Power Devices
Mostrando 25-36 de 257 artigos, teses e dissertações.
-
25. Improvement of power efficiency of hybrid white OLEDs based on p-i-n structures
ABSTRACT In this article, hybrid white organic light-emitting diodes (WOLEDs) under p-i-n structures have been investigated in terms of power efficiency. By using tris(8-hydroxy quinolinato) aluminum (Alq3) doped with 8-hydroxy-quinolinato lithium (Liq) as an n-type and WHI112 doped with molybdenum trioxide (MoO3) as a p-type, the typical device structure of
Matéria (Rio J.). Publicado em: 05/03/2018
-
26. New methodology for modeling, design and implementation of RF power amplifiers
Abstract This work presents a new methodology for modeling, design and implementation of power amplifiers in different technologies. As result of comparison, a flowchart with a new methodology is proposed which can be useful for the designer to design and implement power amplifiers with low, medium and high power devices in different technologies. This paper
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-09
-
27. OPTIMAL LOCATION PROBLEM FOR THE INSTALLATION OF POWER FLOW CONTROLLER
ABSTRACT In power delivery systems, the use of dispersed generation and security control to improve network utilization requires the optimal use of system control devices. The installation of loop controller allows the distribution system to operate in a loop configuration, achieving effective management of voltage and power flow. In the investment planning
Pesqui. Oper.. Publicado em: 2017-09
-
28. Evaluation of a Thermochromic Liquid Crystal for Use as a Temperature Sensor for Components of Electrical Systems
Connectors used in electrical power distribution systems should allow the passage of electricity continuously and without interruption. However, this does not always occur due to failure caused by improper assembly and/or corrosion of the materials employed, which reflects the quality of service. Notable among the new detection technologies that have been st
Mat. Res.. Publicado em: 22/05/2017
-
29. Polarization Diversity on ESM Systems
Abstract Polarization diversity antenna arrays are applied to electronic support measures (ESM) systems since the 1980s. However, even today modern systems are conceived with the employment of the traditional and inconvenient spiral antennas and there are no studies that evidences most of the benefits of this technique applied to them. This paper aims at sho
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-03
-
30. MATHEMATICAL MODELING OF THE ELECTRIC CURRENT GENERATION IN A MICROBIAL FUEL CELL INOCULATED WITH MARINE SEDIMENT
Abstract Microbial fuel cells (MFC) are electrochemical devices that utilize the ability of some microorganisms to oxidize organic matter and transfer electrons resulting from their metabolism to an insoluble acceptor. The goal of the present study was to model the kinetics of electrical current generation from an MFC inoculated with marine sediment. For thi
Braz. J. Chem. Eng.. Publicado em: 2017-01
-
31. Thermoelectric-Sourced Programmable Electronic Switching Module to Ignite Electro-Explosive Devices
ABSTRACT: A microcontroller-based programmable electronic switching module is designed and developed. For supplying power to this module, thermoelectric generators (TEGs) are electrically integrated to the switching module. This integrated switching module is carried out to develop a Thermoelectric-sourced Programmable Electronic Switching Module (TPESM), wh
J. Aerosp. Technol. Manag.. Publicado em: 2015-12
-
32. Exposure to 50 Hz electromagnetic field changes the efficiency of the scorpion alpha toxin
AbstractBackground Extremely low-frequency (50 Hz) electromagnetic field (ELF-EMF) is produced by electric power transmission lines and electronic devices of everyday use. Some phenomena are proposed as “first effects” of ELF-EMF: the discrete changes in the membrane potential and the increase of the calcium channel activity as well as the intracellular
J. Venom. Anim. Toxins incl. Trop. Dis. Publicado em: 20/10/2015
-
33. Method to Determine the Electrical Energy for Ignition of Electro-Explosive Devices
ABSTRACT: During field trials, it was observed that the delay of ignition of electro-explosive devices (EED) depends on ratings of power supplies or dynamo and also on the firing cable lengths. The change in ignition delay of EEDs due to altered supplied current will detoriate the repeatability of sequence of actions in time-critical armament applications. I
J. Aerosp. Technol. Manag.. Publicado em: 2015-09
-
34. Low-level red laser therapy alters effects of ultraviolet C radiation on Escherichia coli cells
Low-level lasers are used at low power densities and doses according to clinical protocols supplied with laser devices or based on professional practice. Although use of these lasers is increasing in many countries, the molecular mechanisms involved in effects of low-level lasers, mainly on DNA, are controversial. In this study, we evaluated the effects of l
Braz J Med Biol Res. Publicado em: 10/07/2015
-
35. Changes in irradiance and energy density in relation to different curing distances
The present study aimed to assess the influence of curing distance on the loss of irradiance and power density of four curing light devices. The behavior in terms of power density of four different dental curing devices was analyzed (Valo, Elipar 2, Radii-Cal, and Optilux-401) using three different distances of photopolymerization (0 mm, 4 mm, and 8 mm). All
Braz. oral res.. Publicado em: 2015
-
36. La ideología en la planificación normativa y la modernización neoliberal: contextos y dispositivos de poder
The productive restructuration of public hospitals in Latin America pretends to make changes in the ways in which attention and care occurs. Current productive restructuration is ideologically ensured by the displacement of the hegemonic discourses in the sector, from Normative Planning to the discourses of neoliberal modernization. In this article, the meth
Saúde debate. Publicado em: 2014-12