Investigation of Mechanical and Metallurgical Properties of Friction Stir Corner Welded Dissimilar Thickness AA5086-AA6061 Aluminium Alloys

AUTOR(ES)
FONTE

Mat. Res.

DATA DE PUBLICAÇÃO

11/06/2018

RESUMO

In this investigation, an attempt has been made to fabricate dissimilar thickness corner joint using non-heat treatable (AA5086) and heat treatable (AA6061) dissimilar aluminium alloys by friction stir welding process with plate thicknesses of 6mm and 4mm. Three parameters and three levels were considered to conduct the experiments such as welding and rotational speeds of 100, 150 and 190 mm/min and 900, 1000 and 1100 rpm and plunge depth of 0.1, 0.2 and 0.3 mm. The mechanical properties were evaluated using hardness and tensile tests. Taguchi grey relational analysis was carried out to determine the optimum process parameters. The higher value of tensile strength was obtained 192 MPa at rotational and welding speeds of 1000 rpm and 150 mm/min which was 76.80% of parent material and maximum hardness was 157 HV at thermomechanically affected zone for the rotational speed of 1100 rpm and hardness at stir zone was maximum because of refined grain formation. The microstructures of various regions were observed and analyzed by optical and scanning electron microscopes. The tensile samples fractured at the heat affected zone. The spindle motor current consumption, work material temperature distribution, and force generation during friction stir welding were estimated and analyzed.

Documentos Relacionados