Dosimeters
Mostrando 1-12 de 51 artigos, teses e dissertações.
-
1. Analysis of Noise Transmitted to Workers in Motor-Manual Forest Harvesting in Minas Gerais State
ABSTRACT Noise can entail irreversible damage to the health of workers exposed to this factor. Thus, this work aimed to evaluate noise levels emitted by chainsaws during forest cutting activity. Noise measurements were performed with dosimeters on the workstation and compared to NR15. The noise dose average of all activities in the operation studied exceeded
Floresta Ambient.. Publicado em: 26/09/2019
-
2. RADIATION EXPOSURE DURING SPINE SURGERY USING C-ARM FLUOROSCOPY
RESUMO Objetivo: Avaliar a dose de radiação recebida pela equipe cirúrgica em cirurgias de coluna, incluindo entre aqueles que não são considerados trabalhadores com exposição ocupacional. Método: Todas as cirurgias de coluna realizadas num mesmo departamento num período de 12 meses foram avaliadas quanto à exposição dos cirurgiões, enfermeiro
Acta ortop. bras.. Publicado em: 2019-02
-
3. Absorbed doses in salivary and thyroid glands from panoramic radiography and cone beam computed tomography
Abstract Introduction: Panoramic radiography and cone beam computed tomography (CBCT) are very important in the diagnosis of oral diseases, however patients are exposed to the risk of ionizing radiation. This paper describes our study aimed at comparing absorbed doses in the salivary glands and thyroid due to panoramic radiography and CBCT and estimating ra
Res. Biomed. Eng.. Publicado em: 15/02/2018
-
4. Evaluation of radiation protection conditions in intraoral radiology
Abstract Introduction: The dental radiology represents about 20% of human exposure to radiation in radio diagnostic. Although the doses practiced in intraoral dentistry are considered low, they should not be ignored due to the volume of the performed procedures. This study presents the radiation protection conditions for intraoral radiology in Curitiba - PR
Res. Biomed. Eng.. Publicado em: 17/05/2016
-
5. Skin Doses on the Lens for Temporomandibular Joint Exam in Cone Beam Computed Tomography
ABSTRACT The aim of this study was to evaluate the kerma at the surface of the lens in TMJ CBCT and to derive the equivalent dose. An anthropomorphic phantom of the head and neck manufactured by Radiation Support Devices (model RS-230) was used. The dosimetric measurements were obtained by using fourteen thermoluminescent dosimetry (TLD) dosimeters (LiF: Mg,
Braz. arch. biol. technol.. Publicado em: 2015-12
-
6. Are the urology operating room personnel aware about the ionizing radiation?
ABSTRACT Purpose: We assessed and evaluated attitudes and knowledge regarding ionizing radiation of urology surgery room staff. Materials and Methods: A questionnaire was sent by e-mail to urology surgery room personnel in Turkey, between June and August 2013. The questionnaire included demographic questions and questions regarding radiation exposure and p
Int. braz j urol.. Publicado em: 2015-10
-
7. Accuracy of dose planning for prostate radiotherapy in the presence of metallic implants evaluated by electron spin resonance dosimetry
Radiotherapy is one of the main approaches to cure prostate cancer, and its success depends on the accuracy of dose planning. A complicating factor is the presence of a metallic prosthesis in the femur and pelvis, which is becoming more common in elderly populations. The goal of this work was to perform dose measurements to check the accuracy of radiotherapy
Braz J Med Biol Res. Publicado em: 26/05/2015
-
8. Análise dos procedimentos e critérios de implantação de feixes de raios X de referência ISO 4037 em baixas energias
According to the radiological protection principles, practices involving ionizing radiation must be planned and carried out under the guarantee that the values of individual doses, the number of people exposed to radiation and the probability of accidental exposures are as low as reasonably achievable. Therefore, radiation dosimetry is required to be done wi
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 09/08/2012
-
9. Estudo e desenvolvimento de dosímetros opticamente estimulados para aplicações em radioterapia / Study and development of Optically Stimulated Luminescent dosimeters for Radiotherapy applications.
Dosímetros Luminescentes Opticamente Estimulados (OSL) vêm sendo testados como alternativa dosimétrica no controle da qualidade e verificação de tratamentos por possuir características adequadas para esse fim, como elevada sensibilidade à radiação ionizante, alta resolução espacial e facilidade de leitura. Neste trabalho, o óxido de alumínio, do
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 24/02/2012
-
10. Estudo e desenvolvimento de dosímetros opticamente estimulados para aplicações em radioterapia / Study and development of Optically Stimulated Luminescent dosimeters for Radiotherapy applications.
Dosímetros Luminescentes Opticamente Estimulados (OSL) vêm sendo testados como alternativa dosimétrica no controle da qualidade e verificação de tratamentos por possuir características adequadas para esse fim, como elevada sensibilidade à radiação ionizante, alta resolução espacial e facilidade de leitura. Neste trabalho, o óxido de alumínio, do
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 24/02/2012
-
11. PRODUÇÃO E CARACTERIZAÇÃO DE DOSÍMETROS À BASE DE MAGNÉSIO. / PRODUCTION AND CHARACTERIZATION OF MAGNESIUM BASED DOSIMETERS
Com o intuito de se obter dosímetros de estado sólido que apresentem características tais como: alta sensibilidade, facilidade de obtenção e manuseio, praticidade e economicidade foram estudados no presente trabalho fósforos à base do íon magnésio. Os materiais escolhidos para análise foram o MgSO4 (sulfato de magnésio) e o MgB4O7 (tetraborato de
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 13/02/2012
-
12. Manufacturing polycrystalline pellets of natural quartz for applications in thermoluminescence dosimetry
This paper describes the manufacturing process of quartz-pellets and shows their potential use as thermoluminescence dosimeters (TLD) for those applications where low-levels of ionising radiation are present. Two batches of cold-pressed pellets were produced and their resistance were evaluated by vibration tests and weight-loss measurements. The batch manufa
Materials Research. Publicado em: 10/07/2012