Drying Beds
Mostrando 1-12 de 26 artigos, teses e dissertações.
-
1. Características físico-hídricas de substratos formulados com lodo de esgoto na produção de mudas de acácia-negra
Resumo Avaliou-se o efeito da retenção de água de substratos para plantas formulados a partir de diferentes proporções de lodo de esgoto (LETE) solarizado, na produção de mudas de acácia-negra (Acacia mearnsii). O experimento foi conduzido em casa de vegetação e no Laboratório de Física do Solo da Embrapa Clima Temperado. O LETE utilizado foi col
Ciênc. Florest.. Publicado em: 02/12/2019
-
2. Drying and extraction of astaxanthin from pink shrimp waste (Farfantepenaeus subtilis ): the applicability of spouted beds
Abstract In this study, the spouted bed drying technique was used to obtain powder from shrimp wastes, with high quality for subsequent extraction of astaxanthin using vegetable oil, as alternative to organic solvents. Shrimp waste paste was dried in three inlet air temperatures (70, 80 and 90 °C), and air velocity used in the experiments was 100% over min
Food Sci. Technol. Publicado em: 30/07/2018
-
3. Anaerobic sludge dewatering by modified drying beds. / Utilização de leitos de drenagem no desaguamento de lodos anaeróbios.
O método de desaguamento por leitos de drenagem foi desenvolvido por Cordeiro a partir do ano de 1993 (CORDEIRO, 2001) para o desaguamento de lodos de Estações de Tratamento de Água. A sua aplicação para lodos de lagoas de estabilização de esgotos foi feita por Fontana et al. (2007). Este trabalho teve por objetivo avaliar a utilização de leitos de
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/09/2011
-
4. Numerical study on hygroscopic material drying in packed bed
The paper addresses numerical simulation for the case of convective drying of hygroscopic material in a packed bed, analyzing agreement between the simulated and the corresponding experimental results. In the simulation model of unsteady simultaneous one-dimensional heat and mass transfer between gas phase and dried material, it is assumed that the gas-solid
Brazilian Journal of Chemical Engineering. Publicado em: 2011-06
-
5. Padrões diagenéticos em arenitos de sistemas de Sabk ha costeiros-eólicos: um estudo comparativo dos reservatórios Juruá da área de Urucu, Bacia de Solimões, AM
Coastal-eolian sabkha sandstones from different ages and basins show similar diagenetic patterns, which understanding is important for their evaluation as geochemical systems and as hydrocarbon reservoirs. The Carboniferous sandstones of the Juruá Formation (Solimões Basin) are one of the most important gas reservoirs of Brazil. The sandstones and interbed
Publicado em: 2010
-
6. Modeling and simulating the drying of grass seeds (Brachiaria brizantha) in fluidized beds: evaluation of heat transfer coefficients
This work is aimed at modeling the heat transfer mechanism in a fluidized bed of grass seeds (Brachiaria brizantha) for supporting further works on simulating the drying of these seeds in such a bed. The three-phase heat transfer model, developed by Vitor et al. (2004), is the one used for this proposal. This model is modified to uncouple one of the four adj
Brazilian Journal of Chemical Engineering. Publicado em: 2009-09
-
7. Fluidodinâmica de leitos fluidizados e vibrofluidizados operando com partículas planas
The use of fluidized beds as a unit operation for drying of particulate materials is common in industrial processes. However, most works published in the literature, focus the drying of uniform particles, in a narrow range of size distribution. The appealing characteristics of fluidization for drying led some authors to suggest its use for drying of particle
Publicado em: 2009
-
8. Contribuições ao estudo da fluidodinâmica e da secagem de pastas em leitos fluidizado e vibrofluidizado
The aim of this study was to analyze the fluid dynamic of the fluidized and vibrofluidized beds with particles with diameter under 1.00 mm, and also to analyze the fluid dynamic behavior of wet beds and the drying of different liquids and suspensions during the transient drying period. The purpose of these tests is to obtain relevant information about the in
Publicado em: 2009
-
9. Estudo das micropropriedades de resíduos sólidos gerados nos decantadores de estações de tratamento de água
The conventional or life-cycle system for water treatment (chemical coagulation, flocculation, sedimentation, filtration, disinfection, fluoridation and pH correction) employed in most water treatment plants (WTP) in Brazil turns water unfit for human consumption (spring water and surface water) into a product that is in accordance with the drinking water gu
Publicado em: 2009
-
10. Análise da adição de resíduo oriundo do tratamento de esgotos em massa cerâmica utilizada para fabricação de telhas
Sludge of Wastewater Treatment Plants (WTPs) disposal is a problem for any municipality, for this reason the amount of sludge production is now a key issue in selecting treatment methods. It is necessary to investigate new applications for this waste type, due to the restrictions imposed by the environmental organs. The raw materials used in the Red Ceramic,
Publicado em: 2009
-
11. Anaerobic sewage sludge treatment by liming / HIGIENIZAÇÃO DE LODO ANAERÓBIO DE ESGOTO POR MEIO ALCALINO ESTUDO DE CASO DA ETE LAGES APARECIDA DE GOIÂNIA - GO
The aim of the present study was to evaluate the efficiency of the alkaline treatment of sanitary sewage sludge produced in the upflow anaerobic sludge blanket (UASB) of the Lages Sewage Treatment Plant, located in Aparecida de Goiânia, GO, Brazil and operated by Saneamento de Goiás, S.A. Saneago. The sludge, which was dewatered into drying beds until a me
Publicado em: 2009
-
12. Experimental and numerical study of spouted bed fluif dynamics
Spouted beds, originally invented in Canada by Mathur and Gishler (1955) as an alternative to fluidized beds for handling coarse particles, are now widely studied in a variety of physical operations, such as drying, coating and granulation. In this work the particle velocity, minimum spouting flow rate and characteristic fluid-dynamic curves of the spouted b
Brazilian Journal of Chemical Engineering. Publicado em: 2008-03