Analog Digital Converters
Mostrando 1-12 de 13 artigos, teses e dissertações.
-
1. An automatic gain control circuit to improve ECG acquisition
Abstract Introduction Long-term electrocardiogram (ECG) recordings are widely employed to assist the diagnosis of cardiac and sleep disorders. However, variability of ECG amplitude during the recordings hampers the detection of QRS complexes by algorithms. This work presents a simple electronic circuit to automatically normalize the ECG amplitude, improving
Res. Biomed. Eng.. Publicado em: 30/11/2017
-
2. Dispositivo para medir tiempo y temperatura usando un microcontrolador
In this paper a device of data acquisition with low cost and easy management was developed for using in experiments of physics where time or temperature measurement is required. The device is composed by three main parts: (i) sensors to measure the physical variables of time and temperature; (ii) a data acquisition card with microcontroller to manage command
Rev. Bras. Ensino Fís.. Publicado em: 27/11/2017
-
3. TÉCNICAS PARA REDUÇÃO DE CONSUMO EM CONVERSORES ANALÓGICO-DIGITAIS POR APROXIMAÇÃO SUCESSIVA E COMPARTILHAMENTO DE CARGA / TECHNIQUES FOR POWER REDUCTION IN SUCCESSIVE APPROXIMATION CHARGE SHARING ANALOG-TO-DIGITAL CONVERTERS
As novas tendências e tecnologias emergentes motivam o projeto de conversores analógico-digitais (ADCs) que precisam suprir especificações cada vez mais restritivas. Nesse contexto, uma métrica de projeto que é constantemente forçada em direção à redução é o consumo de potência, fato esse que leva à concepção de melhorias tanto em nível arq
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 16/03/2012
-
4. Sistema integrado para caracterização automática de conversores analógico-digitais / Integrated system for automated characterization of analog-digital converters
Este trabalho descreve um sistema constituído de diversos instrumentos, que se encontram interligados e gerenciados por um aplicativo de software, implementando um ambiente compacto para a caracterização de conversores analógico-digitais, de acordo com os procedimentos descritos nas normas IEEE 1057-1994 e IEEE 1241-2000. O sistema desenvolvido possui li
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 31/05/2010
-
5. Projeto de um conversor analógico-digital para um receptor Bluetooth em tecnologia CMOS. / Analog to digital converter design for a Bluetooth receiver in CMOS technology.
In this work, an Analog to Digital Converter (ADC) fulfilling the Bluetooth standard specifications is designed. This block stays at the reception side of an integrated wireless transceiver in CMOS technology. Initially, an analysis of the ADC as a system is carried out, at the same time that the specifications at that level are developed. The architecture a
Publicado em: 2010
-
6. Controle automatico eletronico de ganho com supressão de transientes aplicado a EDFAs em redes opticas WDM / Eletronic automatic gain control with transient suppresion applied over WDM optical networks
IIn WDM optical communication systems erbium doped fiber amplifiers (EDFA) have an essential function, enabling amplification of simultaneous channels independently of transmit rate. The majority of current WDM systems use point to point configuration operating with a fixed number of channels over the optical link. However, the new generation optical systems
Publicado em: 2008
-
7. Controle vetorial de velocidade de um motor de indução trifásico com estimação neural de fluxo
This work describes the study and the implementation of the speed control for a three-phase induction motor of 1,1 kW and 4 poles using the neural rotor flux estimation. The vector speed control operates together with the winding currents controller of the stator phasis. The neural flux estimation applied to the vector speed controls has the objective of com
Publicado em: 2008
-
8. Mixed-signal analog-digital circuits design on the pre-diffused digital array using trapezoidal association of transistors
The mixed-signal and analog design on a pre-diffused array is a challenging task, given that the digital array is a linear matrix arrangement of minimum-length transistors. To surmount this drawback a specific discipline for designing analog circuits over such array is required. An important novel technique proposed is the use of TAT (Trapezoidal Association
Publicado em: 2007
-
9. Quaternary digital to analog converter / Conversor digital quaternario para analogico
In this work is presented the multiple value logic as option to substitute or to be used as interface with the binary logic. The multiple value logic differs of the classic binary logic to the fact that its digits are beyond zeros and ones. Using the multiple logic value obtains communication in between blocks or with the external world to one chip with less
Publicado em: 2005
-
10. Desenvolvimento de um protótipo de aquisitor portátil de sinal mioelétrico / Development of a prototype of data logger to myoelectric signal
Electromyography is the study of the muscular function by the acquisition of the electric sign that the muscles produce. Most of the equipments for reception of the sEMG is bench models, in other words, they have a size that disables that the patient can carry it during the period of acquisition of the sign and it is also necessary that a connected computer
Publicado em: 2005
-
11. Um estudo sobre quantizadores reticulados via formas quadraticas extremas e taxa de distorção
O processamento e a transmissão de sinais digitais desempenham um papel dominante para os sistemas de comunicações tanto no aspecto aplicativo quanto no teórico. Sabemos, entretanto, que a maioria dos sinais produzidos são de natureza analógica ou contínua no tempo. Portanto, para um efetivo processamento digital torna-se necessário que sejam propost
Publicado em: 1990
-
12. AUTOMATED SYSTEM FOR THE READING AND ANALYSIS OF STRUCTURAL MEASUREMENTS (S.A.L.A.M.E. PROJECT) - STUDY OF THE HARDWARE / SISTEMA AUTOMÁTICO DE LEITURA E ANÁLISE DE MEDIDAS ESTRUTURAIS (PROJETO S.A.L.A.M.E) - ESTUDO DO HARDWARE
The Structural Laboratory of the Civil Engineering Departament (EGG) is present involved in designing a system for the automation of the existing system. The system measures and characteristics by moans of interest on a structural model design. Tho transducers, linked to Wheatstone bridges, to induced structurals trains imposed upon the model being studied.
Publicado em: 1967