Photocatalytic Activity
Mostrando 25-36 de 80 artigos, teses e dissertações.
-
25. PREPARATION AND VISIBLE LIGHT RESPONSIVE PHOTOCATALYTIC ACTIVITY OF Fe3O4/Ni-Al-Ce LDH/Bi2WO6 COMPOSITES
Novel Fe3O4/Ni-Al-Ce LDH/Bi2WO6 composites were prepared through a hydrothermal method and co-precipitation method. The morphologies and structures of the photocatalysts were characterized by XRD, Raman, TEM, UV-vis-DRS, BET surface area and VSM techniques. The photocatalytic performances of the photocatalysts were investigated by the decolorization of methy
Quím. Nova. Publicado em: 2017-09
-
26. Synthesis, Characterization, and Photocatalytic Activity of Pure and N-, B-, or Ag- Doped TiO2
This article reports the synthesis and characterization of pure and N-, B-, and Ag-doped TiO2 and the ability of these oxides to photodegrade methylene blue (MB) under sunlight or UV-ABC radiation. The compounds were synthesized using the sol-gel method and characterized by scanning electron microscopy, X-ray diffraction, diffuse reflectance spectroscopy, Fo
J. Braz. Chem. Soc.. Publicado em: 2017-09
-
27. Photocatalytic Performance of Titanates with Formula MTiO3 (M= Fe, Ni, and Co) Synthesized by Solvo-Combustion Method
This work reports the synthesis of a variety of materials with an ilmenite-type structure MTiO3 formula, where M= Fe, Co, and Ni, these materials were synthesized by the method of solvo-combustion, a simple and rapid method. These materials were characterized by X-ray Diffraction (XRD), scanning electron microscopy (SEM), FT-IR spectroscopy, thermogravimetri
Mat. Res.. Publicado em: 24/07/2017
-
28. Evaluation of the Photocatalytic Potential of TiO2 and ZnO Obtained by Different Wet Chemical Methods
This paper describes the development of TiO2 and ZnO particles by a chemical route, using two different wet synthesis methods: polymeric precursor (PP) and sol-gel (SG). This study aimed to shed a light on how the synthesis method affects the photocatalytic activity of these oxides. Rhodamine B (RhB) degradation was used as a probe reaction to test the as-sy
Mat. Res.. Publicado em: 26/06/2017
-
29. In Situ Photoactivated Plasmonic Ag3PO4@silver as a Stable Catalyst With Enhanced Photocatalytic Activity Under Visible Light
Silver orthophosphate (Ag3PO4) had been reported as an excellent candidate to split water or decompose pollutants with high efficiency in visible light region, yet is not stable due to the reduction of silver ion. In this work, an easy-fabricated method (in situ photoinduced reduction) was provided to enhance the stability of Ag3PO4 for its possible applicat
Mat. Res.. Publicado em: 03/04/2017
-
30. Photocatalytic Activity and RNO Dye Degradation of Nitrogen-doped TiO2 Prepared by Ionothermal Synthesis
This work concerns the preparation a nitrogen-doped TiO2 by ionothermal synthesis methods and the photocatalytic studies. In this procedure, alkoxide was used as a titanium source, and a deep eutectic mixture of choline chloride and urea (molar ratio 1:2) served as a solvent and source of nitrogen. Different samples were synthesized varying the percentages o
Mat. Res.. Publicado em: 20/03/2017
-
31. Synthesis of Surface Oxygen-deficient BiPO4 Nanocubes with Enhanced Visible Light Induced Photocatalytic Activity
The visible light driven BiPO4 nanocubes with sufficient surface oxygen deficiency were fabricated by a hydrothermal process and subsequently ultrasonic assistant Fe reduction process. The products were characterized by XRD, DRS, XPS, SEM and TEM which showed that the BiPO4 had cuboid-like shape with a smooth surface and clear edges and the oxygen vacancies
Mat. Res.. Publicado em: 13/03/2017
-
32. Effect of Cupric Salts (Cu (NO3)2, CuSO4, Cu(CH3COO)2) on Cu2(OH)PO4 Morphology for Photocatalytic Degradation of 2,4-dichlorophenol under Near-infrared light irradiation
Cu2(OH)PO4 microstructures were synthesized by the hydrothermal method using three different types cupric salts (Cu (NO3)2, CuSO4, Cu(CH3COO)2) as raw materials. The X-ray diffraction (XRD), scanning electron microscopy (SEM) and UV-visible-NIR absorption spectra were used to characterize the as-obtained products. The different anions (SO42-, CH3COO-, NO3-)
Mat. Res.. Publicado em: 26/01/2017
-
33. TITANATE NANOTUBES PRODUCED FROM MICROWAVE-ASSISTED HYDROTHERMAL SYNTHESIS: CHARACTERIZATION, ADSORPTION AND PHOTOCATALYTIC ACTIVITY
Abstract A microwave-assisted hydrothermal (MAH) method was employed to synthesize TiO2 nanotubes (TNTs) and these were compared to the conventional hydrothermal (CH) method. The nanotubes were characterized for their crystallinity, morphology, surface area and photocatalytic activity. The TiO2 P25 was used for comparison purposes and efficiently degraded bo
Braz. J. Chem. Eng.. Publicado em: 2017-01
-
34. CdMoO4 Micro-ellipsoids: Controllable Synthesis, Growth Mechanism, and Photocatalytic Activity
CdMoO4 micro-ellipsoids were synthesized by a simple hydrothermal route with the assistance of nonionic surfactant Triton X-100 and characterized by X-ray diffraction, scanning electron microscopy and UV-Vis diffuse reflectance spectroscopy. The effects of hydrothermal pH, temperature, and time on the morphology and photocatalytic activity of CdMoO4 were inv
Mat. Res.. Publicado em: 21/11/2016
-
35. Preparation and Performance of TiO2-ZnO/CNT Hetero-Nanostructures Applied to Photodegradation of Organic Dye
Water pollution by organic compounds is one of the major challenges faced by industries that use dyeing processes. Thus, some methods were developed for degrading dyes in wastewaters, including heterogeneous photocatalysis by semiconductor oxides. However, these oxides have limited photocatalytic activity due to the fast recombination of photogenerated elect
Mat. Res.. Publicado em: 03/10/2016
-
36. Cr/S/TiO2-LOADED HOLLOW GLASS MICROSPHERES AS AN EFFICIENT AND RECYCLABLE CATALYST FOR THE PHOTOCATALYTIC DEGRADATION OF INDIGO CARMINE UNDER VISIBLE LIGHT
Chromium and sulfur co-doped nanometer TiO2 hollow glass microspheres (Cr/S/TiO2-HGM) were synthesized by a sol-gel method. Characterization used X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), N2 adsorption-desorption (Brunauer-Emmett-Teller (BET) measurements) and UV-Vis diffuse reflectance spectrosc
Quím. Nova. Publicado em: 2016-09