Power System Signal Analysis
Mostrando 1-12 de 39 artigos, teses e dissertações.
-
1. Equipment for Monitoring Synchronous Generators Condition through External Magnetic Field Waveforms
Abstract This paper presents an equipment for monitoring synchronous generators condition through characteristics of the time derivative of the external magnetic field. The developed monitoring methodology allows the identification of established or incipient faults, by detecting changes in the magnetic signature of the synchronous generator. In this methodo
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2022
-
2. Hydraulic System Onboard Monitoring and Fault Diagnostic in Agricultural Machine
Abstract Agricultural Machinery as an off-road vehicle is the backbone of the World agricultural industry. Its main function is to operate as a prime mover and support the power requirements to function the various type of draft implements. In this regards, the hydraulic system is an important part and is controlled by the propagated oil which is cleaned by
Braz. arch. biol. technol.. Publicado em: 24/10/2019
-
3. Low cost system to measure active power in electrosurgical units
Abstract Introduction: The real-time measurement of active power delivered to patients during the electrosurgical act is still an engineering challenge. Besides, there is no electrosurgical unit on the market capable of doing it according to the normative requirement. Methods This work presents the design of an electronic structure capable to probe the ele
Res. Biomed. Eng.. Publicado em: 09/11/2017
-
4. Comparison of In-Flight Measured and Computed Aeroelastic Damping: Modal Identification Procedures and Modeling Approaches
ABSTRACT The Operational Modal Analysis technique is a methodology very often applied for the identification of dynamic systems when the input signal is unknown. The applied methodology is based on a technique to estimate the Frequency Response Functions and extract the modal parameters using only the structural dynamic response data, without assuming the kn
J. Aerosp. Technol. Manag.. Publicado em: 2016-06
-
5. Sistemas CDMA ópticos coerentes baseados em codificação de fase espectral / Coherent optical CDMA systems based on spectral phase coding
In this work we perform a comprehensive analysis of a spectral phase-encoded time spreading optical code division multiple access (SPECTS-OCDMA) system. Despite being a numerical study, efforts were concentrated on the investigation of more realistic scenarios using as much information as possible from implemented test-beds in laboratories. In this context,
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 11/12/2012
-
6. Utilização do elo de corrente continua para o amortecimento de oscilações eletromecanicas em sistemas eletricos de potencia / Use of the direct current link for the electromechanical oscillations damping in electric power systems
This dissertation presents a study about the HVDC (High Voltage Direct Current) link contribution for damping low frequency electromechanical oscillations when Electric Energy System suffers small-signal disturbances. The HVDC link components models were included in the Power Flow method as well as the steady-state characteristics of the dynamic devices (cur
Publicado em: 2009
-
7. CONTRIBUTION TO THE CONTROL OF ELECTRODYNAMIC VIBRATION MACHINES / CONTRIBUIÇÃO AO CONTROLE DE MÁQUINAS DE VIBRAÇÃO ELETRODINÂMICAS
This work presents contributions to the sinusoidal acceleration control of electrodynamic shakers applied in vibration testing. Considering the importance of sine tests to identify critical frequencies of operation and to determine mechanical weakness in the specified performance of specimens, vibration controllers are designed to reproduce the amplitude and
Publicado em: 2009
-
8. ANÁLISE DE COMPONENTES INDEPENDENTES APLICADA EM DISTÚRBIOS DE QUALIDADE DE ENERGIA
This dissertation presents the development of a technique for power quality analysis, considering the case of multiple disturbances. The purpose is to separate the disturbances that are occurring in sequence or at the same time, in voltage signals of the electric power systems. For this, is used the philosophy of blind source separation, with the assumption
Publicado em: 2009
-
9. Application of wavelet transform for power quality analysis in electric arc furnace. / Aplicação da transformada Wavelet na análise da qualidade de energia em fornos elétricos a arco.
A new method for the detection and classification of the disturbances that affect the electric power quality in industrial electric systems with electric arc furnaces was developed in this work. During the fusion process of the electric arc furnaces, may occur several events that affect the electric system to which it is inserted may occur, having as charact
Publicado em: 2008
-
10. ANÁLISE DA DINÂMICA DA ATENUAÇÃO POR CHUVAS EM REGIÕES TROPICAIS / DYNAMIC ANALYSIS OF RAIN ATTENUATION IN TROPICAL REGIONS
The main effect causing non-availability in radio communication systems operating in frequencies above 10GHz, is the rain attenuation, particularly the heavy convective rain that is predominant in tropical regions. This thesis presents a detailed study and modelling of the dynamics of rain attenuation in terrestrial links and earthspace links, based on data
Publicado em: 2008
-
11. Avaliação da acuidade visual de recém-nascidos pequenos para a idade gestacional pelos métodos do potencial visual evocado de varredura e cartões de acuidade de Teller / Evaluation of Visual Acuity in Small-for-Gestational-Age Newborns Using Sweep VEP and Teller Acuity Card Methods
Objective: To evaluate the effects of intra-uterine malnutrition on grating visual acuity (VA) using Sweep VEP and Teller Acuity Cards (TAC). Method: Binocular grating acuity was evaluated in 41 newborns with gestational age 37 weeks. Twentythree were born with appropriate weight for gestational age (AGA age: 14.3 ± 7.5 weeks) and 18 were born small for ges
Publicado em: 2008
-
12. Monitoring of operations the rectification using sensors of fusion / Monitoramento de operações de retificação usando fusão de sensores
The present study deals with an experimental analysis of a monitoring system based on a sensor fusion strategy applied to a cylindrical grinding machine. It comprises a fusion of the power and acoustic emission signals and has as main goal to obtain the FAP (Fast Abrasive Power) using the method developed by Valente (2003). Initially, the power and acoustic
Publicado em: 2007