Iron Absorption
Mostrando 1-12 de 367 artigos, teses e dissertações.
-
1. Influence of the Local Structure on the Photocatalytic Properties of Zinc Spinel Ferrite Nanoparticles
The correlation between iron distribution in octahedral or tetrahedral sites in synthetic magnetite and zinc spinel ferrites and their catalytic properties were investigated in this work. The zinc-doped nanomagnetites were prepared by co-precipitation method and annealed at 420 °C. X-ray diffraction, UV-Vis, X-ray absorption and 57Fe Mössbauer spectroscopi
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
2. Simple Spectrophotometric Determination of Iron in Diesel Oil after Sample Preparation Employing Extraction Induced by Emulsion Breaking
This work reports the development of a simple and fast method for the spectrophotometric determination of Fe in diesel oil using the classic reaction with 1,10-phenanthroline after its extraction induced by emulsion breaking (EIEB). The extraction parameters of EIEB were optimized (concentration of HNO3 and Triton X-100® in the emulsifying solution) as well
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
3. An alternative route to extract nickel and cobalt from non-commercial laterite ore
Abstract Laterite ores, which represent around two-thirds of nickel reserves, became an important source of nickel and cobalt metals. The objective of the present study was to investigate the efficiency of a hybrid route to extract nickel and cobalt present in a laterite ore sample which was not commercially attractive to be processed through the current rou
REM - International Engineering Journal. Publicado em: 2022
-
4. Thallium Associated with Manganese Ore Tailings in a Deactivated Mine in the Western Region of Bahia, Brazil
Thallium (Tl) is a rare metal with toxic effects notably harmful to human health and the environment. In this article, the natural occurrence of Tl was evaluated in a deactivated manganese mine located in the western region of Bahia, Brazil. The extraction procedure with aqua regia was used to dissolve the soil, sediment, and tailings samples. The Tl content
J. Braz. Chem. Soc.. Publicado em: 2021-05
-
5. Influence of Mn2+ ions on depression of quartz and spessartine in gondite ore
Abstract Low-grade manganese ores that are composed of manganese oxides, wad, quartz, iron oxides, gibbsite, and especially of spessartine (Mn3Al2(SiO4)3) are known as gondite. Spessartine is a mineral with a high content of silica (SiO2) and alumina (Al2O3) that causes a decrease of the enrichment in manganese oxide concentrates by flotation, giving this o
REM, Int. Eng. J.. Publicado em: 2021-01
-
6. Maximization of the use of casting sand residue in the production of fired ceramic bricks
Abstract In this study, a red ceramic was developed with the addition of sand residue from deburring and finishing processing of cast iron molds, replacing a variable fraction of the clay. The formulated masses were shaped by pressing and firing at different temperatures (850, 900 and 1000 ºC) at a heating rate of 180 ºC/h and 2-hour level. The bodies were
REM, Int. Eng. J.. Publicado em: 2020-09
-
7. Promoters effectiveness in the improvement in iron and zinc absorption from the rice and bean
Abstract Iron and zinc are essential micronutrients for the organism functioning and their lack can result in prejudices to human health. The information about the presence of minerals in the diet are normally referred to its total concentrations, however these values do not reproduce the fraction that might be bioaccessible for the human body. The objective
Food Sci. Technol. Publicado em: 2020-06
-
8. Obtaining and characterization of anthocyanins from Euterpe oleracea (açaí) dry extract for nutraceutical and food preparations
Abstract The main constituents of the Euterpe oleracea Mart., Arecaceae, fruits (açaí) are anthocyanins. This paper aimed to standardize the extraction process and characterize an anthocyanin-rich dry extract obtained from this fruit. A 23 full factorial design was used. The volumes of ethanol 92% and acetic acid and the extraction time were used as factor
Rev. bras. farmacogn.. Publicado em: 09/12/2019
-
9. Análise do desempenho de adensamento da massa refratária de sílica usada em fornos de indução
Resumo As indústrias de fundição de ferro fundido usam em seu processo grande quantidade de sucata zincada, o que tem contribuído para a redução da campanha do revestimento refratário de fornos de indução a cadinho já que o vapor de zinco formado no aquecimento migra para o centro do refratário, condensando em regiões externas do forno, próximo
Cerâmica. Publicado em: 14/11/2019
-
10. Influência do tipo e teor de pigmento no estado endurecido de ladrilhos hidráulicos
Resumo A aplicação de ladrilhos hidráulicos voltou a ser valorizada nos últimos anos em função de sua beleza e versatilidade. O ganho de resistência sem necessidade de queima é uma considerável vantagem, mas o tempo e o custo de produção e a manutenção em estoque são algumas desvantagexns observadas. Como são materiais que permanecem expostos
Cerâmica. Publicado em: 14/11/2019
-
11. Reuse of iron ore tailings in the production of geopolymer mortars
Abstract A great variety of silica and alumina-rich materials have been investigated in the production of alkaline activated binders (or geopolymers) with low environment impact, e.g. low CO2 emissions. Geopolymer mortars and concretes may be more environmentally friendly if not only Portland cement but also natural aggregates (sand, gravel) are replaced wit
REM, Int. Eng. J.. Publicado em: 16/09/2019
-
12. Elemental Concentration and Sulfur Chemical Speciation in the Amazonian Plant Andira surinamensis Using Synchrotron Radiation Techniques (SR-XRF, XANES), RBS and WD-XRF
The inorganic composition of the bark and leaf of a plant from the Amazon rainforest, Andira surinamensis, was determined using two non-destructive, multi-element techniques: X-ray fluorescence (XRF) and Rutherford backscattering spectrometry (RBS). XRF measurements were made using both a conventional X-ray source and synchrotron radiation. It was observed t
J. Braz. Chem. Soc.. Publicado em: 16/09/2019