Piezoelectric Sensors And Actuators
Mostrando 1-12 de 17 artigos, teses e dissertações.
-
1. Consideration of Spillover Effect in Active Vibration Suppression of a Smart Composite Plate Using Piezoelectric Elements
Abstract In this paper, the problem of vibration suppression of a smart composite plate with bonded piezoelectric patches is considered. A higher order plate model is used for finite element modeling of the plate and the PID controller is used to generate control voltage command to the piezo actuators from the piezo sensors data. Derived formulation and the
Lat. Am. j. solids struct.. Publicado em: 2016
-
2. Control of a Support Excitation Smart Beam Subjected to a Follower Force with Piezoelectric Sensors/Actuators
Abstract In this paper, an active control is used to suppress the flutter vibration of a support excitation beam subjected to a follower force, using piezoelectric sensors/actuators. The beam is fixed to a motion support from one end and the other end is subjected to a follower force. The governing equations of motion are derived based on the generalized fun
Lat. Am. j. solids struct.. Publicado em: 2015-12
-
3. Vibration suppression of a rotating flexible cantilever pipe conveying fluid using piezoelectric layers
AbstractIn this study, the governing equations of a rotating cantilever pipe conveying fluid are derived and the longitudinal and lateral induced vibrations are controlled. The pipe considered as an Euler Bernoulli beam with tip mass which piezoelectric layers attached both side of it as sensors and actuators. The follower force due to the fluid discharge ca
Lat. Am. j. solids struct.. Publicado em: 2015-06
-
4. Vibration attenuation and shape control of surface mounted, embedded smart beam
Active Vibration Control (AVC) using smart structure is used to reduce the vibration of a system by automatic modification of the system structural response. AVC is widely used, because of its wide and broad frequency response range, low additional mass, high adaptability and good efficiency. A lot of research has been done on Finite Element (FE) models for
Lat. Am. j. solids struct.. Publicado em: 2012-06
-
5. Metodologia para a alocação ótima discreta de sensores e atuadores piezoelétricos na simulação do controle de vibrações em estruturas de materiais compósitos laminados
O principal objetivo do controle de vibrações é a sua redução ou minimização, através da modificação automática da resposta estrutural. Em muitas situações isto é necessário para promover a estabilidade estrutural, e para alcançar o alto desempenho mecânico necessário em diversas áreas técnicas, tais como a engenharia aeroespacial, civil
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2012
-
6. Técnicas para monitoramento de integridade estrutural usando sensores e atuadores piezoelétricos / Techniques for structural health monitoring using piezoelectric sensors and actuators
A utilização de materiais piezoelétricos, na função de sensores e atuadores distribuídos, para o controle e monitoramento de vibrações estruturais tem um enorme potencial de aplicação nas indústrias aeronáutica, aeroespacial, automobilística e eletroeletrônica. O uso de sensores piezoelétricos integrados para monitoramento de integridade estru
Publicado em: 2011
-
7. Finite element analysis of actively controlled smart plate with patched actuators and sensors
The active vibration control of smart plate equipped with patched piezoelectric sensors and actuators is presented in this study. An equivalent single layer third order shear deformation theory is employed to model the kinematics of the plate and to obtain the shear strains. The governing equations of motion are derived using extended Hamilton's principle. L
Latin American Journal of Solids and Structures. Publicado em: 2010-09
-
8. Otimização topológica de transdutores piezelétricos com gadação funcional de material: projeto, simulação, análise e fabricação. / Topology optimization of piezoelectric transducers considering functionally graded material: design, simulation, analysis and fabrication.
Piezoelectric materials generate displacements when they are excited by electrical potential and electrical potential when they are excited by force or pressure. These materials are widely applied in Precision Mechanics, Mechatronics, and Ultrasonic imaging areas. On the other hand, Functionally Graded Materials (FGM) are advanced materials, whose properties
Publicado em: 2010
-
9. Simultaneous control and piezoelectric insert optimization for manipulators with flexible link
This work proposes a tracking control model for a flexible link robotic manipulator using simultaneously motor torques and piezoelectric actuators. The dynamic model of manipulator is obtained in a closed form through the Lagrangian approach. The control uses the motor torques for the tracking control of the joints and also to reduce the low frequency vibrat
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2009-06
-
10. Structural damage detection using time series analysis and piezoelectries actuators and sensors / Detecção de danos estruturais usando analise de series temporais e atuadores e sensores piezeletricos
This work proposes a novel approach to detect and locate incipient damage in structures by using only acceleration responses and coupled piezoelectric actuators and sensors. Though the major focus in smart damage detection is given by on the monitoring of the electrical impedance in the frequency domain, the current contribution applies a novel technique bas
Publicado em: 2008
-
11. Controle de manipuladores robóticos flexíveis usando atuadores e sensores piezelétricos otimizados / Control of flexible robotic manipulators using optimized piezo-electric actuators and sensors
Neste trabalho, apresenta-se um modelo de controle de trajetória para um manipulador constituído de um segmento rígido e um flexível com atuadores e sensores piezelétricos. o modelo dinâmico do manipulador é obtido de forma fechada através da formulação de Lagrange, considerando os segmentos como vigas de Euler-Bernoulli não-prismáticas. O contro
Publicado em: 2008
-
12. Modelagem por elementos finitos de placas compostas dotadas de sensores e atuadores piezoelÃtricos : implementaÃÃo computacional e avaliaÃÃo numÃrica / Finite element modeling of composite plates incorporating piezoelectric sensors and actuators: implementation and numerical assessment
This Dissertation presents a methodology based on the Finite Element method for the modeling of laminated composite beams and plates containing piezoelectric sensors and actuators. The fundamental concepts and the theoretical developments are presented, followed by a number of numerical simulations performed in MATLABÂ environment. The finite element used i
Publicado em: 2006