Effect of heat treatment on microstructures and mechanical properties in a full lamellar PM TiAl alloy
AUTOR(ES)
Su, Meike, Lang, Zebao, Zheng, Lijing, Yan, Jie, Guan, Kai, Zhang, Hu
FONTE
Materials Research
DATA DE PUBLICAÇÃO
07/06/2012
RESUMO
The effect of heat treatment on the microstructures and tensile properties of a powder metallurgical (PM) TiAl based alloy has been investigated in this paper. The near gamma (NG) microstructure is transformed to a full lamellar (FL) microstructure with an average grain size of 100 μm by heat treatments. The lamellar spacing of FL structure decreases with the increase of cooling rate. For cooling rates of 5, 10 and 50 °C/min, the lamellar spacing is 1.9, 1.0 and 0.8 μm respectively. The room temperature tensile properties exhibit an increasing trend with decrease of lamellar spacing.
Documentos Relacionados
- Effect of heat treatment on some mechanical properties of 7075 aluminium alloy
- PM versus IM Ti-5Al-5V-5Mo-3Cr Alloy in Mechanical Properties and Fracture Behaviour
- Effect of Extrusion and Heat Treatment on Microstructure and Mechanical Properties of Hypereutectic A390-0.3wt%Nd Alloy
- Synthesis, Characterization and Dry Sliding Wear Behavior of In-situ Formed TiAl3 Precipitate Reinforced A356 Alloy Produced by Mechanical Alloying Method
- Effect of experimental heat treatment on mechanical properties of resin composites
