Plasma Heating
Mostrando 1-12 de 92 artigos, teses e dissertações.
-
1. Solventes eutéticos naturais profundos (NADES) no preparo de amostras de rocha fosfática e suplemento mineral para determinação elementar por técnicas de plasma
Natural deep eutectic solvents (NADES) based on xylitol, citric acid, and malic acid were synthesized and used in ultrasound-assisted extraction (UAE) and heating-bath extraction of phosphate rock and mineral supplement samples. Arsenic, Ca, Cd, Cr, Cu, Fe, K, Mg, Mn, Na, P and Zn were determined by inductively coupled plasma mass spectrometry (ICP-MS) and i
Quím. Nova. Publicado em: 2021-06
-
2. Acrylamide reduces plasma antioxidant vitamin levels in rats due to increased oxidative damage
RESUMO Objetivo A acrilamida é um químico potencialmente neurotóxico e carcinogênico, sendo naturalmente criada durante o processo de aquecimento de alimentos ricos em carboidratos, como batatas fritas e cereais matinais. Dado que o composto pode ser ingerido através do consumo de alimentos, o presente trabalho teve por objetivo investigar o seu efeito
Rev. Nutr.. Publicado em: 17/01/2020
-
3. The Surface Treatment of Niobium Superconducting Reentrant Cavities by Means of High Temperature Nitrogen Plasma Based Ion Implantation
High Temperature Nitrogen Plasma Based Ion Implantation (HT-NPBII) has been used to treat the surface of niobium superconducting reentrant cavities, which are part of parametric transducers in a resonant-mass gravitational wave detector. The aim is to enhance the corresponding electrical quality factors (Q-factors) which are closely related with the increase
Mat. Res.. Publicado em: 13/12/2019
-
4. Surface, microstructural, and adhesion strength investigations of a bioactive hydroxyapatite-titanium oxide ceramic coating applied to Ti-6Al-4V alloys by plasma thermal spraying
Ti-6Al-4V alloy is employed in implants because of its good mechanical strength, excellent biocompatibility, and good resistance to corrosion in biological environments. Herein, a composite (HAp-TiO2, 50% by volume of both components) coating surface employing Ti-6Al-4V was characterized. Samples were analyzed post fabrication and post heat treatment to anal
Mat. Res.. Publicado em: 28/05/2018
-
5. Microstructural and Electrochemical behaviour of Aluminium Alloy Composites Produced Using Different Sintering Techniques
Present research work analyses the effect of heating modes on the densification, microstructure and mechanical properties of aluminum alloys [65Al-20Cu-15Mn] fabricated through powder metallurgy route. Sintering of compacts using conventional, microwave and spark plasma sintering methods has been carried out at 525°C. From the results, it has been observed
Mat. Res.. Publicado em: 12/03/2018
-
6. Spark Plasma Sintering of a Hard Metal Powder Obtained from Hard Metal Scrap
Spark plasma sintering is used to consolidate a WC-Co powder produced from milled discharged hard metal cutting inserts. The powder was mixed to 10%wt Co powder and spark plasma sintered (SPS) under 80Mpa pressure, at 1200ºC with heating rate of 160ºC/min. A reference alloy was prepared with a commercial WC powder and 10%wt. Co under the same conditions. T
Mat. Res.. Publicado em: 13/03/2017
-
7. Method Development and Total Uncertainty Estimation for Boron, Sulfur and Phosphorus Determination in Mineral Fertilizer Using ICP OES
This study deals with B, S, and P determination in mineral fertilizer and S in commercial sulfur-formulation using inductively coupled plasma optical emission spectrometry. According to multivariate optimization using a Doehlert matrix, the analytes extraction in fertlizer can be conducted in open flask and heating on hot plate or in closed flask in microwav
J. Braz. Chem. Soc.. Publicado em: 2016-11
-
8. DETERMINAÇÃO SIMULTÂNEA DE METAIS E ENXOFRE POR ICP-OES EM RESÍDUOS DE DESTILAÇÃO DE PETRÓLEO
A method for digestion of crude oil distillation residues (atmospheric residue, AR and vacuum residue, VR) using microwave-induced combustion (MIC) was developed for simultaneous determination of metals (Ba, Co, Fe, Mg, Mn, Ni and V) and sulfur by inductively coupled plasma optical emission spectrometry (ICP-OES). Samples were wrapped in polyethylene films a
Quím. Nova. Publicado em: 2016-11
-
9. Evaluating the "Tape Tea" Myth as Low Cost Abuse Drug through Mass Spectrometry
The role of the "tape tea" as a low cost abuse drug is evaluated, by searching for possible inorganic and organic compounds after its preparation. Two energy sources are evaluated (conventional and microwave heating) for preparing the "tape tea" using new or used cassette (K7) or video home system (VHS) tapes. After optimizing all the inductively coupled pla
J. Braz. Chem. Soc.. Publicado em: 2016-10
-
10. Pressurized Flow Solubilization System Using Electromagnetic Induction Heating Technique for Simultaneous Determination of Inorganic Elements (Ba, Ca, Cd, Cu, Fe, Mg, Mn, Na, Pb, Sr, Zn) in Sonicate Slurries of Biological Materials by Microwave Induced Plasma Optical Emission Spectrometry (MIP-OES)
A pressurized continuous flow system using electromagnetic induction heating technique has been developed for the determination of trace and minor element content in biological samples by microwave induced plasma-optical emission spectrometry (MIP-OES). The system allows the continuous solubilization of samples at an optimized temperature of 120 °C and pres
J. Braz. Chem. Soc.. Publicado em: 2016-03
-
11. Study of aluminum nitride precipitation in Fe- 3%Si steel
For good performance of electrical steels it is necessary a high magnetic induction and a low power loss when submitted to cyclic magnetization. A fine dispersion of precipitates is a key requirement in the manufacturing process of Fe- 3%Si grain oriented electrical steel. In the production of high permeability grain oriented steel precipitate particles of c
Mat. Res.. Publicado em: 11/06/2013
-
12. Avaliação de métodos de preparo de amostra para a determinação de halogênios em alumina de alta pureza / Evaluation of sample preparation methods for halogens determination in high-purity alumina
The presence of trace elements in high purity alumina (e.g. halogens) can compromise the final product characteristics. In this work, different sample preparation methods based on alkaline fusion, halogen extraction in water with and without microwave heating, alkaline extraction, microwave-induced combustion and pyrohydrolysis for further halogens determina
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 08/04/2011