Thermal
Mostrando 1-12 de 6575 artigos, teses e dissertações.
-
1. Catalysts Derived from Thermal Treatments of Hydrocalumite-Type Compounds: Synthesis and Application in Transesterification Reactions
Catalyst performance is a relevant factor in biodiesel production because it can affect the efficiency of the process. This work provides a study of the performance of heterogeneous catalysts for biodiesel production derived from thermal-treated hydrocalumite-type compounds. This work aimed to synthesize and characterize hydrocalumite-type compounds intercal
Journal of the Brazilian Chemical Society. Publicado em: 2023
-
2. Tailoring the properties of Y2O3 via synthesis parameters varied during the PVA-assisted sol-gel route
Abstract The effect of synthesis parameters on the microstructural behavior and morphology during the yttrium oxide (Y2O3) formation is reported. Y2O3 crystals were produced by a modified sol-gel route assisted by polyvinyl alcohol solution varying the calcination temperature and solution pH. The crystalline phase formation was investigated using X-ray powde
Cerâmica. Publicado em: 2023
-
3. Study of rhombohedral tricalcium phosphate in hexagonal crystal structure family on the sample prepared by the sol-gel route and the effect of calcination temperature
Abstract The effect of the calcination temperature at 800 and 1000 °C on the stable formation of the tricalcium phosphate with rhombohedral structure in the system of the hexagonal crystal family was determined, while its precursor was made from limestone obtained from nature in the Lumajang district, Indonesia. The rhombohedral tricalcium phosphate samples
Cerâmica. Publicado em: 2023
-
4. Bioactive SiO2-K2O-CaO-P2O5 glass-ceramic scaffold prepared using polyurethane foam template
Abstract A glass-ceramic in the SiO2-K2O-CaO-P2O5 quaternary system was prepared by substituting the Na2O component with K2O to avoid Na2Ca2Si3O9 formation upon thermal treatment since this phase decreases apatite formation kinetics on glass material. To form the glass-ceramic, a modified sol-gel method involving solution precipitation, followed by reagents
Cerâmica. Publicado em: 2023
-
5. Efficient Encapsulation and Controlled Release of N,N-Diethyl-3-methylbenzamide (DEET) from Oil-in-Water Emulsions Stabilized by Cationic Nanocellulose and Silica Nanoparticles
Oil-in-water emulsions containing N,N-diethyl-3-methylbenzamide (DEET) were developed aiming to extend the sustained release of the active compound, by using two oppositely charged nanomaterials, namely silica nanoparticles (SiNP) and cationic cellulose nanofibrils (CCNF), as stabilizers, and a mixture of food-grade nonionic surfactants to avoid precipitatio
Journal of the Brazilian Chemical Society. Publicado em: 2023
-
6. Thermal characterization of soil-cement bricks using mining tailings
Abstract Soil-cement bricks are earth construction materials that have been gaining prominence due to their environmental advantages. The Brazilian Technical Standard NBR 8491 establishes physical and mechanical procedures to characterize these bricks. However, the thermal characterization is an important assessment, since it is related to the building’s t
REM - International Engineering Journal. Publicado em: 2022
-
7. Hydroponic cultivation of coriander intercropped with rocket subjected to saline and thermal stresses in the root-zone
ABSTRACT An experiment was carried out in a randomized blocks design, aiming at evaluation of the cultivation of coriander intercropped with rocket subjected to saline and thermal stresses in the root-zone. Six treatments were evaluated, as follows: four treatments consisted of the combinations of two levels of electrical conductivity of water (ECw 0.3 and 6
Revista Ceres. Publicado em: 2022
-
8. Study of nanocomposites with carbon nanotubes and their tendency for carbon organization
Abstract The carbon derived from the thermal treatment of modified phenolic resins (PR) tends to organize into graphitic lamellae or turbostratic carbon and is commonly considered non-graphitizable. In this study, nanocomposites were synthesized with modified phenolic resin (Novolac) used as the matrix and oxidized multi-walled carbon nanotubes (NTox) in amo
Cerâmica. Publicado em: 2022
-
9. Radiação térmica e a fórmula de Planck
In this paper, theoretical and experimental research on blackbody thermal radiation is discussed and historically ordered. The main thermal radiation equations following Planck’s revolutionary idea are obtained using the formalism of statistical mechanics. These equations, already well known, are deduced in a very detailed and didactic way in order to faci
Química Nova. Publicado em: 2022
-
10. Properties and technical characteristics of Casira pottery, Jujuy, Argentina
Abstract In this work, the results of a multi-technique characterization of a type of pottery production with high cultural and economic relevance from the only potter town in Argentina are presented and correlated. Raw materials, a prepared paste, and ceramic samples were studied. Chemical, structural, textural, microstructural, and thermal features were as
Cerâmica. Publicado em: 2022
-
11. Post-Occupancy Evaluation of an educational building: Case study of the ETS-UESC Building
Abstract The physical and environmental conditions of educational institutions are determining factors for occupant comfort. The Post-Occupancy Evaluation (POE) presents itself as a methodology for verifying environmental aspects in full use, considering the technical criteria and the users' perception. This article discusses the particularities of the ETS-U
REM - International Engineering Journal. Publicado em: 2022
-
12. Quality Control for Lignin and Gelatin Microcapsules Loaded with Orange Essential Oil
Sustainable natural product-based microstructured systems and biopolymers are strong candidates for use in crop protection. Lignin and gelatin microcapsules loaded with orange essential oil were developed with spray-drying in order to enhance its potential. We evaluated the microparticle controlled release mechanisms, biological effects, structural and therm
Journal of the Brazilian Chemical Society. Publicado em: 2022