Electrical Measurements
Mostrando 13-24 de 425 artigos, teses e dissertações.
-
13. SPATIALIZATION OF ELECTRICAL CONDUCTIVITY AND PHYSICAL HYDRAULIC PARAMETERS OF SOILS UNDER DIFFERENT USES IN AN ALLUVIAL VALLEY
RESUMO A caracterização da estrutura de variabilidade espacial de propriedades hidráulicas e da salinidade do solo é de grande importância para um adequado manejo agrícola de vales aluviais e para proteção da vegetação ciliar. Dessa forma, o objetivo deste trabalho foi a verificação da precisão de medições indiretas da condutividade elétrica
Rev. Caatinga. Publicado em: 09/05/2019
-
14. COMPARATIVE STUDY OF TiO2 AND ZnO APPLICATION IN HYBRID SOLAR CELLS USING COPOLYMER P3OT/P3MT
Hybrid inorganic-organic solar cells are an attractive alternative energy source because of their low-cost production and ability to make use of a large amount of solar radiation available. This work aims to evaluate different solar cells composed of TiO2 and ZnO with P3OT/P3MT copolymer. Layers of semiconductor oxides were deposited on transparent fluorine-
Quím. Nova. Publicado em: 02/05/2019
-
15. Growth and photosynthetic parameters of saccharine sorghum plants subjected to salinity
ABSTRACT. Plants are often exposed to abiotic stresses such as salinity, which represents a barrier to the cultivation of agricultural species mainly in arid and semi-arid regions. This study evaluated the development of four saccharine sorghum genotypes for tolerance to different salinity levels under greenhouse conditions. The experimental design was a ran
Acta Sci., Agron.. Publicado em: 28/03/2019
-
16. Conceitos básicos de radiômetros de substituição elétrica para medidas da Irradiância Solar Total
Resumo A irradiância solar total (TSI) é definida como a energia emitida pelo Sol por unidade de área e recebida pela Terra. Durante muitos anos essa energia foi considerada constante, no entanto, hoje se sabe que há variações em diferentes escalas de tempo. A medição do valor absoluto da TSI precisar ser realizada em ambiente extraterrestre devido �
Rev. Bras. Ensino Fís.. Publicado em: 07/01/2019
-
17. Development and characterization of gas sensors using thin films of polyaniline as active layer
ABSTRACT This work aimed at the development and characterization of gas sensing devices using thin films of polyaniline (PAni) as active layer, deposited by in situ polymerization. The polyaniline, an intrinsically conductive polymer, was used due to its high sensitivity to gases, low response time and stability, ease of synthesis and low cost. The sensor wa
Matéria (Rio J.). Publicado em: 06/12/2018
-
18. Analysis of Production and Consumption of Electric Energy in the Green Office of UTFPR in Curitiba
ABSTRACT The increasing demand for electricity and the scarcity of resources, require renewable energy sources and efficient equipment that reduce the consumption of electricity. The Green Office (GO) of the Universidade Tecnológica Federal do Paraná (UTFPR) is a sustainable building that uses strategies to reduce impacts to the environment, one of them be
Braz. arch. biol. technol.. Publicado em: 29/11/2018
-
19. Mixed Electrical Conduction of Calcium Aluminates Synthesized by Polymeric Precursors
A study of the electrical transport properties of calcium aluminate (CA) with coexisting C3A and C12A7 phases was carried out. In this work, powders resulting from synthesis based on the polymer precursor method. The resulting product was characterized by means of XRD, Raman, and UV-visible analysis to obtain the optical BG and by EIS. From the XRD and Raman
Mat. Res.. Publicado em: 23/11/2018
-
20. Development of a Prototype for Measurement of Electrical Energy
ABSTRACT The present work presents the development of a system of measurement of electric energy consumption. This system shows the consumer the amount of energy consumed and its respective monetary value in real time. The prototype was used in a case study to validate its operation. Data were collected to discuss the results obtained. In order to verify if
Braz. arch. biol. technol.. Publicado em: 29/10/2018
-
21. Effect of the Morphology and Structure on the Microwave Absorbing Properties of Multiwalled Carbon Nanotube Filled Epoxy Resin Nanocomposites
The current research shows the effect of structural and morphological differences of multilayer carbon nanotubes (CNT) on radar absorbing materials (RAM) performance. Two CNT samples, from different manufacturers, had their morphological and structural aspects investigated by XRD, SEM and SEM-FEG analyses. CNT/epoxy resin based nanostructured composites were
Mat. Res.. Publicado em: 16/07/2018
-
22. Preliminary results of cervical impedance measurements
AbstractIntroduction: In this work, we report the development and initial tests of a measuring system that is used to measure the cervical electrical impedance with the purpose of assessing cervical ripening. The objective is to offer a system that provides real-time information about the cervical electrical impedance and, indirectly, of the cervical ripeni
Res. Biomed. Eng.. Publicado em: 17/05/2018
-
23. Kinetics of Vacancy Doping in SrTiO3 Studied by in situ Electrical Resistivity
The kinetics of annealing to transform stoichiometric SrTiO3 insulator into a vacancy-doped semiconductor-superconductor was revisited by in situ electrical resistivity measurements. SrTiO3 single crystals were grown by Floating Zone Method. Using a homemade apparatus several electrical resistivity as a function of time were measured at different temperature
Mat. Res.. Publicado em: 03/05/2018
-
24. Resistivity Reduction of Nanostructured Undoped Zinc Oxide thin Films for Ag/ZnO Bilayers Using APCVD and Sputtering Techniques
Nanostructured undoped zinc oxide (ZnO) thin films were deposited using atmospheric pressure chemical vapor deposition (APCVD) on glass substrates using zinc acetate dehydrate [C4H6O4Zn·2H2O, ZnAc] in less than 2 minutes for each sample. In order to reduce the resistivity of ZnO films, a very thin layer of Ag was deposited on top of the films via the sputte
Mat. Res.. Publicado em: 15/03/2018