Experimental studies of short concrete reinforced steel fiber beams under bending

AUTOR(ES)
FONTE

Rev. IBRACON Estrut. Mater.

DATA DE PUBLICAÇÃO

20/05/2019

RESUMO

Resumo Este estudo apresenta os resultados do rompimento de dois grupos de vigas de concreto com fibras de aço. Cada grupo foi composto de 4 vigas com vão de 300 mm, 4 com vão de 500 mm e 4 com vão de 800 mm e seção de 15 cm x 15 cm. A variação dos grupos se deu pela quantidade de fibras (I com 40 kg/m³ e II com 60 kg/m³). Foram avaliados o comportamento da tensão tangencial, momento de fendilhação, energia de deformação, tenacidade, efeito escala e energia de fratura. O grupo II apresentou maior resistência máxima, sendo essa diferença pouco significativa, entretanto, quanto menor o vão maior a influência das fibras. O maior consumo de fibras conferiu à matriz maior resistência à flexão e à tensão tangencial, tendo maior influência nos vão menores. Tanto a energia de deformação quanto a energia de fratura apresentam diferenças consideráveis para os vãos menores, chegando quase a se igualar nos dois grupos para o vão de 800 mm. A tenacidade aumentou mais nas vigas de maior vão e sofreu maior redução para o menor vão do grupo II.Abstract This paper presents the results of a test program on 24 concrete beams with a cross section of 15 x 15 cm. Those are divided into two groups of 12 beams. Group I has a steel fiber content of 40 kg/m³ while Group II uses 60 kg/m³ of steel fibers. The tests consider three sets of beam lengths: 300 mm, 500 mm and 800 mm. The beams were submitted to bending aiming at investigating shear stresses, bending, strain energy, toughness, scale effect and fracture energy. Group II showed a slightly higher resistance to rupture than Group I. However, the smaller the length, the larger the influence of the fiber content. The largest fiber content gave the concrete higher resistance when submitted to bending and shear, especially for the smaller lengths. Both strain and fracture energy, however, show considerable differences for smaller lengths, but are almost the same for the 800 mm beams. Toughness shows improvement in the longer beams and a reduction of this property in the shorter beam from Group II.

Documentos Relacionados