Mechanical behaviour of steel fiber reinforced concrete with stone powder
AUTOR(ES)
Periquito, Mário dos Santos, Magalhães, Margareth da Silva
FONTE
Matéria (Rio J.)
DATA DE PUBLICAÇÃO
20/07/2017
RESUMO
ABSTRACT Nowadays, there is an increasing interest in the development of eco-friendly materials. Thus, environmental challenges due to the necessity of reducing worldwide levels of CO2 emissions, to limit the energy consumption and to use industrial waste are promoting an increasing effort to find viable alternatives to minimize pollution from the main productive processes. Thus, this paper addresses the results of an investigation on the influence of stone powder, residue from the production of crushed aggregates, on the mechanical performance of concrete reinforced with steel fibers. The effect of the amount of stone powder sand was evaluated using 0%, 50% and 100% natural sand replacement. Workability and mechanical properties were evaluated by compressive, elastic modulus, four-point bending and abrasion tests. Economic impact study of the composite production was also carried out. Based on the results obtained, it is possible to conclude that the use of crushed stone sand in steel fiber reinforced concrete is beneficial in terms of the workability and abrasion resistance but was some disadvantages. For instance, when 100% manufactured sand was added, the compressive and bending strength was reduced. However, the elastic modulus was not changed. It is also important to highlight that with 100% stone powder content, the compressive strength is still higher than 30MPa and the cost for producing is about of 32% cheaper.
Documentos Relacionados
- Compression specific toughness of normal strength steel fiber reinforced concrete (NSSFRC) and high strength steel fiber reinforced concrete (HSSFRC)
- Mechanical characterization of fiber reinforced Polymer Concrete
- Mechanical and Durability Performance of Polyacrylonitrile Fiber Reinforced Concrete
- Experimental studies of short concrete reinforced steel fiber beams under bending
- Stress-strain curves for steel fiber-reinforced concrete in compression