Kinematic Tests
Mostrando 1-12 de 21 artigos, teses e dissertações.
-
1. REAL TIME PPP APPLIED TO AIRPLANE FLIGTHT TESTS
Abstract The availability in real time of GNSS satellites orbits, clock corrections and code and phase biases provided the possibility of application of Real Time Precise Point Positioning (RTPPP). This paper presents the methodology concerning RTPPP and application to kinematic trajectories of airplane flight tests, but without using the carrier phase bias.
Bol. Ciênc. Geod.. Publicado em: 10/07/2019
-
2. Parameters Determination of Yoshida Uemori Model Through Optimization Process of Cyclic Tension-Compression Test and V-Bending Springback
Abstract In recent years, the studies on the enhancement of the prediction capability of the sheet metal forming simulations have increased remarkably. Among the used models in the finite element simulations, the yield criteria and hardening models have a great importance for the prediction of the formability and springback. The required model parameters are
Lat. Am. j. solids struct.. Publicado em: 2016-10
-
3. The effect of various kinematics on postoperative pain after instrumentation: a prospective, randomized clinical study
ABSTRACT Objective: To evaluate various kinematic movements on postoperative pain using a Reciproc system. Material and Methods: Fifty-six molar teeth were divided into four groups according to kinematics as follows: continuous rotation, 360° CCW – 30° CW, 270° CCW – 30° CW, and 150° CCW – 30° CW. Preoperative and postoperative pain levels usin
J. Appl. Oral Sci.. Publicado em: 2016-10
-
4. Experimentally Validated Combustion and Piston Fatigue Life Evaluation Procedures for the Bi-Fuel Engines, Using an Integral-Type Fatigue Criterion
Abstract A relatively complete procedure for high cycle fatigue life assessment of the engine components is outlined in the present paper. The piston is examined as a typical component of the engine. In this regard, combustion process and transient heat transfer simulations, determination of the instantaneous variations of the pressure and temperature in the
Lat. Am. j. solids struct.. Publicado em: 2016-06
-
5. Comparison between Neutron Diffraction measurements and numerical simulation of residual stresses of a Wire-Drawing process
In this work, a drawing processed was simulated to calculate forces and the resulting residual stresses in the material. The calculated residual stresses were compared with experimentally measured residual stresses by the Neutron Diffraction Method. The modeled process was the Wire Drawing. The necessary parameters to model the process were taken from an ind
Mat. Res.. Publicado em: 08/02/2013
-
6. Análise da cinemática dos compartimentos da parede torácica nas posições supino e sentada de pacientes com esclerose lateral amiotrófica
Amyotrophic Lateral Sclerosis (ALS) is characterized by deterioration of upper and lower motor neurons. The main components, which alter the respiratory muscles are the inspiratory, expiratory, and bulbar, leading to chronic respiratory failure. One way to improve gas exchange of these individuals is by employing non-invasive ventilation (NIV). Therefore, th
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 16/12/2011
-
7. Comparação de modelos hidrodinâmicos simplificados de propagação de vazão em rios e canais
This work has identified, tested and improved simplified flood routing models to verify the advantages and disadvantages presented. The solutions provided by these models were tested by using a full hydrodynamic model considered in this work as an ideal result. The simplified hydrodynamic models used were: A variable parameter kinematics wave model, the Musk
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2011
-
8. Desempenho de pacientes com acidente vascular encefalico em testes de reconhecimento de tividades de vida diaria com frequencia autocontrolada e pre- determinada Luciana Protásio de Melo Natal 2009
The stimulation of motor learning is an important component to a rehabilitation and type of practice used is de basic importance to Physiotherapy. The motor skills are the types more basic of behavior that subjects must acquire throughout its lives and observational learning one of forms for its acquisition. Objective: This study aimed to compare performance
Publicado em: 2009
-
9. Algoritmos de navegação em tempo real para um sistema GPS de posicionamento relativo de precisão / Real time navigation algorithms for a percise GPS relative positioning system
The GPS signal is subject to several error sources in the measurements. The combined effects of these errors in the propagation signal cause a degradation in precision of positioning. However, using carrier phase measurements, it is possible to reduce positioning error up to 100 times, if compared with positioning using code measurernents. However, this type
Publicado em: 2009
-
10. Geração de trajetórias para veículos aéreos autônomos não-tripulados
In this work a study on the problem of the trajectory generation for unmanned aerial vehicles is carried through. The main objective is to provide tools of path planning for aerial robots, taking into account some of its main physical constraints of movement. For this, some of the more used techniques for motion planning of grounded robots are argued initial
Publicado em: 2008
-
11. Simulation software development for multibody systems / Desenvolvimento de uma ferramenta computacional para simulação de sistemas mecânicos multicorpos
The mathematical simulation is a very important tool to reduce production costs in new projects of agricultural machines. This work consists of a simulation software development for multibody systems (MBS), called FSSM (tool for simulation of mechanical systems), with appropriate functionalities for manufacturers of agricultural machines, using the AutoCAD g
Publicado em: 2008
-
12. ANÁLISE TENSÃO DEFORMAÇÃO E POR EQUILÍBRIO LIMITE DO MECANISMO DE TOMBAMENTO FLEXURAL
The search for maximizing mineral exploitation, associated to the safety measures needed in order to make this activity viable, force us to seek new forms of analysis to achieve these guidelines in an optimum way. The purpose of this work is to contribute to a better explanation of the breakdown of phyllite slopes by flexural toppling in the region of the Qu
Publicado em: 2008