Polarization Curves
Mostrando 25-36 de 95 artigos, teses e dissertações.
-
25. Study and Assessment of the Efficiency of the Cocoa Bark Extracted from the Theobroma Cacao as an Inhibitor of the Corrosion of Carbon Steel in Substitution of Benzotriazole
Corrosion represents high losses to the economy, therefore, researches on the minimization of its damages in materials, mainly the metallic ones, are necessary. Among the various alternatives of protection against corrosion, there is the application of corrosion inhibitors that can minimize or even stop the corrosive process of metallic materials. However, a
Mat. Res.. Publicado em: 30/11/2017
-
26. Influence of the Tungsten Content on Surface Properties of Electroless Ni-W-P Coatings
Ternary Ni-W-P films were produced by electroless deposition using baths with different tungsten concentrations. After deposition, the coated surfaces were annealed at 400°C for 1h. Surface morphology and film composition in the as-plated condition were assessed by SEM and EDS analyses, respectively. The crystalline phases after annealing were investigated
Mat. Res.. Publicado em: 21/11/2017
-
27. Evaluation of Castor Bark Powder as a Corrosion Inhibitor for Carbon Steel in Acidic Media
The inhibition effect of castor bark powder obtained from Ricinus communis on AISI 1020 carbon steel in acidic media (HCl 0.5 mol.L-1) has been studied by electrochemical impedance spectroscopy (EIS), polarization curves, scanning vibrating electrode technique (SVET) and weight loss measurements. Fourier transform infrared spectroscopy (FTIR) and scanning el
Mat. Res.. Publicado em: 30/10/2017
-
28. Optimization of spin-coated electrodes for electrolyte-supported solid oxide fuel cells
ABSTRACT Electrodes for electrolyte-supported solid oxide fuel cells (SOFC's) were fabricated by spin coating. Strontium-doped lanthanum manganite (LSM) cathode and nickel yttria-stabilized zirconia cermet anodes were synthesized and processed for enhanced deposition conditions. The influence of electrode microstructural parameters was investigated by a syst
Matéria (Rio J.). Publicado em: 22/05/2017
-
29. Resistance to Pitting Corrosion in Steels Based on the Fe-Cr-Ni-C System
This study aimed to investigate the effects of difference in nickel content and the tempering temperatures on the corrosion resistance in 13Cr2Ni0.1C and 13Cr1Ni0.15C steels. Results showed that passive film in 13Cr2Ni0.1C steel is formed more quickly at the lowest and highest tempering temperature (650°C and 750°C) but the lowest tempering temperature (65
Mat. Res.. Publicado em: 15/05/2017
-
30. Carbon steel corrosion induced by sulphate-reducing bacteria in artificial seawater: electrochemical and morphological characterizations
ABSTRACT In this work, the corrosion behavior of carbon steel AISI 1020 was evaluated in artificial seawater in the presence of mixed sulfate-reducing bacteria (SRB) culture isolated from the rust of a pipeline. The corrosion evaluation was performed by electrochemical techniques (open circuit potential (Eocp), polarization curves and electrochemical impedan
Matéria (Rio J.). Publicado em: 2016-12
-
31. Roasted Coffee Extracts as Corrosion Inhibitors for Mild Steel in HCL Solution
The behavior of roasted coffee extract and its isolated high molecular weight fraction have been investigated as carbon steel corrosion inhibitors in HCl solution by weight loss measurements, potentiodynamic polarization curves, electrochemical impedance and scanning electron microscopy analysis. All results showed that the high molecular weight fraction, ri
Mat. Res.. Publicado em: 26/09/2016
-
32. Biofuncionalización de Ti6Al4V mediante crecimiento de nanoestructuras de TiO 2 con contenido de calcio y fósforo
ABSTRACT In this work the effect of the electrodeposition of calcium phosphate on TiO2 nanostructures was evaluated. For that, TiO2 nanostructures were developed in a solution of NH4F and NH4H2PO4 on Ti6Al4V substrates and subsequent cathodic electrodeposition was performed using Ca(NO3)2 and (NH4)2HPO4 as electrolyte. The surface morphology was observed by
Matéria (Rio J.). Publicado em: 2016-09
-
33. Comportamiento a la Corrosión del Acero API X70 Soldado por el Proceso de Doble Arco Sumergido Inmerso en Diferentes Medios Corrosivos
Abstract The steels API X70 are applied in construction and fabrication of pipeline for transport of hydrocarbons, however, to lapse time are degrade due to environment to which are exposed, influencing on mode and corrosion rate on surface base metal (BM), heat zone affected (HAZ) and fusion zone (FZ). In order to know and evaluate the corrosion susceptibi
Soldag. insp.. Publicado em: 2016-06
-
34. Use of Electrochemical Tests for Assessment of the Effect of Erosive Particle Size on the Erosion-Corrosion Behaviour of AISI 304L Austenitic Stainless Steel
The degradation of AISI 304L stainless steel under static corrosion, liquid impingement and corrosion-erosion was studied using polarization curves. Static corrosion and liquid impingement tests were performed in 3.5% NaCl solution. Corrosion-erosion tests were performed in the same solution, containing 10 wt-% of three different SiO2 particle sizes. Synergi
Mat. Res.. Publicado em: 04/03/2016
-
35. The inhibitory action of Bauhinia purpurea extracts on the corrosion of carbon steel in sulfuric acid medium
The inhibitory effect of Bauhinia purpurea (Fabaceae) extract was studied in the corrosion of carbon steel in 1.0 mol∙L-1 sulfuric acid solution. This plant was collected from the Brazilian rainforest. The carbon steel protection was observed by varying the extract concentration from 50 to 500 mg∙L-1. Polarization curves revealed that this extract acted
Mat. Res.. Publicado em: 12/02/2016
-
36. CURRENT-VOLTAGE CURVES FOR TREATING EFFLUENT CONTAINING HEDP: DETERMINATION OF THE LIMITING CURRENT
Abstract Membrane separation techniques have been explored for treating industrial effluents to allow water reuse and component recovery. In an electrodialysis system, concentration polarization causes undesirable alterations in the ionic transportation mechanism. The graphic construction of the current voltage curve is proposed for establishing the value of
Braz. J. Chem. Eng.. Publicado em: 2015-12