Pull System
Mostrando 1-12 de 91 artigos, teses e dissertações.
-
1. Fixation of the Anterior Ligament Graft at the Tibial Pole: Biomechanical Analysis of Three Methods
Resumo Objetivo Análise biomecânica comparativa da resistência da fixação tibial para reconstrução ligamentar com parafuso de interferência, comparada com parafuso do tipo poste com arruela, e com fixação associada entre os métodos (fixação híbrida). Métodos Foram utilizados 54 corpos de prova (tíbia suína e tendão digital bovino), que fo
Rev. bras. ortop.. Publicado em: 13/12/2019
-
2. An Anchorage System for Enhanced Bond Behavior between Carbon Fiber Reinforced Polymer Sheets and Cracked Concrete
Abstract The contribution of CFRP wraps, as an anchorage system, to enhancing bond behavior between CFRP sheet and cracked concrete, was investigated. Thirty six concrete blocks (150 x 150 x 200 mm) were cast with 3ϕ12 mm steel bars embedded laterally at different spacing along the 200-mm-dimension. Half of the moist-cured blocks were subjected to a cyclic
Lat. Am. j. solids struct.. Publicado em: 05/09/2019
-
3. Caracterización de resinas epoxi para uso en conectores de ductos flexibles
ABSTRACT In the offshore productions of gas and oil are frequently used flexible pipes. The end fitting is the connection between the flexible pipe body and the production unit, at the assembly of this component is used epoxy resin to fill the free space inside it. This polymeric material holds the tensile armor wires to form the anchoring system. A critical
Matéria (Rio J.). Publicado em: 19/07/2018
-
4. Influencia de la temperatura en ensayos de arrancamiento sobre diferentes sistemas epoxi-acero de uso en conectores de ductos flexibles
ABSTRACT In the offshore oil fields located in deep and ultra-deep waters they are used flexible pipes. In many cases inside these pipes, the hydrocarbons are transported at elevated temperatures. At the ends of the flexible pipes are installed end fittings, these are the connection with sea platforms and different subsea systems. In the assembly of end fitt
Matéria (Rio J.). Publicado em: 19/07/2018
-
5. Experimental Study of the Compressive Strength of Multi-Coat Renders
Mortar compressive strength is a standard requirement and should be tested on stand-ardized specimens with a 40 mm square cross section. However, these specimens with only one type of mortar (base-coat layer) do not represent the render traditionally ap-plied to façades since that must consist of at least two layers (base coat and top coat, with different f
Mat. Res.. Publicado em: 13/07/2017
-
6. Modeling the pull-in instability of the CNT-based probe/actuator under the Coulomb force and the van der Waals attraction
Carbon nano-tube (CNT) is applied to fabricate nano-probes, nano-switches, nano-sensors and nano- actuators. In this paper, a continuum model is employed to obtain the nonlinear constitutive equation and pull-in instability of CNT-based probe/actuators, which includes the effect of electrostatic interaction and intermolecular van der Waals (vdW) forces. The
Lat. Am. j. solids struct.. Publicado em: 2014-12
-
7. Dynamic pull-in instability of geometrically nonlinear actuated micro-beams based on the modified couple stress theory
This paper investigates the dynamic pull-in instability of vibrating micro-beams undergoing large deflection under electrosatically actuation. The governing equation of motion is derived based on the modified couple stress theory. Homotopy Perturbation Method is employed to produce the high accuracy approximate solution as well as the second-order frequency-
Lat. Am. j. solids struct.. Publicado em: 2014-10
-
8. Modeling the size dependent pull-in instability of beam-type NEMS using strain gradient theory
It is well recognized that size dependency of materials characteristics, i.e. size-effect, often plays a significant role in the performance of nano-structures. Herein, strain gradient continuum theory is employed to investigate the size dependent pull-in instability of beam-type nano-electromechanical systems (NEMS). Two most common types of NEMS i.e. nano-
Lat. Am. j. solids struct.. Publicado em: 2014
-
9. Sistema Fotovoltaico de Pequeno Porte Interligado à Rede ElÃtrica / A Low Power, Grid-Connected Photovoltaic System
A necessidade de obter uma matriz energÃtica menos poluente e em harmonia com o meio ambiente à um tÃpico muito importante no sÃculo XXI. Este trabalho apresenta um conversor cc-ca de dois estÃgios para injetar a energia de um arranjo de painÃis fotovoltaicos à rede elÃtrica. O primeiro estÃgio à um conversor elevador, isolado, baseado na CÃlula d
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 02/03/2012
-
10. O interactoma de Stanniocalcina-1 humana sugere novas funções e vias de atuação celulares / The interactome of human Stanniocalcin-1 suggests new cellular functions and pathways
O objetivo deste projeto foi estudar genes ativados em células do estroma da medula óssea, induzidos pela co-cultura com blastos leucêmicos, na tentativa de uma melhor compreensão sobre o crostalk entre estas células no microambiente tumoral. Nós identificamos Stanniocalcina-1 (STC1) como um potencial marcador molecular do microambiente tumoral, uma ve
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 19/08/2011
-
11. Avaliação da aderência entre o concreto e o sistema de reforço com fibra de carbono / Evaluation of the adhesion between concrete and strengthening system with carbon fiber
O reforço de estruturas de concreto armado ou protendido têm sido necessário na construção civil devido às falhas causadas por erros em projetos e execuções de obras, corrosões de armaduras, reabilitação após incêndios ou mudanças na utilização das estruturas projetadas. Os métodos convencionais para reforço de estruturas de concreto estão
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 01/04/2011
-
12. Banco de sementes e sistemas de renovação no pasto de capim-braquiária com integração de culturas agrícolas / Seed bank in renewal of pasture signal grass with crop livestock integration
The experiment was conducted to evaluate the renewal of pasture of Brachiaria decumbens with integration of crops in cropping systems "planting" direct and conventional. The experiment was conducted in pastures of Brachiaria decumbens Stapf. Located on the campus of University Federal of Viçosa, Viçosa, MG. The experiment consisted of five "systems" of gra
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 22/02/2011