Experimental Aerodynamics
Mostrando 1-12 de 15 artigos, teses e dissertações.
-
1. Visual Experimental and Numerical Investigations around the VLM-1 Microsatellite Launch Vehicle at Transonic Regime
ABSTRACT: It is performed and presented an experimental and numerical investigation over the flow patterns around the fore-body section of a microsatellite launch vehicle in development at Instituto de Aeronáutica e Espaço. The experimental investigation with a VLM-1 model in 1:50 scale is carried out at the Brazilian Pilot Transonic Wind Tunnel, located i
J. Aerosp. Technol. Manag.. Publicado em: 2017-06
-
2. Reanálise CFSR-NCEP aplicada ao modelo SiB2 na simulação de fluxos de CO2 sobre o cultivo de soja em Cruz Alta.
The present work aimed to evaluate the behavior of CO2 fluxes, run by the Simple Biosphere Model (SiB2), by adopting CFSR-NCEP data reanalyzed as an atmospheric boundary condition. A statistical analysis was used in order to validate the results obtained using a coefficient for the adjusted model based on the simulation parameters when compared to the data o
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2012
-
3. Otimização e dinâmica dos fluidos computacional aplicadas a turbinas eólicas
The present work consists in the application of optimization methods and computational fluid dynamics to wind turbines. The massive growth in renewable energies demands more powerful turbines and more accuracy in their design and analysis. This work has three objectives: optimization of an airfoil for wind turbines, simulation of a wind turbine airfoil in de
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2012
-
4. Simulação de grandes escalas para análise numérica da esteira aerodinâmica da turbina eólica NREL UAE Phase VI
The Unsteady Aerodynamics Experiment Phase VI, which has been carried out in 2000 by the US National Renewable Energy Laboratory (NREL) at the NASA Ames wind tunnel, has been numerically reproduced. The purpose of this work is to study the characteristics of the wind wake produced by the 10 meter two bladed wind turbine, operating at a constant rotational sp
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2012
-
5. Desenvolvimento analítico e numérico de perfis e cascatas Joukowski e NACA pela técnica de distribuição de vórtices / Analytical and numerical development of Joukowski and NACA profiles and cascades by the vortex distribution technique
O presente trabalho tem como objetivos principais a elaboração de uma metodologia de cálculo de perfis e de cascatas em escoamento potencial baseado na distribuição de vórtices na superfície, o desenvolvimento de um código computacional próprio e a convalidação dos resultados obtidos. A metodologia baseia-se nos trabalhos de Martensen (1959), de M
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 03/08/2011
-
6. Análise aerodinâmica de perfis de asa para aeronaves experimentais tipo jn-1
A importância na escolha do perfil de asa de uma aeronave é função de sua relevância no seu desempenho; influenciando desde os custos de deslocamento (consumo de combustível, nível de vôo, por exemplo), a condições de segurança do vôo (resposta em condições críticas) do avião. O objetivo deste trabalho foi analisar quatro perfis de asa a fim
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 25/02/2011
-
7. Experimental results of a Mach 10 conical-flow derived waverider to 14-X hypersonic aerospace vehicle
Abstract This paper presents a research in the development of the 14-X hypersonic airspace vehicle at Institute for Advanced Studies (IEAv) from Department of Science and Aerospace Technology (DCTA) of the Brazilian Air Force (FAB). The 14-X project objective is to develop a higher efficient satellite launch alternative, using a Supersonic Combustion Ramjet
J. Aerosp. Technol. Manag.. Publicado em: 2011-08
-
8. Avaliação numérica e experimental de um veículo de competição de milhagem. / Numerical and experimental evaluation of a supermileage competition vehicle.
Dentre as competições nas quais estudantes são desafiados a construir protótipos com finalidades específicas, está a de fazer um veículo que transporte uma pessoa e percorrera a maior distância com um litro de combustível. Um dos fatores que contribuem para o consumo é a resistência aerodinâmica, assim prever seus efeitos é essencial para um bom
Publicado em: 2011
-
9. Simulation of viscous flow around a circular cylinder near a moving ground
The objective of this paper is to study the vortex shedding from a circular cylinder near a moving ground; this is done using the Vortex Method. A moving ground has been widely used in the field of experimental vehicle aerodynamics, especially of high-performance racing cars, to properly consider the ground effect on the vehicles aerodynamic. In experimental
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2009-09
-
10. Estudo de diferentes tipos de solo em túnel de vento através de simulação numérica. / Study of different types of floor configuration in a tunnel using numeric simulation.
O trabalho aqui apresentado visa estudar diferentes tipos de piso localizados na seção de testes de um túnel de vento e verificar a influência que ocorre em ensaios de automóveis analisando o escoamento entre o veículo e o solo, assim como avaliar alterações no coeficiente de arrasto, utilizando simulações numéricas computacionais. O coeficiente d
Publicado em: 2009
-
11. Novo sensor de vazão de fluidos com foco em aplicações biomedicas / New fluid flow sensor aimed at biomedical applications
Spirometer is a device that evaluates pulmonary ventilation. This paper presents a preliminary study of a new electromechanical sensor, focused on the biomedical application of spirometry. The sensor is composed of a bluff body positioned inside a tube trough a hole, being a part of the body inside and another part outside of the tube, and an accelerometer p
Publicado em: 2009
-
12. A numerical investigation of the aerodynamics of a furnace with a movable block burner
In this work the air flow in a furnace was computationally investigated. The furnace, for which experimental test data are available, is composed of a movable block burner connected to a cylindrical combustion chamber by a conical quarl. The apertures between the movable and the fixed blocks of the burner determine the ratio of the tangential to the radial a
Brazilian Journal of Chemical Engineering. Publicado em: 2007-06