Weibull Distribution
Mostrando 1-12 de 80 artigos, teses e dissertações.
-
1. Tadalafil-loaded PLGA microspheres for pulmonary administration: preparation and evaluation
Tadalafil, a long-acting PED-5 inhibitor, is commonly used for the treatment of pulmonary arterial hypertension (PAH). However, its efficacy and clinical application are severely limited by the poor water solubility, low bioavailability and a series adverse effects (e.g. headaches, indigestion). In this study, tadalafil was prepared and loaded into biodegrad
Braz. J. Pharm. Sci.. Publicado em: 20/12/2019
-
2. Estimativa da resistência característica à tração da madeira na direção paralela às fibras por meio de modelos probabilísticos
RESUMO Para um dimensionamento de estruturas de madeiras dentro das exigências de segurança, a resistência para determinada solicitação mecânica é calculada com base em seu valor característico, correspondente ao percentil de 5% de um determinado modelo de distribuição de probabilidades. A norma brasileira NBR 7190 [1] estabelece, para pequenas amo
Matéria (Rio J.). Publicado em: 25/11/2019
-
3. Weibull distribution and dynamics of germination of Rangpur lime seeds at different temperatures
Resumo: O limão-cravo é o porta-enxerto mais utilizado no Brasil e sua propagação ocorre por meio de sementes. Atualmente nas prescrições das Regras de Análise de Sementes não há metodologia descrita para realização do teste de germinação de limão-cravo. Dessa forma, o objetivo foi estudar a dinâmica da germinação em sementes de limão-cravo
J. Seed Sci.. Publicado em: 09/09/2019
-
4. Modeling of probability in obtaining intensity-duration-frequency relationships of rainfall occurrence for Pelotas, RS, Brazil
RESUMO Com base em séries históricas, para cada localidade, equações podem caracterizar a relação entre a intensidade, duração e frequência de ocorrência de precipitação pluvial. Objetivou-se apresentar duas equações para a localidade de Pelotas, RS, no período de 1982-2015, uma denominada convencional e outra híbrida, dependendo do modelo pr
Rev. bras. eng. agríc. ambient.. Publicado em: 10/07/2019
-
5. Microstructure and Weibull distribution of rupture strength of clay-talc ceramics
Resumo As propriedades mecânicas das cerâmicas de argila-talco contendo 0 a 10% em massa de talco sinterizadas a 1100 °C foram obtidas por medidas de flexão. Com o valor médio de resistência à flexão de 23,1 MPa, a amostra com 5% de talco (G5) foi a mais forte e apresentou o menor valor de poro interconectado (64%). A dispersão dos valores de resist
Cerâmica. Publicado em: 06/06/2019
-
6. Aplicação da Distribuição Nakagami na Análise de Dados de Precipitação
Resumo Este trabalho teve como objetivo avaliar o desempenho da distribuição Nakagami na análise de séries de precipitação mensal, ao longo de vários anos, visando à seleção de uma distribuição útil para o planejamento e gestão de atividades dependentes dos índices de precipitação na Região Sul do Brasil. Para tanto, compara-se a mesma com
Rev. bras. meteorol.. Publicado em: 30/05/2019
-
7. Fatigue Failure Analysis on Precracked 304 Stainless Steel Components Repaired by Laser with Addition of Nanocomposites
Abstract The service life of components can be extended by repairing fatigue crack with laser so as to improve resource utilization rate. However, the effect of laser repair may be influenced by the instability of laser treatment. To investigate the addition of nanocomposites on the laser repairing effect, fatigue test under uniaxial tension was carried out
Soldag. insp.. Publicado em: 16/05/2019
-
8. A new class of lifetime models and the evaluation of the confidence intervals by double percentile bootstrap
Abstract: In this paper, we introduce a new three-parameter distribution by compounding the Nadarajah-Haghighi and geometric distributions, which can be interpreted as a truncated Marshall-Olkin extended Weibull. The compounding procedure is based on the work by Marshall and Olkin 1997. We prove that the new distribution can be obtained as a compound model w
An. Acad. Bras. Ciênc.. Publicado em: 08/04/2019
-
9. Dynamics of Eucalyptus Diameter Distribution in the State of Minas Gerais
ABSTRACT The aim of this study was to evaluate the effects of age, site, and density factors on the dynamics of eucalyptus diameter distribution. Data were obtained from a continuous forest inventory measured at different occasions, stratified according to the factors evaluated and adjusted by the three-parameter Weibull function using nonthinned clonal plo
Floresta Ambient.. Publicado em: 04/04/2019
-
10. ESTIMATION OF THE CHARACTERISTIC VALUE OF WOOD STRENGTH
ABSTRACT For safety reasons, wood strength values, essential for structural dimensioning, are calculated based on the characteristic value, which corresponds to the 5% percentile of a given probability distribution model. For small samples, the Brazilian normative document ABNT NBR 7190 establishes an estimator of the characteristic wood strength, which can
Eng. Agríc.. Publicado em: 2019-02
-
11. Prediction System for Diameter Distribution and Wood Production of Eucalyptus
ABSTRACT The aim of the present study was to propose a prediction system to estimate the diameter distribution and wood production in unthinned eucalyptus clone plantations. Data was obtained from permanent sample units, with ages from 28 to 78 months. The Weibull distribution was used to estimate the frequency of the number of trees per diameter class. Mod
Floresta Ambient.. Publicado em: 26/07/2018
-
12. Size Effects on Fracture Parameters of High Alumina Refractories
The randomness of phase compositions and their distribution as well as the micro cracks and pores in refractories result in the dependence of mechanical properties on the sample size. In this work, the size effects on fracture parameters including bending strength, elastic modulus and fracture toughness of high alumina bricks were investigated by testing sam
Mat. Res.. Publicado em: 10/07/2018