coatings were characterized by scanning electro
Mat. Res.. Publicado em: 27/11/2017
-
6. Corrosion Mechanism Suggested Based on Electrochemical Analysis and SVET for Uncoated Tinplate and Post Coated With a Hybrid Film
The tinplate, used in the packaging sector and formed from a metal substrate, comprises a steel base which has undergone a surface treatment to produce a thin layer of FeSn2, a tin layer and an oxide tin layer. Currently, packaging using surface treatment is based on the use of chromates because these metals provide an excellent corrosion resistance. Nontoxi
Mat. Res.. Publicado em: 09/10/2017
-
7. The use of Shearography technique to evaluate polymeric composite repairs - case study
ABSTRACT Pipelines are subject to a variety of defects such as wall thickness loss, grooves, dents and holes. To restore the pipe integrity, polymeric composite repairs can be used. The inspection of repaired pipes is of fundamental importance, not only to verify the initial integrity, but also to monitor their state over time. Shearography is a laser optica
Matéria (Rio J.). Publicado em: 09/10/2017
-
8. Evaluation of a Thermochromic Liquid Crystal for Use as a Temperature Sensor for Components of Electrical Systems
Connectors used in electrical power distribution systems should allow the passage of electricity continuously and without interruption. However, this does not always occur due to failure caused by improper assembly and/or corrosion of the materials employed, which reflects the quality of service. Notable among the new detection technologies that have been st
Mat. Res.. Publicado em: 22/05/2017
-
9. Surface Properties Contrast between Al Films and TiO2 Films Coated on Magnesium Alloys by Magnetron Sputtering
Al films and TiO2 films were separately coated on AZ31 magnesium alloy substrates by means of magnetron sputtering method. The surface properties of the samples were explored and compared. Scanning electron microscope (SEM) observed the compact structure characteristics of as-deposited Al films and TiO2 films. After heat treatment under 200ºC for half an ho
Mat. Res.. Publicado em: 20/02/2017
-
10. Influence of the Addition of Montmorillonite in an Epoxy Powder Coating Applied on Carbon Steel
AbstractPolymer coatings have been used for the corrosion protection of metal surfaces acting as a physical barrier against several corroding media. In spite of the good efficiency of these coatings their resistance is limited due to the presence of localized defects which give place to localized corrosion. Aiming to improve the barrier properties of these c
Mat. Res.. Publicado em: 2015-10
-
11. Niobium and niobium-iron coatings on API 5LX 70 steel applied with HVOF
The present study aimed to create and characterize niobium and niobium-iron 60% coatings applied to steel API 5L X70 using the hypersonic thermal spray process (HVOF). The morphologies of the coatings were analyzed using scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD) and profilometry, while the coatings' har
Mat. Res.. Publicado em: 27/06/2014
-
12. Estudos das características técnicas e operacionais das galerias de águas pluviais como subsídios para gestão patrimonial e estabelecimento de diretrizes para projetos de sistemas de drenagem urbana
The purpose of this work is to study the emergence and evolution of pathological manifestations in urban stormwater channels and relate them to technical and operational characteristics of concrete structures so that plans for urban drainage systems management are developed, as well as new concepts for stormwater channel projects. The main reference is the D
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 20/04/2012