Coating Particle
Mostrando 13-24 de 68 artigos, teses e dissertações.
-
13. The Effect of Electroless Bath Parameters and Heat Treatment on the Properties of Ni-P and Ni-P-Cu Composite Coatings
Ni-P-(Cu) composite coatings were applied on a St37 steel in an acidic bath of hypophosphite composite. The effect of the concentration of the Cu particles and pH of the solutionon the amount of Ni and P of the coatings, their morphology, and hardness of the coatings were explored. Some of the coated samples were also heat treated at 400ºC for 1 hour. The p
Mat. Res.. Publicado em: 08/01/2018
-
14. ENCAPSULATION OF EXTRACT FROM WINERY INDUSTRY RESIDUE USING THE SUPERCRITICAL ANTI-SOLVENT TECHNIQUE
Abstract Grape pomace (seed, skin and stem) is a winery byproduct with high levels of biologically active compounds, such as antioxidants and antimicrobials, that could be converted into high added-value products. Since these components are easily degraded by oxygen, light and high temperature exposure, stabilization is important, for instance, by a microenc
Braz. J. Chem. Eng.. Publicado em: 2016-09
-
15. Macrophages adhesion rate on Ti-6Al-4V substrates: polishing and DLC coating effects
Abstract Introduction Various works have shown that diamond-like carbon (DLC) coatings are able to improve the cells adhesion on prosthesis material and also cause protection against the physical wear. On the other hand there are reports about the effect of substrate polishing, in evidence of that roughness can enhance cell adhesion. In order to compare and
Res. Biomed. Eng.. Publicado em: 2016-06
-
16. Comportamiento Tribológico y Microestructural en Recubrimientos Aplicados por GTAW y HVOF (Proceso Térmico de Espreado) y Usado en Recuperación de Aceros Grado Herramienta AISI/SAE D2
Abstract The Fe-Cr-Mo alloys are use in covers to protect the components that are under wear and corrosion. The high velocity thermo spray covering by HVOF (high velocity oxi-fuel) in Fe-Cr-Mo alloys has reported as a good result in projection fields for the steel tool grade for cold work. The HOVF is an attractive method to apply covering and recuperate dia
Soldag. insp.. Publicado em: 2016-06
-
17. Development of a Powder-feed Device and Procedures for the Application of an Experimental Alloy in Overhead PTA-P Welding
Abstract: When they are damaged by cavitation, hydroelectric power plant turbine blades must be repaired using operations that could benefit from developments in welding technologies. In light of this, the LABSOLDA welding laboratory at the Federal University of Santa Catarina is making efforts to enhance the flexibility and robustness of the powder-fed plas
Soldag. insp.. Publicado em: 2015-12
-
18. Incorporação de resíduos de placas de circuitos impressos (RPCI) em massas cerâmicas triaxiais utilizando experimentos com misturas / Incorporation of waste printed circuit boards (WPCB) in triaxial ceramic bodies using experiments with mixtures
The aim of this work is evaluate the effect of incorporation of waste printed circuit boards (WPCB) in physical and mechanical properties of triaxial ceramics for coating. Through the technique of experiment with mixtures seven formulations were developed with clay (40, 53, 60 e 80%); phyllite (20, 33, 40 e 60%) and waste (0, 14, 20 e 40%). The WPCB was char
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/02/2012
-
19. PROTETORES SOLARES À BASE DE FILTROS INORGÂNICOS: DESENVOLVIMENTO E CARACTERIZAÇÃO
The inorganic sunscreens represented mainly by titanium dioxide (TiO2) and Zinc Oxide (ZnO), were classified as inert particles, therefore, they are pointed out as the best way to protect the skin against the harmful effects of ultraviolet radiation (UV). However, recent studies suggest that these particles have several stability problems that may lead to a
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 01/01/2012
-
20. Synthesis and characterization of nanocrystalline hydroxyapatite gel and its application as scaffold aggregation
The sol-gel process is a technique used to synthesize materials from colloidal suspensions and, therefore, is suitable for preparing materials in the nanoscale. In this work hydroxyapatite was used due to its known properties in tissue engineering. Hydroxyapatite Ca10(PO4)6(OH)2 is a bioactive ceramic which is found in the mineral phase of bone tissue and is
Mat. Res.. Publicado em: 02/10/2012
-
21. Application of cassava starch and carnauba wax-based edible coatings in minimally processed apples / Aplicação de coberturas comestíveis à base de fécula de mandioca e cera de carnaúba em maçãs minimamente processadas
This study aimed at formulating a cassava starch, carnauba wax and stearic acid or palmitic acid - based edible coating, and evaluating their properties and their effects when applied to minimally processed apples. In a first step, Plackett-Burman designs were performed for the following variables selection of coating formulations: cassava starch concentrati
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 12/12/2011
-
22. Obtenção e caracterização elétrica de filmes finos de SnO2:Sb / Deposition and electrical properties of sno2:sb films abstract
The growing demand for advanced electronic devices based on nanomaterials has motivated efforts to produce nanoscale building blocks with designed functions. Transparent conducting oxide nanocrystals (TCONs) are particularly promising for the development of such devices. TCONs synthesized in an organic medium play an important role as building blocks because
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 03/03/2011
-
23. Bond strength of three luting agents to zirconia ceramic - influence of surface treatment and thermocycling
OBJECTIVE: This in vitro study aimed to evaluate the influence of different surface treatments, 3 luting agents and thermocycling on microtensile bond strength (µTBS) to zirconia ceramic. Material and METHODS: A total of 18 blocks (5x5x4 mm) were fabricated from zirconia ceramic (ICE Zirkonia) and duplicated into composite blocks (Alphadent). Ceramic blocks
J. Appl. Oral Sci.. Publicado em: 01/07/2011
-
24. Influence of pH of colloidal suspension on the electrical conductivity of SnO2 thin films deposited via Sol-Gel-Dip-Coating
Tin dioxide (SnO2) thin films are deposited by the dip-coating technique from colloidal suspensions prepared with distinct pH through the sol-gel method. The decrease of the pH contributes to the destruction of an electrical layer adjacent to particles in solution, leading to a high degree of aggregation among these particles due to the generation of cross-l
Materials Research. Publicado em: 04/03/2011