Influência do formato do pilar na capacidade retentiva de copings metálicos cimentados sobre implantes

AUTOR(ES)

Glauco Pereira Moysés

FONTE

IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia

DATA DE PUBLICAÇÃO

18/07/2008

RESUMO

This study evaluated the influence of the abutment design on the retention of cementretained, implant-supported metallic copings. Two abutments of the same system, with the same height, indications and total occlusal convergence, but of different designs were evaluated. Ten RN SynOcta abutments and ten RN solid titanium abutments both manufactured by Straumann USA and indicated for cement-retained single crowns and fixed partial dentures were tightened to 35Ncm on twenty implant analogs previously placed in resin blocks. Twenty plastic burnout copings were waxed, included, cast and machined by the same operator. After inspected under a stereomicroscope, the copings were cemented (Temp Bond NE) with load of 5 kg maintained for ten minutes. After this, the assemblies were stored for 24h in 100% humidity at room temperature and subjected to a pull-out test at a crosshead speed of 5 mm/min until the displacement of the metallic copings. The load required to dislodge each coping was recorded in kilogram-force and the data were statistically analyzed using the T student test for independent samples. The mean load necessary load to dislodge the metallic copings showed by SynOcta abutments (11,19 kg) was statistically higher than the one for the solid abutments (10,18 kg). With the limitations of this study, we can conclude that the design of the abutment influence significantly the retention of metallic copings.

ASSUNTO(S)

dental implant retenção implante dentário pilar protético iti cimentação retention prosthetic abutment iti ementation odontologia

Documentos Relacionados

• Influência da conicidade do pilar e tipo de agente cimentante na retentividade de coroas metálicas cimentadas sobre pilares personalizáveis de implantes
• Avaliação da adaptação e capacidade de infiltração microbiana na interface implante-pilar protético em diferentes sistemas de implantes
• Estudo da influência do formato das partículas na operação de filtração de gases
• Estudo in vitro da influência do formato e do tratamento de superfície de implantes odontológicos no torque de inserção, resistência ao arrancamento e frequência de ressonância
• Influência do local de ancoragem dos implantes na vértebra sobre o torque de inserção e resistência ao arrancamento