In Situ And Laboratory Tests
Mostrando 1-12 de 37 artigos, teses e dissertações.
-
1. Settlement of bored piles with expander body system in lateritic soils
Abstract The Expander Body pile (EB) is a combination of a cast-in-situ pile method with an inflated, pump-grouted tip. The EB system's pioneering conjunction with the conventional drilling pile technique has improved work load, foundation security, cost reductions and abrupt displacements in lateritic, porous, unsaturated soils. The aim of this article is t
REM, Int. Eng. J.. Publicado em: 2021-09
-
2. Geological - geotechnical characterization of different lithotypes in an underground mine
Abstract A mineralogical, geological and geotechnical characterization of several rock types (phyllite, dolomite, breccia and marl) from an underground mine site aimed, among other things, to identify its mineral composition and to provide parameters to support the understanding of rock mass behavior. For this purpose, it was possible to perform laboratory a
REM, Int. Eng. J.. Publicado em: 2021-01
-
3. Detection of somatic TP53 mutations and 17p deletions in patients with chronic lymphocytic leukemia: a review of the current methods
ABSTRACT Chronic lymphocytic leukemia is the most common hematologic malignancy among adults in Western countries. Several studies show that somatic mutations in the TP53 gene are present in up to 50% of patients with relapsed or refractory chronic lymphocytic leukemia. This study aims to review and compare the methods used to detect somatic TP53 mutations a
Hematol., Transfus. Cell Ther.. Publicado em: 2020-09
-
4. Experimental Study of the Compressive Strength of Multi-Coat Renders
Mortar compressive strength is a standard requirement and should be tested on stand-ardized specimens with a 40 mm square cross section. However, these specimens with only one type of mortar (base-coat layer) do not represent the render traditionally ap-plied to façades since that must consist of at least two layers (base coat and top coat, with different f
Mat. Res.. Publicado em: 13/07/2017
-
5. Desenvolvimento de método para medida de permeabilidade superficial de revestimentos de argamassa. / Development of method for measuring the surface permeability of coating mortar.
The phenomenon of permeability refers to the ability with which a fluid is transported through a porous medium, driven by pressure gradient between the material and the external environment. Degradation agents are conducted to the interior of mortar and concrete driven through such a phenomenon. Therefore, it is the permeability as a key parameters for durab
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 25/05/2011
-
6. Caracterização ambiental da bacia do Alto Jacaré-Guaçu (experimentos laboratoriais e in situ): elaboração de sedimentos sintéticos para avaliação da toxicidade do cádmio / Environmental characterization of the Alto Jacaré-Guaçu River Basin (Laboratory and In situ experiments): Formulation of synthetic sediments for assessing the toxicity of cadmium
A bacia do Alto Jacaré-Guaçu foi avaliada quanto aos aspectos limnológicos e ecotoxicológicos em quatro campanhas de amostragem de água e sedimento em 14 pontos distribuídos na área. Testes de toxicidade com água, tanto em laboratório como in situ, apresentaram toxicidade crônica com efeitos na sobrevivência, crescimento e morfologia de brânquias
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 28/03/2011
-
7. Utilização de redes neurais artificiais para determinar o tempo de resposta de sensores de temperatura do tipo RTD / Time response of temperature sensors using neural networks
In a PWR nuclear power plant, the primary coolant temperature and feedwater temperature are measured using RTDs (Resistance Temperature Detectors). These RTDs typically feed the plants control and safety systems and must, therefore, be very accurate and have good dynamic performance. The response time of RTDs is characterized by a single parameter called the
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 16/09/2010
-
8. Estudo experimental da combustão molhada na recuperação de oleo pesado / Experimental study of the wet combustion on heavy oil recovery
One way to improve the performance of the oil recovery method, known as dry forward in situ combustion, is to inject water either simultaneously or intermittently with the air, named as wet forward in situ combustion. The specific heat of the dry air is considerably lower than that of water, such that water may render a better transport of the heat generated
Publicado em: 2010
-
9. Evaluation of the results of cervical screening cervical laboratories accredited by the Health System in accordance with the diagnosis of the Monitoring Unit of External Quality / Avaliação dos resultados dos exames citopatológicos do colo do útero dos laboratórios credenciados pelo Sistema Único de Saúde de acordo com o diagnóstico da Unidade de Monitoramento Externo da Qualidade
Introduction: The External Quality Monitoring (MEQ) was developed from recommendations of the National Cancer Institute, in order to evaluate the performance of cytopathology diagnostic of the cervix and provide subsidies for continuing education to professionals in laboratories that provide services to public health. Objectives: To evaluate the results of P
Publicado em: 2010
-
10. Análise de diferentes metodologias executivas de solo pregado a partir de arrancamento realizados em campo e laboratório / Analysis of different soil nailing executive methods from pullout tests performed in field and laboratory
Apesar do largo emprego da técnica de solo pregado em nosso país, pouquíssima pesquisa foi realizada sobre a resistência ao cisalhamento de interface solo-reforço (qs) e sobre a importância deste parâmetro no desempenho desta técnica de reforço in situ de taludes e escavações. Busca-se com esta tese, avaliar experimentalmente, a influência de dif
Publicado em: 2009
-
11. Geotechnical site characterization and study of an erosion process caused by urban setting / Investigação geotécnica e estudo de um processo erosivo causado por ocupação urbana
This dissertation presents geotechnical site characterization results of an erosion process area, in Bauru city, inland of São Paulo State, Brazil. The objective is to characterize the local soil and define the major causing factors for the erosion process evolution, which initiated with deforestation, soil sealing and discharge of pluvial and sewer water.
Publicado em: 2009
-
12. PHYSICAL SIMULATION OF WELLBORE MECHANICAL BEHAVIOR / SIMULAÇÃO FÍSICA DO COMPORTAMENTO MECÂNICO DE POÇOS DE PETRÓLEO
A major problem during hydrocarbon production from poorly consolidated sandstone in the influx of sand, or sand production. This problem is complex and can occur as a result of a large variety of reasons, like magnitude of the in situ stresses, formation strength, and wellbore-development operations. If the potential for sand production could be predicted, t
Publicado em: 2009