Estudo da degradação de corante têxtil em matrizes aquosas por meio dos processos oxidativos avançados O3-H2O2/UV e foto-Fenton. / Study on the degradation of a textile dye in aqueous matrices by the oxidative processes O3-H2O2/UV and photo-Fenton.

AUTOR(ES)
DATA DE PUBLICAÇÃO

2009

RESUMO

The textile industry generates large volumes of wastewater with high organic load, strong coloration and toxicity. In this work, the treatment of an aqueous solution containing the dye Solophenyl Yellow Arle 154% was studied by the O3-H2O2/UV and photo-Fenton processes, in order to evaluate the responses color removal after 5 minutes; color removal after 60 minutes; maximum rate of color removal; and TOC removal after 60 minutes. The experiments were carried out in the semi-batch mode with circulation using a photochemical reactor with annular coaxial radiation field, consisting of a cylindrical stainless steel support with an aluminum internal reflector with 12 lamps fixed symmetrically in the internal reflecting surface, and a quartz tube reactor of 0.7 L, positioned vertically along the axis of the reflector. For the O3- H2O2/UV process, Phillips TUV lamps (36 W, 254 nm) were used; the gas stream containing zone was introduced into the reactor through a diffuser. For the photo- Fenton process, Sylvania lamps (12 W each, 300 - 400 nm) and a concentration of Fe (II) of 0.25 mmol/L were used. In both cases, the hydrogen peroxide solution was added in the first 30 minutes of treatment. The samples were analyzed by the measurement of total organic carbon (TOC) and color removal (absorbance measured at 405 nm in a UV-visible spectrophotometer). In both cases the Doehlert experimental design was used, defining the minimum and maximum values of each variable adopted. In the case of O3-H2O2/UV process (PHASE I), the effects of the total electric power of the lamps (144 - 432 W), H2O2 concentration (5 - 30 mmol/L), initial dye concentration (20 - 100 mg/L), ozone concentration (10 - 40 mg/L), and pH (3 - 10) were studied. For the photo-Fenton process, the studied variables were: total electric power of the lamps (160 - 480 W), H2O2 concentration (5 - 30 mmol/L), and initial dye concentration (20 - 100 mg/L). The results of PHASE I indicated that the increase of dye concentration in acidic conditions increases color removal after 5 and 60 minutes, thus suggesting the efficiency of molecular ozone action upon the chromophore group of the dye. The best results showed color removal above 95% after 5 and 60 minutes of treatment. However, for the TOC removal the process was not efficient, with maximum removal after 60 minutes of only 35.6%. In PHASE II less satisfactory results for color removal were obtained in comparison with PHASE I (56.1% after 5 minutes and 78% after 60 minutes of treatment), but with higher TOC removal after 60 minutes, achieving over 45.1%. The highest color removal rates were observed within the first 5 minutes of treatment for all runs. Additional experiments carried out in PHASE III showed that the oxidation by O3 followed by the photo-Fenton process enabled to achieve suitable results for both color (97.2%) and TOC removals (69.5%). The study of the O3 process in the continuous mode and a preliminary economic evaluation suggests a high potential for the use of the integrated O3-photo-Fenton process in textile industries.

ASSUNTO(S)

color removal fhoto-fenton descoloração efluentes indústria têxtil foto-fenton total organic carbon advanced oxidation processes o3-h2o2/uv ozone carbono orgânico total aops o3-h2o2/uv poas azo dyes corantes diretos processos oxidativos avançados corantes azo corantes têxteis dyehouse wastewater direct dyes ozônio remoção de cor textile dyes

ACESSO AO ARTIGO

Documentos Relacionados