Elaboração de filmes biodegradáveis a partir do resíduo da extração do pigmento de Cúrcuma / Development of biodegradable films from the residue of the extraction of the pigment from turmeric.

AUTOR(ES)
FONTE

IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia

DATA DE PUBLICAÇÃO

04/10/2012

RESUMO

This work aimed to study the potential of the bran residue obtained from the extraction of the pigment from turmeric (Curcuma longa L.) in the preparation of biodegradable films. The extraction of the turmeric dye was conducted by Soxhlet procedure in orer to simulate the industrial process. Two types of solvents were employed ethanol isopropanol (1:1) and methanol acetone (1:1). The pies were crushed and sieved in an attempt to isolate the starch, but no success was achieved. However, this process yielded different fractions, which ensured better characterization of the material. The fractions were divided into 80 (F1), 200 (F2), 270 (F3) and 400 (F4) mesh subfractions and centrifuged (F5). The analysis of pies and turmeric fraction were characterized by chemical composition, SEM, XRD and spectroscopy. Films were prepared from these fractions by film casting methodology, and were characterized by SEM, X-ray diffraction and FTIR analysis; they were also analyzed in terms of their antioxidant, mechanical, water solubility, moisture permeability, and water vapor properties. The films prepared from fractions (methanol: acetone) showed better mechanical and barrier properties than those prepared from the fractions (ethanol: isopropanol), but industrially the solvent used for the extraction of pigment is ethanol: isopropanol. Thus, the film prepared from fractional FE2 (200 mesh) (ethanol: isopropanol) which have the best mechanical and barrier properties than the films prepared from fractions from FE3 and FE5, was chosen for the optimization of the preparation of these films. To this end, we developed an experimental design 22 with four axial points and three focal points, for evaluation of the effect of the heating temperature (Ta) and the filmogenic solution pH on the mechanical properties, moisture, solubility, and permeability to water vapor of the films plasticized with glycerol (22 g fraction glycerol/100 g) and sorbitol (30 g sorbitol/100 g fraction). Results were examined by using response surface methodology and analysis multi-response analysis. The optimum conditions for attainment of films with better mechanical properties and functional characteristics were: T = 84.7 º C and pH 8.3 for films with glycerol, and T = 87.6 ° C and pH 8.5 for films with sorbitol. Compared to films plasticized with sorbitol, the films containing glycerol, had lower crystallinity index, lower content of curcuminoids as verified by HPLC analysis and DPPH. The turmeric bran films plasticized with sorbitol were more resistant, less elongated, and slightly permeable to water vapor compared to films prepared with glycerol.

ASSUNTO(S)

casting cúrcuma curcumin film biodegradable filmes biodegradáveis glicerol sorbitol starch turmeric

ACESSO AO ARTIGO

Documentos Relacionados