High Sensitivity Spectroscopy
Mostrando 1-12 de 63 artigos, teses e dissertações.
-
1. Determination of Catechol and Hydroquinone by Using Perilla frutescens Activated Carbon Modified Glassy Carbon Electrode
High specific surface area activated carbon prepared by Perilla frutescens (PFHSAAC) was modified on the surface of the glassy carbon electrode (GCE) by drop-coating method to construct a PFHSAAC/GCE. The electrochemical properties of the modified electrode were investigated in detail by some electrochemical methods such as cyclic voltammetry (CV), different
J. Braz. Chem. Soc.. Publicado em: 2020-01
-
2. Caracterização de termistores automotivos do tipo NTC
RESUMO Os termistores automotivos são eletrocerâmicas com características sensoras alojadas em estojos metálicos fixadas no radiador, que têm como função controlar a temperatura da água de resfriamento do motor. O objetivo deste trabalho foi caracterizar dois termistores comerciais aplicados em veículos automotores. Os termistores caracterizados for
Matéria (Rio J.). Publicado em: 25/11/2019
-
3. The influence of Cu content on high temperature corrosion behavior of heat - resistant molten salt steel
ABSTRACT This work studies the high temperature corrosion behavior of new heat-resistant steel with salt coating method of 75%Na2SO4+25%NaCl coating on the steel surface at 700ºC. The chemical composition of corrosion products and surface morphology of the corrosion layer were analyzed using X-ray diffractometer (XRD), scanning electron microscopy (SEM), en
Matéria (Rio J.). Publicado em: 16/09/2019
-
4. Synthesis of Hydrotalcite-Supported CdTe Semiconductor Nanocrystals for Electrochemical Detection of Ciprofloxacin
In this work, CdTe quantum dots (QDs) were controllably grown onto the surface of layered double hydroxide (LDH) aiming to develop a sensitive and selective method for the electrochemical detection of ciprofloxacin (CPX). Emission and absorption spectroscopy results as well as high-resolution transmission electron microscopy (HRTEM) images evidenced the form
J. Braz. Chem. Soc.. Publicado em: 23/05/2019
-
5. Development and characterization of gas sensors using thin films of polyaniline as active layer
ABSTRACT This work aimed at the development and characterization of gas sensing devices using thin films of polyaniline (PAni) as active layer, deposited by in situ polymerization. The polyaniline, an intrinsically conductive polymer, was used due to its high sensitivity to gases, low response time and stability, ease of synthesis and low cost. The sensor wa
Matéria (Rio J.). Publicado em: 06/12/2018
-
6. Primary Hyperparathyroidism: The Influence of Bone Marrow Adipose Tissue on Bone Loss and of Osteocalcin on Insulin Resistance
OBJECTIVES: Bone marrow adipose tissue has been associated with low bone mineral density. However, no data exist regarding marrow adipose tissue in primary hyperparathyroidism, a disorder associated with bone loss in conditions of high bone turnover. The objective of the present study was to investigate the relationship between marrow adipose tissue, bone m
Clinics. Publicado em: 2016-08
-
7. Development of a Selective and Sensitive Sensor for Urate Determination Based on Tris(1,10-phenantroline)copper(II) Bis(tetracyanoquinodimethanide) Adsorbed on Carbon Nanotubes
The present work describes the development of a selective electrochemical sensor for urate based on tris(1,10-phenantroline)copper(II) bis(tetracyanoquinodimethanide) (Cu(phen)3(TCNQ)2) adsorbed on multi-walled carbon nanotubes (CNT). The composite material was characterized by infrared spectroscopy, scanning electron microscopy, and electrochemical impedanc
J. Braz. Chem. Soc.. Publicado em: 2015-10
-
8. The Inhibition of Sodium Oleate for Pitting Corrosion of Aluminum Alloy 2024 in 0.1 mol L-1 NaCl Solution
The inhibition mechanism of sodium oleate (C17H33COONa) for pitting corrosion of aluminum alloy (AA) 2024 in 0.1 mol L-1 NaCl solution was investigated using potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), scanning electron microscopy with energy dispersive spectrometer (SEM-EDS) and X-ray photo
J. Braz. Chem. Soc.. Publicado em: 2015-08
-
9. Biochemical imaging of normal, adenoma, and colorectal adenocarcinoma tissues by Fourier transform infrared spectroscopy (FTIR) and morphological correlation by histopathological analysis: preliminary results
Introduction The colorectal cancer is a major health problem worldwide. Histology is considered the gold standard for differential diagnosis. However, it depends on the observer's experience, which can lead to discrepancies and poor results. Spectroscopic imaging by Fourier transform infrared (FTIR) is a technique that may be able to improve the diagnosis,
Res. Biomed. Eng.. Publicado em: 2015-03
-
10. Evaluation of nuclear magnetic resonance spectroscopy variability
INTRODUCTION: The intrinsically high sensitivity of Magnetic Resonance Spectroscopy (MRS) causes considerable variability in metabolite quantification. In this study, we evaluated the variability of MRS in two research centers using the same model of magnetic resonance image scanner. METHODS: Two metabolic phantoms were created to simulate magnetic resonance
Rev. Bras. Eng. Bioméd.. Publicado em: 2014-09
-
11. Caracterización de nanoestructuras sub-superficiales utilizando espectroscopía de aniquilación de positrones
Positron annihilation spectroscopy (PAS) has proved to be a powerful tool for the study of defects in solids due to its high sensitivity to the presence of defects such as vacancies, vacancy agglomerates or voids. Furthermore, PAS allows to identify and characterize each of these defects. There are different experimental variations of PAS technique such as p
Matéria (Rio J.). Publicado em: 2013-12
-
12. Influência dos polieletrólitos na resposta eletroquímica de filmes automontados contendo nanotubos de carbono para aplicação em nanomedicina / Influence the polyelectrolytes on the electrochemical response of layer-by-layer films containing carbon nanotubes for applications in nanomedicine
Carbon Nanotubes (CNTs) are cylindrical carbon nanostructures exhibiting excellent electrical, thermal, optical and mechanical properties. The immobilization of CNTs in nanostructured thin films in conjunction with polymers using the Layer-by-Layer (LbL) technique provides a new alternative for development of nanocomposites to be used as sensors and biosenso
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 20/06/2011