Process Simulation
Mostrando 1-12 de 994 artigos, teses e dissertações.
-
1. Modeling and Computer Simulation of Viscoelastic Crypt Deformation
ABSTRACT Colorectal cancer morphogenesis begins at the cellular level from cell mutations in the intestinal epithelium cavities called crypts. These mutations lead to a pressure difference in the epithelium crypt walls, which can cause deformation and generate visible abnormalities in the epithelium. The geometrical modeling of these crypts and the mathemati
Trends in Computational and Applied Mathematics. Publicado em: 2022
-
2. Semi-analytical Equations for Designing Terahertz Graphene Dipole Antennas on Glass Substrate
Abstract Semi-analytical equations are developed for aiding the process of designing terahertz graphene-based rectangular dipole antennas lying on glass substrates. It directly provides the dipole length required for obtaining resonance at a desired frequency since antenna width and graphene chemical potential are known. By using the finite-difference time-d
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2022
-
3. Editorial Comment: Development and validation a task-specific checklist for a microsurgical varicocelectomy simulation model
ABSTRACT Introduction: Transverse preputial island flap urethroplasty (TPIFU) is one of the most frequently performed technique for single-stage repair in proximal hypospadias. It was reported that the subepithelial urethroplasty would obviously decrease urethrocutaneous fistula (UF) complication after proximal TIP. But in the process of TPIFU, it had not b
Int. braz j urol.. Publicado em: 2020-10
-
4. Comparison between traditional project appraisal methods and uncertainty analysis applied to mining planning
Abstract Long-term mining planning is a complex process which involves a large number of variables and uncertainties. Traditional discount cash flow (DCF) is usually used in the evaluation of mining projects. DCF includes net present value (NPV), internal rate of return (IRR), and profitability index (PI). A sensitivity analysis is usually carried out to eva
REM, Int. Eng. J.. Publicado em: 2020-06
-
5. FUZZY SLIDING-MODE TEMPERATURE-CONTROL SYSTEM FOR SOAKING AND GERMINATION OF RICE SEEDS
ABSTRACT The soaking and germination process of rice seeds is the starting point in rice cultivation in cold regions and has a significant effect on grain yield. Efficient techniques for controlling the water temperature in the seed tank are required to enhance germination quality. This paper introduces a fuzzy theory for designing a fuzzy logic-based slidin
Eng. Agríc.. Publicado em: 2020-04
-
6. Arantes ACQ. A morte é um dia que vale a pena viver. Alfragide, Portugal: Oficina do livro; 2019.
ABSTRACT The soaking and germination process of rice seeds is the starting point in rice cultivation in cold regions and has a significant effect on grain yield. Efficient techniques for controlling the water temperature in the seed tank are required to enhance germination quality. This paper introduces a fuzzy theory for designing a fuzzy logic-based slidin
Ciênc. saúde coletiva. Publicado em: 2020-04
-
7. PREPARATION AND SIMULATION OF THE ON-LINE SiO2/S COATING FOR COKING INHIBITION IN THE INDUSTRIAL CRACKING FURNACE
Abstract Coke formation inside radiant coils is one of the main problems during thermal cracking of hydrocarbons. The on-line preparation of the coating for coking inhibition is a promising technology because it provides more flexibility to the operators on site. The SiO2/S coating was prepared on the inner surface of coils in an 8-year-served GK-VI industri
Braz. J. Chem. Eng.. Publicado em: 13/01/2020
-
8. ANALYSIS OF THE BASELINE DRIFT ARTIFACT IN HADAMARD TRANSFORM SEPARATION TECHNIQUES
The baseline drift artifact (BDA), namely, the baseline bias between the Hadamard transform (HT) spectrum and the signal averaging (SA) spectrum was unfortunately found in the HT pulsed separation techniques, which makes the HT analytical chemistry face the challenge of non-stability and unreliability. In order to find out the origin and eliminate the BDA ph
Quím. Nova. Publicado em: 2020-01
-
9. 3D numerical investigation of mixture formation and combustion in a DISI engine at part-load under stratified operation
This work investigates through numerical simulation, the operation of a big bore direct fuel injection spark ignition engine, at part load under stratified operation. It evaluates fuel-air mixture preparation and combustion process with the adoption of detailed chemical kinetics mechanisms for both Isooctane and Ethanol, and applying adaptive mesh refinement
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2020
-
10. Scheduling optimum planting window for gladiola based on El Niño Southern Oscillation
ABSTRACT: Gladiola is an important cut flower worldwide and scheduling field gladiola production is largely dependent on planting at the correct time since its development is controlled by the air temperature. The aim of this study was to configure a planting window of gladiola in order to harvest spikes to be sold on All Souls' Day and Mother's Day holidays
Sci. agric. (Piracicaba, Braz.). Publicado em: 20/12/2019
-
11. SUCROSE CRYSTALLIZATION: MODELING AND EVALUATION OF PRODUCTION RESPONSES TO TYPICAL PROCESS FLUCTUATIONS
Abstract This work describes a phenomenological model of the two-massecuite system for sucrose crystallization, developed using EMSO software. In most Brazilian sugarcane industries, sucrose crystallization is performed using this system. This process is considered to be a fundamental step in obtaining sugar of the desired quality and accounts for a substant
Braz. J. Chem. Eng.. Publicado em: 09/12/2019
-
12. AN INVESTIGATION OF THE HEAT TRANSFER PERFORMANCE OF DUAL IMPROVED INTERMIG IMPELLERS IN A STIRRED TANK WITH AN INNER HEATING COIL
Abstract The heat transfer process in a stirred tank of diameter T=0.5m equipped with dual-layer improved Intermig impellers and helical coils was investigated by experiment and numerical simulation methods. The temperature field, the temperature boundary layer lateral to the coil and the heat transfer coefficient were measured at different rotational speeds
Braz. J. Chem. Eng.. Publicado em: 09/12/2019